scholarly journals ARCHITECTURAL AND DESIGN FEATURES OF RESIDENTIAL BUILDINGS IN SAINT-PETERSBURG IN THE SECOND HALF OF THE XVIII CENTURY

2020 ◽  
Vol 10 (2) ◽  
pp. 71-77
Author(s):  
Svetlana G. GOLOVINA

The paper presents a review of architectural and design techniques which were characteristic for residential development in the second half of the XVIII century in St. Petersburg. During that period, there was formed the urban planning, volumetric spatial and constructional structure of residential buildings, which later, in the XIX - early XX century, became a typical solution for residential development in St. Petersburg. The fi rewalled residential house was usually built along the perimeter of the possessory plot of land with an inner courtyard formed inside. The residential house consisted of a two-span front building and one-span side buildings located along the perimeter of the site. The constructional system of a residential building in the second half of the XVIII century was a vaulted-beam scheme along the longitudinal walls. The main construction structures are described, such as brick walls with subsequent fi nishing, strip stone footings based on wooden joists, roofs built on wooden batt er rafters in a cold att ic with no heating.

Author(s):  
E. G. Molotkova ◽  

The article presents a comparative analysis of urban planning complexes that turned out to be the first large objects of urbanization in Europe referring to the New Era. The introduction of a systematic approach to the development of vast wetlands and formation of an elite-type living environment is considered. The author reveals the characteristic features of residential buildings` morphotypes in St. Petersburg and Amsterdam referring to the early XVIII century and emphasizes the significance of the connectivity of territories and transport communications. The difference in the resources involved is noted, which is reflected in the project concepts and in the methodology for implementing the project. The article is the first part of a block of two articles.


2016 ◽  
Vol 11 (1) ◽  
pp. 97-106
Author(s):  
Lenka Sirochmanová ◽  
Mária Kozlovská ◽  
Renáta Bašková

Abstract The developers need to know what is important to their customers in preparation of new construction of residential buildings. The paper deals with finding the importance of structure, material, cost, time and environmental criteria of residential buildings from the perspective of the future owners. The research methodology that provided the information was questionnaire survey. Research was conducted in two lines. The first line is dedicated to the research of main construction domains of residential building. The second line of the research deals with the specific criteria of main construction domains. The order of importance of the main areas and the specific criteria is determined by analyzing of data through descriptive characteristics: median, modus, variance, average value and by weigh of importance.


2018 ◽  
Vol 33 ◽  
pp. 01030
Author(s):  
Andrey Vaytens ◽  
Gennadiy Rusanov ◽  
Pavel Skryabin

One of the most important issues in national urban planning is arrangement of high-rise buildings in the largest cities of Russia. This issue becomes especially acute in such cities as Saint Petersburg, which has unique architectural and urban-planning heritage preserved to a great extent. In this regard, it seems important to trace the evolution of high-rise construction development and arrangement in Leningrad – Saint Petersburg in the middle of the 20th — early 21st centuries. The goal of the article is to consider high-rise construction development regarding both public and residential buildings in comparison of project ideas and results of their implementation in the 1940s–2000s. Prerequisites and issues of high-rise construction of that period are considered. Particular attention is paid to changes in the official urban-planning policy, regulatory framework and attitude of city authorities to high-rise construction. The study was carried out with the consideration of the following historic periods differing in their urban-planning policy: the late 1940s–1950s; 1960s; 1970–1980s; 1990s; 2000s–2010s. Economical prerequisites of high-rise construction and their influence on the modern urban-planning policy during the post-Soviet period are considered. In conclusion, an attempt is made to determine tendencies of high-rise construction development in Saint Petersburg.


2019 ◽  
pp. 22-32
Author(s):  
В. А. Абизов ◽  
А. В. Кулик

Determination of the basic methodological provisions for the formation of the design service enterprises' entrance groups built-in into the residential buildings. Consideration of design features of the entrance groups of built-in objects in accordance with the hierarchical levels of formation of their architectural environment. The research is based on a systematic approach that allows us to consider the architectural environment of entertaining institutions as hierarchically subordinate to the integrity. Also are used methods of historical, comparative and typological analysis, experimental design. The article comprehensively examines the various factors and conditions that influence on the organization of the architectural environment of the service enterprises' entrance groups located on the first floors of residential buildings. The main stages of designing and the corresponding hierarchical levels of formation of the design of the service objects' entrance groups, are revealed.  The proposed method of designing of service enterprises' entrance groups of built-in into the apartment houses is proposed. The peculiarities of the design of entrance groups in accordance with the revealed hierarchical levels of formation and development of their architectural environment are presented. The given methodological provisions regarding the formation of the design of service enterprises' entrance groups of built-in into the apartment houses will be useful for the current practice of designing, rehabilitating, modernizing and exploiting the built-in service objects and will contribute to solving the problem of aesthetic expressiveness of residential development.


