Purpose: Assessment of the possibilities of shaping the structure and improvement
of mechanical properties of casting from AlMg10 alloy through a selection of casting
technology and precipitation hardening.
Design/methodology/approach: the work evaluated the impact of casting and heat
treatment technology on the mechanical properties and structure of AlMg10 alloy castings.
The tests were performed on 200 mm × 100 mm × 25 mm plate castings produced by
gravity casting methods for sand and metal moulds and by a liquid state press moulding
technology. Castings made with these technologies solidify in substantially different heat-
evaporation conditions and exhibit varying degrees of primary structure fragmentation.
Metallographic and strength tests were performed on raw castings and after heat treatment.
Findings: The changes in the morphology and size of primary crystals and the dispersion
of the reinforcing phase according to the casting solidification rate and the precipitation
hardening treatment were analyzed. Solidifying castings in the form of sand show a globular
structure, whereas in die and press castings, a typically dendritic structure occurs, with the
dendritic crystals in pressed castings being much smaller in size than the die castings. In
castings which were not heat-treated, the reinforcing phase of Al3Mg2 occurs in interdendritic
spaces, and its dispersion increases with the rate of cooling. After supersaturation and
ageing treatments, the phase α has a grain structure in all samples. The largest dispersion
of reinforcing molecules is characterized by press castings. In a raw state, the highest
mechanical properties are shown by castings made in the form of sand and the method of
pressing in a liquid state. Heat treatment of AlMg10 alloy castings significantly influences
the increase of mechanical indexes in all castings investigated. The highest features of Rm
are approx. 330 MPa and A5 above 10% is obtained in castings made by the press method.
Research limitations/implications: Particular attention should be paid to the avoidance
of the effects of slag inclusion, shrinkage and magnesium oxidation during casting of
AlMg10 alloys. In die castings of a plate type, due to own stresses, a significant decrease in
mechanical properties occurs.
Practical implications: The most advantageous mechanical properties of AlMg10 alloy
castings are obtained by using liquid-state pressing technology. In addition, this technology
makes it possible to produce thin-walled castings of high dimensional accuracy, high air-
tightness, fine grain structure, lack of surface defects and low roughness.
Originality/value: The paper presents the possibility of improving the mechanical
properties of AlMg10 castings by applying heat treatment. It has been proven that the
casting method has a significant effect on the mechanical properties of the castings.
The effect of the non-dendritic structure of aluminum alloy 1973 ingots on the process of stamping in the solid-liquid state
