Unilateral NMR and Micro DSC Study of Artificially Aged Parchments

2017 ◽  
Vol 68 (8) ◽  
pp. 1780-1785 ◽  
Author(s):  
Claudiu Sendrea ◽  
Elena Badea ◽  
Alina Adams
Keyword(s):  
Structural Changes ◽  
Ageing Time ◽  
Relaxation Times ◽  
Thermal Ageing ◽  
Accelerated Ageing ◽  
Transverse Relaxation ◽  
Thermally Induced ◽  
Unilateral Nmr ◽  
Micro Dsc ◽  
The Impact

New and artificially aged parchments were studied by unilateral NMR and micro DSC. Samples were obtained by exposing new parchments to 80 �C and alternate 40 and 80% relative humidity for increasing times up to 32 days. The impact of accelerated ageing was assessed by measuring both the proton transverse relaxation times (T2eff) and thermodynamic parameters associated with thermal denaturation of fibrillar collagen. Depending on the ageing time, significant structural changes correlated with thermal stability and collagen heterogeneity were observed, in good agreement with changes in phase composition and relaxation times. The results suggest two ageing regimes depending on the balance between the two main processes which drive the behavior of parchments during thermal ageing, i.e. thermally induced cross linking and thermal destabilization and denaturation.

Thermal Ageing Embrittlement of Casting Duplex Stainless Steels for Nuclear Power Plant

2010 ◽  
Author(s):  
Yuhong Yao ◽  
Jianfeng Wei ◽  
Jiangnan Liu ◽  
Zhengpin Wang ◽  
Yu Wang
Keyword(s):  
Stainless Steels ◽  
Thermal Aging ◽  
Nuclear Power ◽  
Power Plants ◽  
Ageing Time ◽  
Thermal Ageing ◽  
Duplex Stainless Steels ◽  
Impact Properties ◽  
Α Phase ◽  
The Impact

Cast duplex stainless steels (CSS) used for PWR pipes are degraded due to thermal ageing embrittlement during long-term service at 288 °C to 327 °C. Z3CN20-09M Cast duplex Stainless Steels (CSS) made in France for domestic nuclear power plants were thermally aged at 400 °C for 100 h, 300 h, 1000 h, 3000 h and 10000 h. The tensile properties and the impact properties at different thermal aging duration were measured and the effects of the thermal aging time on the microscopic structures and substructures of Z3CN20-09M were respectively investigated by optical microscopy and transmission electron microscopy. The results showed that the tensile strengths of Z3CN20-09M CSS increased gradually with the increment of the thermal ageing time, whereas the impact properties decreased with the prolonging of the thermal ageing time. After long thermal ageing time the dislocation configurations were greatly changed in austenite, and there were precipitates along the austenite-ferrite interface. Moreover, the iron-rich α phase and the chromium-rich α phase precipitated in ferrite aged for 10000h by nucleation and growth rather than the spinodal decomposition. All of above revealed that Z3CN20-09M CSS became brittle during thermal ageing.

Microstructural and Property Changes During Short-Term Ageing of Cast Austenitic Stainless Steels

1983 ◽  
Vol 21 ◽  
Author(s):  
M. Hodgkinson ◽  
T.A. Towers
Keyword(s):  
Impact Energy ◽  
Structural Changes ◽  
Fine Particles ◽  
Ageing Time ◽  
Austenitic Stainless Steels ◽  
Ferrite Content ◽  
Delta Ferrite ◽  
Microstructural Investigation ◽  
Property Changes ◽  
The Impact

ABSTRACTThe Charpy ν-notch impact properties at -196°C of casts of Type 316 austenitic stainless steel have been compared, after ageing at 650°C for time periods up to 90 minutes. The impact energy of all steels depends on ageing time; the degree of response to ageing depends on original delta ferrite content, which varied from −0.5% to 5.0% in the steels studied. For steels with delta ferrite content in the lower half of this range the impact energy, during ageing, initially decreases to a minimum, subsequently rises to a maximum and finally decreases. Steels with delta ferrite contents near 5% suffer a continuous decrease in impact energy as ageing time increases.Microstructural investigation reveals, during early stages of ageing, the rapid formation of sigma phase, at the ferrite-austenite interphase boundaries. Some delta concurrently transforms to new austenite. Microfractographs indicate a change in the nature of the fracture as ageing progresses. Initially, fractures have large dimples, but as ageing progresses, a finer dimpling appears and extends in area. These dimples contain fine particles, identified mainly as MnS. The variations in impact behaviour are explained on the basis of the structural changes observed.

