Low-power tunnel field effect transistors using mixed As and Sb based heterostructures

2013 ◽  
Vol 2 (6) ◽  
pp. 637-678 ◽  
Author(s):  
Yan Zhu ◽  
Mantu K. Hudait
Keyword(s):  
Low Power ◽  
Band Gap ◽  
Field Effect ◽  
Field Effect Transistors ◽  
Band Alignment ◽  
Oxide Semiconductor ◽  
Device Performance ◽  
Material System ◽  
Wide Range ◽  
Band Alignments

AbstractReducing supply voltage is a promising way to address the power dissipation in nano-electronic circuits. However, the fundamental lower limit of subthreshold slope (SS) within metal oxide semiconductor field effect transistors (MOSFETs) is a major obstacle to further scaling the operation voltage without degrading ON/OFF ratio in current integrated circuits. Tunnel field-effect transistors (TFETs) benefit from steep switching characteristics due to the quantum-mechanical tunneling injection of carriers from source to channel, rather than by conventional thermionic emission in MOSFETs. TFETs based on group III-V compound semiconductor materials further improve the ON-state current and reduce SS due to the low band gap energies and smaller carrier tunneling mass. The mixed arsenide/antimonide (As/Sb) InxGa1-xAs/GaAsySb1-y heterostructures allow a wide range of band gap energies and various staggered band alignments depending on the alloy compositions in the source and channel materials. Band alignments at source/channel heterointerface can be well modulated by carefully controlling the compositions of the mixed As/Sb material system. In particular, this review introduces and summarizes the progress in the development and optimization of low-power TFETs using mixed As/Sb based heterostructures including basic working principles, design considerations, material growth, interface engineering, material characterization, device fabrication, device performance investigation, band alignment determination, and high temperature reliability. A review of TFETs using mixed As/Sb based heterostructures shows superior structural properties and distinguished device performance, both of which indicate the mixed As/Sb staggered gap TFET as a promising option for high-performance, low-standby power, and energy-efficient logic circuit application.

scholarly journals Three-Dimensional Nanoscale Mapping of State-of-the-Art Field-Effect Transistors (FinFETs)

2017 ◽  
Vol 23 (5) ◽  
pp. 916-925
Author(s):  
Pritesh Parikh ◽  
Corey Senowitz ◽  
Don Lyons ◽  
Isabelle Martin ◽  
Ty J. Prosa ◽  
...  
Keyword(s):  
Field Effect ◽  
Focused Ion Beam ◽  
Field Effect Transistors ◽  
Ion Beam ◽  
Semiconductor Industry ◽  
Three Dimensional ◽  
Atom Probe ◽  
Physical Structure ◽  
Oxide Semiconductor ◽  
Device Performance

AbstractThe semiconductor industry has seen tremendous progress over the last few decades with continuous reduction in transistor size to improve device performance. Miniaturization of devices has led to changes in the dopants and dielectric layers incorporated. As the gradual shift from two-dimensional metal-oxide semiconductor field-effect transistor to three-dimensional (3D) field-effect transistors (finFETs) occurred, it has become imperative to understand compositional variability with nanoscale spatial resolution. Compositional changes can affect device performance primarily through fluctuations in threshold voltage and channel current density. Traditional techniques such as scanning electron microscope and focused ion beam no longer provide the required resolution to probe the physical structure and chemical composition of individual fins. Hence advanced multimodal characterization approaches are required to better understand electronic devices. Herein, we report the study of 14 nm commercial finFETs using atom probe tomography (APT) and scanning transmission electron microscopy–energy-dispersive X-ray spectroscopy (STEM-EDS). Complimentary compositional maps were obtained using both techniques with analysis of the gate dielectrics and silicon fin. APT additionally provided 3D information and allowed analysis of the distribution of low atomic number dopant elements (e.g., boron), which are elusive when using STEM-EDS.

scholarly journals Effects of Doping Concentration on Device Performance of GaN-based Nano-regime MOSFETs

2017 ◽  
Vol 16 (1) ◽  
pp. 69-74
Author(s):  
Md Iktiham Bin Taher ◽  
Md. Tanvir Hasan
Keyword(s):  
Field Effect ◽  
Doping Concentration ◽  
Field Effect Transistors ◽  
Metal Oxide Semiconductor ◽  
Oxide Semiconductor ◽  
Device Performance ◽  
Gate Length ◽  
Drain Voltage ◽  
Switching Device ◽  
Device Applications