2020 ◽  
Vol 17 (1) ◽  
pp. 41
Author(s):  
UMMU SHOLEHAH MOHD NOR

High residential living in Malaysia has not been widely given a significant emphasises in literature despite its increasing scale and significance in the real estate market. The significance of high rise is mainly due the increasing rate of migration from rural to urban. It is estimated a total of 77.2 percent of the Malaysian population lived in urban areas in 2020. Approximately, 30 percent of this urban population lives in strata housing. These percentages are predicted to continue to increase in the future. The emergence of high residential building has been argued as confronting various problems which has considerable impact on this life style. Satisfaction is an important outcome of living in one’s dwelling, although it is not the only consideration. High residential building in Malaysia encountered numerous problems in term of management aspects, legislation aspects, and residents’ satisfaction. The purpose of this paper is to investigate the tenants’ satisfaction living in high residential buildings in Klang Valley. The questionnaires survey is conducted amongst 276 tenants at low cost and medium cost HRB using random sampling in HRB located at areas under jurisdiction Dewan Bandaraya Kuala Lumpur (DBKL), Majlis Bandaraya Subang Jaya (MBSJ), Majlis Bandaraya Shah Alam (MBSA), Majlis Bandaraya Subang Jaya (MBSJ), Majlis Perbandaran Selayang (MPS) and Majlis Perbandaran Ampang Jaya (MPAJ). The result from this study shows that tenant in medium cost residential building are more satisfied in term of facilities and management as compared to tenants in low cost residential building. Tenants also not disclosed to the existing act and procedure related to high residential building. In conclusion, this study suggested the Local Authority to emphasise the role of tenant. These recommendation hopefully will increase the level of satisfaction amongst the residents in HRB.


Energies ◽  
2021 ◽  
Vol 14 (10) ◽  
pp. 2917
Author(s):  
Mohammad Dabbagh ◽  
Moncef Krarti

This paper evaluates the potential energy use and peak demand savings associated with optimal controls of switchable transparent insulation systems (STIS) applied to smart windows for US residential buildings. The optimal controls are developed based on Genetic Algorithm (GA) to identify the automatic settings of the dynamic shades. First, switchable insulation systems and their operation mechanisms are briefly described when combined with smart windows. Then, the GA-based optimization approach is outlined to operate switchable insulation systems applied to windows for a prototypical US residential building. The optimized controls are implemented to reduce heating and cooling energy end-uses for a house located four US locations, during three representative days of swing, summer, and winter seasons. The performance of optimal controller is compared to that obtained using simplified rule-based control sets to operate the dynamic insulation systems. The analysis results indicate that optimized controls of STISs can save up to 81.8% in daily thermal loads compared to the simplified rule-set especially when dwellings are located in hot climates such as that of Phoenix, AZ. Moreover, optimally controlled STISs can reduce electrical peak demand by up to 49.8% compared to the simplified rule-set, indicating significant energy efficiency and demand response potentials of the SIS technology when applied to US residential buildings.


Symmetry ◽  
2021 ◽  
Vol 13 (3) ◽  
pp. 405
Author(s):  
Anam Nawaz Khan ◽  
Naeem Iqbal ◽  
Rashid Ahmad ◽  
Do-Hyeun Kim