Comparative Studies on the Thermal Ageing of Some Painting Materials

2018 ◽  
Vol 55 (2) ◽  
pp. 168-175
Author(s):  
Traian Rus ◽  
Adriana Mariana Bors ◽  
Alina Ruxana Caramitu ◽  
Iosif Lingvay ◽  
Danut Ionel Vaireanu
Keyword(s):  
Structural Changes ◽  
Thermal Stresses ◽  
Industrial Applications ◽  
Thermal Ageing ◽  
Accelerated Ageing ◽  
Clear Correlation ◽  
Dielectric Losses ◽  
Thermal Treatments ◽  
Thermal Cycles ◽  
Painting Materials

This paper presents a comparative study with respect to the behavior of some painting materials, used mainly for decorative and protective industrial applications, exposed to a controlled accelerated ageing process by using thermal storage and successive thermal cycles. The evaluation of the structural changes, as well as those concerning the dielectric loss were carried out in a comparative manner, on the initial samples, before any exposure to thermal stresses and during the ongoing process of the thermal treatments applied. As analysis techniques coupled thermal analysis and dielectric impedance spectroscopy have been used. It was found that there is a clear correlation between the structural changes of the investigated materials, particularly in the case of the epoxy materials subjected to the applied thermal treatments and the evolution of the dielectric losses in the material. As a result of these investigations, one may determine the characteristic acceptable zones for the thermal stresses (up to 1300 h of storage and 1500 thermal cycles), anything above these boundaries leading to strong increases in the dielectric losses and hence the deterioration of the materials rendered unfit to be used for the intended purpose.

International trade: Research of the reasons for the fall

2019 ◽  
pp. 79-91 ◽  
Author(s):  
V. S. Nazarov ◽  
S. S. Lazaryan ◽  
I. V. Nikonov ◽  
A. I. Votinov
Keyword(s):  
Growth Rate ◽  
International Trade ◽  
Exchange Rate ◽  
Global Economy ◽  
Structural Changes ◽  
Global Value Chains ◽  
Value Chains ◽  
Negative Contribution ◽  
Basic Commodity ◽  
The Impact

The article assesses the impact of various factors on the growth rate of international trade. Many experts interpreted the cross-border flows of goods decline against the backdrop of a growing global economy as an alarming sign that indicates a slowdown in the processes of globalization. To determine the reasons for the dynamics of international trade, the decompositions of its growth rate were carried out and allowed to single out the effect of the dollar exchange rate, the commodities prices and global value chains on the change in the volume of trade. As a result, it was discovered that the most part of the dynamics of international trade is due to fluctuations in the exchange rate of the dollar and prices for basic commodity groups. The negative contribution of trade within global value chains in 2014 was also revealed. During the investigated period (2000—2014), such a picture was observed only in the crisis periods, which may indicate the beginning of structural changes in the world trade.

THE IMPACT OF UKRAINE'S EXCISE DUTY POLICY ON THE TRANSFORMATION PROCESSES OF THE TOBACCO MARKET

2020 ◽  
Vol 2020 (10) ◽  
pp. 19-33
Author(s):  
Nadiia NOVYTSKA ◽  
◽  
Inna KHLIEBNIKOVA ◽  
Keyword(s):  
Structural Changes ◽  
Tax Avoidance ◽  
Transformation Process ◽  
State Regulation ◽  
Tobacco Products ◽  
Excise Duty ◽  
Increasing Demand ◽  
High Level ◽  
The Impact ◽  
Transformation Processes

The market of tobacco products in Ukraine is one of the most dynamic and competitive. It develops under the influence of certain factors that cause structural changes, therefore, the aim of the article is to conduct a comprehensive analysis of transformation processes in the market of tobacco and their alternatives in Ukraine and identify the factors that cause them. The high level of tax burden and the proliferation of alternative products with a potentially lower risk to human health, including heating tobacco products and e-cigarettes, are key factors in the market’s transformation process. Their presence leads to an increase in illicit turnover of tobacco products, which accounts for 6.37% of the market, and the gradual replacement of cigarettes with alternative products, which account for 12.95%. The presence on the market of products that are not taxed or taxed at lower rates is one of the reasons for the reduction of excise duty revenues. According to the results of 2019, the planned indicators of revenues were not met by 23.5%. Other reasons for non-fulfillment of excise duty revenues include: declining dynamics of the tobacco products market; reduction in the number of smokers; reorientation of «cheap whites» cigarette flows from Ukraine to neighboring countries; tax avoidance. Prospects for further research are identified, namely the need to develop measures for state regulation and optimization of excise duty taxation of tobacco products and their alternatives, taking into account the risks to public health and increasing demand of illegal products.