Gallium nitride (GaN) based metal-oxide semiconductor field-effect transistors (MOSFETs) are promising for switching device applications. The doping of n- and p-layers is varied to evaluate the figure of merits of proposed devices with a gate length of 10 nm. Devices are switched from OFF-state (gate voltage, VGS = 0 V) to ON-state (VGS = 1 V) for a fixed drain voltage, VDS = 0.75 V. The device with channel doping of 1×1016 cm-3 and source/drain (S/D) of 1×1020 cm-3 shows good device performance due to better control of gate over channel. The ON-current (ION), OFF-current (IOFF), subthreshold swing (SS), drain induce barrier lowering (DIBL), and delay time are found to be 6.85 mA/μm, 5.15×10-7 A/μm, 87.8 mV/decade, and 100.5 mV/V, 0.035 ps, respectively. These results indicate that GaN-based MOSFETs are very suitable for the logic switching application in nanoscale regime.

scholarly journals A Simulation Study of a Gate-All-Around Nanowire Transistor with a Core–Insulator

Micromachines ◽  
2020 ◽  
Vol 11 (2) ◽  
pp. 223 ◽  
Author(s):  
Yannan Zhang ◽  
Ke Han ◽  
and Jiawei Li
Keyword(s):  
Metal Oxide ◽  
Low Power ◽  
Energy Efficient ◽  
Field Effect ◽  
High Performance ◽  
Field Effect Transistors ◽  
Future Generation ◽  
Metal Oxide Semiconductor ◽  
Oxide Semiconductor ◽  
Ultra Low Power

Ultra-low power and high-performance logical devices have been the driving force for the continued scaling of complementary metal oxide semiconductor field effect transistors which greatly enable electronic devices such as smart phones to be energy-efficient and portable. In the pursuit of smaller and faster devices, researchers and scientists have worked out a number of ways to further lower the leaking current of MOSFETs (Metal oxide semiconductor field effect transistor). Nanowire structure is now regarded as a promising candidate of future generation of logical devices due to its ultra-low off-state leaking current compares to FinFET. However, the potential of nanowire in terms of off-state current has not been fully discovered. In this article, a novel Core–Insulator Gate-All-Around (CIGAA) nanowire has been proposed, investigated, and simulated comprehensively and systematically based on 3D numerical simulation. Comparisons are carried out between GAA and CIGAA. The new CIGAA structure exhibits low off-state current compares to that of GAA, making it a suitable candidate of future low-power and energy-efficient devices.

scholarly journals Implementation of 20 nm Graphene Channel Field Effect Transistors Using Silvaco TCAD Tool to Improve Short Channel Effects over Conventional MOSFETs

2021 ◽  
Vol 7 (1) ◽  
pp. 18-29
Author(s):  
Vinod Pralhad Tayade ◽  
Swapnil Laxman Lahudkar
Keyword(s):  
Low Power ◽  
Field Effect ◽  
High Speed ◽  
Field Effect Transistors ◽  
Oxide Semiconductor ◽  
Short Channel Effects ◽  
Short Channel ◽  
Channel Effects ◽  
20 Nm ◽  
Graphene Material

In recent years, demands for high speed and low power circuits have been raised. As conventional metal oxide semiconductor field effect transistors (MOSFETs) are unable to satisfy the demands due to short channel effects, the purpose of the study is to design an alternative of MOSFETs. Graphene FETs are one of the alternatives of MOSFETs due to the excellent properties of graphene material. In this work, a user-defined graphene material is defined, and a graphene channel FET is implemented using the Silvaco technology computer-aided design (TCAD) tool at 100 nm and scaled to 20 nm channel length. A silicon channel MOSFET is also implemented to compare the performance. The results show the improvement in subthreshold slope (SS) = 114 mV/dec, ION/IOFF ratio = 14379, and drain induced barrier lowering (DIBL) = 123 mV/V. It is concluded that graphene FETs are suitable candidates for low power applications.

Sign in / Sign up

Export Citation Format

Share Document