With the development of modern power systems (smart grid), energy consumption prediction becomes an essential aspect of resource planning and operations. In the last few decades, industrial and commercial buildings have thoroughly been investigated for consumption patterns. However, due to the unavailability of data, the residential buildings could not get much attention. During the last few years, many solutions have been devised for predicting electric consumption; however, it remains a challenging task due to the dynamic nature of residential consumption patterns. Therefore, a more robust solution is required to improve the model performance and achieve a better prediction accuracy. This paper presents an ensemble approach based on learning to a statistical model to predict the short-term energy consumption of a multifamily residential building. Our proposed approach utilizes Long Short-Term Memory (LSTM) and Kalman Filter (KF) to build an ensemble prediction model to predict short term energy demands of multifamily residential buildings. The proposed approach uses real energy data acquired from the multifamily residential building, South Korea. Different statistical measures are used, such as mean absolute error (MAE), root mean square error (RMSE), mean absolute percentage error (MAPE), and R2 score, to evaluate the performance of the proposed approach and compare it with existing models. The experimental results reveal that the proposed approach predicts accurately and outperforms the existing models. Furthermore, a comparative analysis is performed to evaluate and compare the proposed model with conventional machine learning models. The experimental results show the effectiveness and significance of the proposed approach compared to existing energy prediction models. The proposed approach will support energy management to effectively plan and manage the energy supply and demands of multifamily residential buildings.


Energies ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 3876
Author(s):  
Sameh Monna ◽  
Adel Juaidi ◽  
Ramez Abdallah ◽  
Aiman Albatayneh ◽  
Patrick Dutournie ◽  
...  

Since buildings are one of the major contributors to global warming, efforts should be intensified to make them more energy-efficient, particularly existing buildings. This research intends to analyze the energy savings from a suggested retrofitting program using energy simulation for typical existing residential buildings. For the assessment of the energy retrofitting program using computer simulation, the most commonly utilized residential building types were selected. The energy consumption of those selected residential buildings was assessed, and a baseline for evaluating energy retrofitting was established. Three levels of retrofitting programs were implemented. These levels were ordered by cost, with the first level being the least costly and the third level is the most expensive. The simulation models were created for two different types of buildings in three different climatic zones in Palestine. The findings suggest that water heating, space heating, space cooling, and electric lighting are the highest energy consumers in ordinary houses. Level one measures resulted in a 19–24 percent decrease in energy consumption due to reduced heating and cooling loads. The use of a combination of levels one and two resulted in a decrease of energy consumption for heating, cooling, and lighting by 50–57%. The use of the three levels resulted in a decrease of 71–80% in total energy usage for heating, cooling, lighting, water heating, and air conditioning.


2021 ◽  
Vol 13 (2) ◽  
pp. 679
Author(s):  
Roya Aeinehvand ◽  
Amiraslan Darvish ◽  
Abdollah Baghaei Daemei ◽  
Shima Barati ◽  
Asma Jamali ◽  
...  

Today, renewable resources and the crucial role of passive strategies in energy efficiency in the building sector toward the sustainable development goals are more indispensable than ever. Natural ventilation has traditionally been considered as one of the most fundamental techniques to decrease energy usage by building dwellers and designers. The main purpose of the present study is to enhance the natural ventilation rates in an existing six-story residential building situated in the humid climate of Rasht during the summertime. On this basis, two types of ventilation systems, the Double-Skin Facade Twin Face System (DSF-TFS) and Single-Sided Wind Tower (SSWT), were simulated through DesignBuilder version 4.5. Then, two types of additional ventilation systems were proposed in order to accelerate the airflow, including four-sided as well as multi-opening wind towers. The wind foldable directions were at about 45 degrees (northwest to southeast). The simulation results show that SSWT could have a better performance than the aforementioned systems by about 38%. Therefore, the multi-opening system was able to enhance the ventilation rate by approximately 10% during the summertime.


2020 ◽  
Vol 12 (24) ◽  
pp. 10344
Author(s):  
Sameh Monna ◽  
Adel Juaidi ◽  
Ramez Abdallah ◽  
Mohammed Itma

This paper targets the future energy sustainability and aims to estimate the potential energy production from installing photovoltaic (PV) systems on the rooftop of apartment’s residential buildings, which represent the largest building sector. Analysis of the residential building typologies was carried out to select the most used residential building types in terms of building roof area, number of floors, and the number of apartments on each floor. A computer simulation tool has been used to calculate the electricity production for each building type, for three different tilt angles to estimate the electricity production. Tilt angle, spacing between the arrays, the building shape, shading from PV arrays, and other roof elements were analyzed for optimum and maximum electricity production. The electricity production for each household has been compared to typical household electricity consumption and its future consumption in 2030. The results show that installing PV systems on residential buildings can speed the transition to renewable energy and energy sustainability. The electricity production for building types with 2–4 residential units can surplus their estimated future consumption. Building types with 4–8 residential units can produce their electricity consumption in 2030. Building types of 12–24 residential units can produce more than half of their 2030 future consumption.


Sign in / Sign up

Export Citation Format

Share Document