scholarly journals Green Synthesis of Ceria Nanoparticles Using Azadirachta Indica Plant Extract: Characterization, Gas Sensing and Antibacterial Studies

2021 ◽  
Vol 18 (3) ◽  
pp. 285-297
Author(s):  
Satish Arvind Ahire ◽  
Ashwini Ashok Bachhav ◽  
Thansingh Bhavsing Pawar ◽  
Arun Vitthal Patil ◽  
Swapnil Sampatrao Shendge ◽  
...  
Keyword(s):  
Cerium Dioxide ◽  
Gas Sensing ◽  
Structural Characteristics ◽  
Mass Difference ◽  
Sem Analysis ◽  
Precipitation Method ◽  
Film Sensor ◽  
Antibacterial Study ◽  
Cubic Lattice ◽  
Gas Response

In the present investigation we have fabricated the cerium dioxide (CeO2) nanoparticles by green route. While preparing the cerium dioxide nanoparticles by co-precipitation method, Neem leaf extract mixed into the precursor of cerium. The synthesized nanoparticles of CeO2 were used for the preparation of thick film sensor by using screen printing strategy. The fabricated CeO2 sensor was characterized by XRD, SEM, EDS and TEM techniques. The structural characteristics investigated by x-ray diffraction technique (XRD). XRD confirms the formation of cubic lattice of CeO2 material. The surface, texture, porosity characteristics were investigated from SEM analysis, while chemical composition of the material was analysed by EDS technique. The transmission electron microscopy (TEM) confirms the formation cubic lattice of the cerium dioxide material. The thickness of the films was calculated from mass difference method, the prepared film sensors belong to thick region. The fabricated material CeO2 sensor was applied as gas sensor to sense the gases such as LPG, petrol vapors (PV), toluene vapors (TV) and CO2. The CeO2 sensor showed excellent gas response for LPG and PV, nearly 93.20 % and 78.23 % gas response. The rapid response and recovery of the prepared sensors was observed at the tested gases. CeO2 material also employed for antibacterial study at several pathogenic organism such as pseudomonas, staphylococcus aureus and salmonella typhae. From antibacterial study it was observed that the material is capable of inhibiting the growth of these pathogenic microbes.

scholarly journals Recent advances in Performance and effect of Zr doping with ZnO thin film sensor in Ammonia Vapour Sensing

2021 ◽  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Gas Sensing ◽  
Wide Band ◽  
Fast Response ◽  
Sem Analysis ◽  
Zno Thin Film ◽  
Film Sensor ◽  
Doped Zno ◽  
Silar Technique

<p>Pure and Zr doped ZnO thin films were prepared using SILAR technique. The influence of Zr doping on structural, morphological, optical and gas sensing properties of ZnO has been reported. X-ray diffraction study confirmed the formation of wurtzite structure of ZnO thin film (JCPDS 36-1451) fabricated by SILAR technique and the caluculated crystallites size of pure and doped ZnO were 39 and 36 nm respectively . SEM analysis of thin films has shown a completely different surface morphology. EDAX spetrum cnfirmed the presence of different compositional element in the fabriated thin films. Zr (3 wt%) doped ZnO thin film exhibited the best properties with a good transmittance and it has wide band gap of 3.26 eV. Photoluminescence emissions indicated increase in concentration of oxygen vacancies with introduction of dopant. NH3 vapour sensors were fabricated out of fabricated samples and it was observed that doped samples have significantly high sensing response, good selectivity, fast response and recovery time to ammonia vapoutr at room temperature.</p>

scholarly journals Toxic Gas Response for Nanostructured Cobalt Oxide Thin Films

2021 ◽  
Vol 19 (50) ◽  
pp. 20-30
Author(s):  
Suhad A. Hamdan ◽  
Iftikhar M. Ali ◽  
Isam M.Ibrahim
Keyword(s):  
Thin Films ◽  
Cobalt Oxide ◽  
Gas Sensing ◽  
Response Times ◽  
Xrd Analysis ◽  
Sem Analysis ◽  
Sensing Properties ◽  
Reducing Gas ◽  
Gas Sensing Properties ◽  
Gas Response

 The gas sensing properties of undoped Co3O4 and doped with Y2O3 nanostructures were investigated. The films were synthesized using the hydrothermal method on a seeded layer. The XRD, SEM analysis and gas sensing properties were investigated for the prepared thin films. XRD analysis showed that all films were polycrystalline, of a cubic structure with crystallite size of (12.6) nm for cobalt oxide and (12.3) nm for the Co3O4:6% Y2O3. The SEM analysis of thin films indicated that all films undoped Co3O4 and doped possessed a nanosphere-like structure. The sensitivity, response time and recovery time to H2S reducing and NO2 oxidizing gases were tested at different operating temperatures. The resistance changed with exposure to the test gas. The results revealed that the Co3O4:6%Y2O3 possessed the highest sensitivity around 90% (at room temperature) and 62.5% (at 150 oC) when exposed to the reducing gas H2S and oxidizing gas NO2, respectively with 0.8sec for both recovery and response times.