Effekt of blood flow shutdown on the vein damage when exposed to HIFU

2017 ◽  
pp. 46-50
Author(s):  
Н.Н. Петрищев ◽  
Д.Ю. Семенов ◽  
А.Ю. Цибин ◽  
Г.Ю. Юкина ◽  
А.Е. Беркович ◽  
...  
Keyword(s):  
Blood Flow ◽  
Structural Changes ◽  
Focused Ultrasound ◽  
Vena Cava ◽  
Posterior Wall ◽  
High Intensity Focused Ultrasound ◽  
Vein Wall ◽  
Ultrasound Exposure ◽  
Isolated Segment ◽  
The Impact

The purpose. In the study we investigated the impact of the partial blood flow shutdown on structural changes in the rabbit vena cava posterior wall after exposure to high-intensity focused ultrasound (HIFU). Methods. Ultrasound Exposure: frequency of 1.65 MHz, the ultrasound intensity in the focus of 13.6 kW/cm, the area of the focal spot 1 mm, continuous ultrasound, exposure for 3 seconds. Results. Immediately after HIFU exposure all layers of the vein wall showed characteristic signs of thermal damage. A week after exposure structural changes in the intima, media and adventitia was minimal in the part of vessel with preserved blood flow, and after 4 weeks the changes were not revealed. A week after HIFU exposure partial endothelium destruction, destruction of myocytes, disorganization and consolidation of collagen fibers of the adventitia were observed in an isolated segment of the vessel, and in 4 weeks endothelium restored and signs of damage in media and adventitia persisted, but were less obvious than in a week after exposure. Conclusion. The shutdown of blood flow after exposure to HIFU promotes persistent changes in the vein wall. Vein compression appears to be necessary for the obliteration of the vessel, when using HIFU-technology.

scholarly journals KUALITAS AIR SUNGAI DI KAWASAN WISATA PANTAI PETITENGET, KEROBOKAN KABUPATEN BADUNG BALI

2018 ◽  
Vol 12 (2) ◽  
pp. 226
Author(s):  
Wayan Budiarsa Suyasa ◽  
Sri Kunti Pancadewi G. A ◽  
Iryanti E. Suprihatin ◽  
Dwi Adi Suastuti G. A.
Keyword(s):  
Water Quality ◽  
Structural Changes ◽  
Pollution Index ◽  
Basic Structure ◽  
Physical Damage ◽  
E Coli ◽  
Pollutant Source ◽  
Quality Category ◽  
Index Value ◽  
The Impact

In order to maintain the environmental carrying capacity of coastal tourism, this research was conducted to determine the condition of river water environmental pollution in the Petitenget beach area and pollutant source activities. Determination of water quality is carried out by analyzing the water quality taken at several sampling points in the four rivers that lead to the Petitenget beach. Determined the pollution index value (IP) of the physical chemical and biological pollution parameters. The results showed that the four rivers that flow into the Petitenget Beach area had been contaminated with indications of pH, BOD, COD, ammonia, Coliform and E. coli which exceeded water quality category III class quality (PerGub Bali No 16 Year 2016). The four rivers are included in the criteria of severe contamination. The four rivers have experienced physical damage or structural changes that have very high discharge fluctuations both in quantity and quality. Slimy basic structure, smelly and slum aesthetic waters. While the indication of the impact of pollution is waste water which is directly discharged into the river from hotels, restaurants, homestays, commercial centers and settlements.

Statistical Approaches to Structural Change in Regional Interindustry Models

1986 ◽  
Vol 18 (9) ◽  
pp. 1189-1207
Author(s):  
B Ó Huallacháin
Keyword(s):  
Structural Change ◽  
Structural Changes ◽  
Washington State ◽  
Multivariate Statistical Analyses ◽  
Input Output ◽  
Multivariate Statistical ◽  
State Data ◽  
System A ◽  
Statistical Approaches ◽  
The Impact

The conventional approach to assessing structural change in regional input – output tables is to measure the impact of coefficient change on the estimation of outputs and multipliers. The methods developed and tested in this paper focus exclusively on the coefficients. Univariate and multivariate statistical analyses can be used to identify and measure various types of changes ranging from coefficient instability to changes in interindustry relationships as a system. A distinction is made between structural changes in input relationships and those in output relationships. The methods are tested by using Washington State data for the years 1963 and 1967. The results are compared with previous analyses of change in these data.

Sign in / Sign up

Export Citation Format

Share Document