SEM analysis of the change in the reaction rates with deposit structures in the copper-iron cementation system

1978 ◽  
Vol 36 (1) ◽  
pp. 456-457
Author(s):  
V. Annamalai ◽  
L.E. Murr
Keyword(s):  
Structural Characteristics ◽  
Secondary Electron Emission ◽  
Copper Deposit ◽  
Reaction Rates ◽  
Sem Analysis ◽  
Experimental Conditions ◽  
Major Drawback ◽  
Emission Mode ◽  
Scrap Iron ◽  
Image Position

Economical recovery of copper metal from leach liquors has been carried out by the simple process of cementing copper onto a suitable substrate metal, such as scrap-iron, since the 16th century. The process has, however, a major drawback of consuming more iron than stoichiometrically needed by the reaction.Therefore, many research groups started looking into the process more closely. Though it is accepted that the structural characteristics of the resultant copper deposit cause changes in reaction rates for various experimental conditions, not many systems have been systematically investigated. This paper examines the deposit structures and the kinetic data, and explains the correlations between them.A simple cementation cell along with rotating discs of pure iron (99.9%) were employed in this study to obtain the kinetic results The resultant copper deposits were studied in a Hitachi Perkin-Elmer HHS-2R scanning electron microscope operated at 25kV in the secondary electron emission mode.

Improvement in NO2 Gas Sensing Performance Using Igzo Film Sensor

2020 ◽  
Vol 97 (6) ◽  
pp. 71-78
Author(s):  
Sunil Babu Eadi ◽  
Jun-Kyo Jeong ◽  
Hyeong-Sub Song ◽  
Ga-Won Lee ◽  
Hi-Deok Lee
Keyword(s):  
Gas Sensing ◽  
Film Sensor ◽  
Sensing Performance

Effect of Temperature on the Electrical and Gas Sensing Properties of Polyaniline and Multiwall Carbon Nanotube Doped Polyaniline Composite Thin Films

2011 ◽  
Vol 254 ◽  
pp. 167-170 ◽  
Author(s):  
Subodh Srivastava ◽  
Sumit Kumar ◽  
Vipin Kumar Jain ◽  
Y.K. Vijay
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Gas Sensing ◽  
Hydrogen Gas ◽  
Composite Thin Film ◽  
Effect Of Temperature ◽  
Multiwall Carbon Nanotube ◽  
Film Sensor ◽  
Composite Thin Films ◽  
Pani Composite

In the present work we have reported the effect of temperature on the gas sensing properties of pure Polyaniline (PANI) and Multiwall carbon nanotube (MWNT) doped PANI composite thin film based chemiresistor type gas sensors for hydrogen gas sensing application. PANI and MWNT doped PANI composite were synthesized by in situ chemical oxidative polymerization of aniline using ammonium persulfate in an acidic medium. The thin sensing film of chemically synthesized PANI and MWNT doped PANI composite were deposited onto finger type Cu-interdigited electrodes using spin cast technique to prepared chemiresistor type gas sensor. The electrical properties of these composite thin films were characterized by I-V measurements as function of temperature. The I-V measurement revealed that conductivity of composite thin films increased as the temperature increased. The changes in resistance of the composite thin film sensor were utilized for detection of hydrogen gas. It was observed that at room temperature, MWNT doped PANI composite sensor shows higher response value and sensitivity with good repeatability in comparison to pure PANI thin film sensor. It was also observed that both PANI and MWNT doped PANI composite thin film based sensors showed unstable behavior as the temperature increased. The surface morphology of these composite thin films has also been characterized by scanning electron microscopy (SEM) measurement.

Star-Fruit-Shaped CuO Structures for High Performance Ethanol Gas Sensor Device

2021 ◽  
Vol 13 (4) ◽  
pp. 724-733
Author(s):  
Ahmad Umar ◽  
Ahmed A. Ibrahim ◽  
Rajesh Kumar ◽  
Hassan Algadi ◽  
Hasan Albargi ◽  
...  
Keyword(s):  
Gas Sensor ◽  
High Performance ◽  
Crystal Size ◽  
Gas Sensing ◽  
Sensor Applications ◽  
Sensor Device ◽  
Star Fruit ◽  
Micro Structures ◽  
Gas Response ◽  
Structural Crystal

In this paper, star-fruit-shaped CuO microstructures were hydrothermally synthesized and subsequently characterized through different techniques to understand morphological, compositional, structural, crystal, optical and vibrational properties. The formation of star-fruit-shaped structures along with some polygonal and spherical nanostructures was confirmed by FESEM analysis. XRD data and Raman spectrum confirmed the monoclinic tenorite crystalline phase of the CuO with crystal size 17.61 nm. Star-fruit-shaped CuO microstructures were examined for ethanol gas sensing behavior at various operating temperatures and concentrations. The gas response of 135% was observed at the optimal temperature of 225 °C. Due to excellent selectivity, stability and re-usability, the as-fabricated sensor based on star-fruit-shaped CuO micro-structures may be explored for future toxic gas sensor applications.

Fabrication, Characterization and Exploration of Cobalt (II) ion doped, modified zinc oxide thick film sensor for gas sensing characteristics of some pernicious gases

2021 ◽  
pp. 100187
Author(s):  
Vinayak R. Bagul ◽  
Ganesh R. Bhagure ◽  
Satish Arvind Ahire ◽  
Arun Vitthal Patil ◽  
Vishnu Ashok Adole ◽  
...  
Keyword(s):  
Zinc Oxide ◽  
Thick Film ◽  
Gas Sensing ◽  
Film Sensor ◽  
Sensing Characteristics

scholarly journals Preparation of Nanostructured SnO2-NiO Composite Semiconductor for Gas Sensor Applications

2021 ◽  
pp. 391-403
Author(s):  
S. Kumar ◽  
P. Gowthaman ◽  
J. Deenathayalan
Keyword(s):  
Gas Sensor ◽  
Composite Nanofibers ◽  
Volume Fraction ◽  
Gas Sensing ◽  
Precipitation Method ◽  
Response Sensitivity ◽  
X Ray ◽  
Sensing Properties ◽  
Working Temperature ◽  
Gas Sensing Properties

Electro spinning technology combined with chemical precipitation method and high-temperature calcination was used to prepare SnO2-NiO composite semiconductor nanofibers with different Sn content. Scanning electron microscope (SEM), X-ray diffractometer (XRD) and energy dispersive X-ray spectrometer (EDS) were used to characterize the morphology, structure and content of various elements of the sample. Using ethanol as the target gas, the gas sensing properties of SnO2-NiO nanofibers and the influence of Sn content on the gas sensing properties of composite nanofibers were explored. The research results show that SnO2-NiO composite nanofibers have a three-dimensional network structure, and the SnO2 composite can significantly enhance the gas sensitivity of NiO nanofibers. With increase of SnO2 content, the response sensitivity of composite fibers to ethanol gas increases, and the response sensitivity of composite nanofibers with the highest response to ethanol gas with a volume fraction of 100×10-6 at the optimal working temperature of 160℃ are13.4;It is 8.38 times the maximum response sensitivity of NiO nanofibers. Compared with the common ethanol gas sensor MQ-3 on the market, SnO2-NiO composite nanofibers have a lower optimal working temperature and higher response sensitivity, which has certain practical application value

A Novel Tungsten Trioxide Based Gas Sensor for Indoor Formaldehyde Detection

2021 ◽  
Vol 16 (3) ◽  
pp. 363-367
Author(s):  
Gaoqi Zhang ◽  
Fan Zhang ◽  
Kaifang Wang ◽  
Tao Tian ◽  
Shanyu Liu ◽  
...  
Keyword(s):  
Electron Microscope ◽  
Gas Sensor ◽  
Indoor Air ◽  
Gas Sensing ◽  
X Ray Diffraction ◽  
X Ray ◽  
Sensing Material ◽  
Transmission Electron ◽  
Gas Sensing Properties ◽  
Gas Response

Accurate and real-time detection of formaldehyde (HCHO) in indoor air is urgently needed for human health. In this work, a ceramic material (WO3·H2O) with unique structure was successfully prepared using an efficient hydrothermal method. The crystallinity, morphology and microstructure of the as-prepared sensing material were analyzed by X-ray diffraction (XRD), field emission scanning electron microscope (FESEM) as well as transmission electron microscope (TEM). The characterization results suggest that the as-prepared sample is composed of square-like nanoplates with uneven surface. Formaldehyde vapor is utilized as the target gas to investigate gas sensing properties of the synthesized novel nanoplates. The testing results indicate that the as-fabricated gas sensor exhibit high gas response and excellent repeatability to HCHO gas. The response value (Ra/Rg) is 24.5 towards 70 ppm HCHO gas at 350 °C. Besides, the gas sensing mechanism was described.

Sign in / Sign up

Export Citation Format

Share Document