Mesa-structures and Focal Plane Arrays based on epitaxially grown InSb layers

Aspects of epitaxially grown indium antimonide (InSb) on InSb substrates (InSb-on-InSb) by molecular beam epitaxy (MBE) for the 2D focal plane arrays fabrication process have been described. The epitaxial growth offers possibility for complex structure production, and then such structures suppose more effective control of the thermal generation charge carriers as the detector temperature is raised above 80 K. Investigations of mid-wave infrared (MWIR) 320256 FPAs with 30 μm pitch and 640512 FPAs with 15 μm pitch based on InSb-on-InSb layers have shown high performance: the average detectivity at T = 77 K more than 21011 cmW-1Hz1/2, the average value of noise equivalent temperature difference (NETD) with a cold aperture of 60o at T = 77K was in the range of 10–20 mK. High quality thermal imaging images were obtained in real time mode.

Impact of parameter control on the performance of APSO and PSO algorithms for the CSTHTS problem: An improvement in algorithmic structure and results

Cascaded Short Term Hydro-Thermal Scheduling problem (CSTHTS) is a single objective, non-linear multi-modal or convex (depending upon the cost function of thermal generation) type of Short Term Hydro-Thermal Scheduling (STHTS), having complex hydel constraints. It has been solved by many metaheuristic optimization algorithms, as found in the literature. Recently, the authors have published the best-achieved results of the CSTHTS problem having quadratic fuel cost function of thermal generation using an improved variant of the Accelerated PSO (APSO) algorithm, as compared to the other previously implemented algorithms. This article discusses and presents further improvement in the results obtained by both improved variants of APSO and PSO algorithms, implemented on the CSTHTS problem.

Electrophysical and photocatalytic properties of SnO2-ZnO thin films prepared by sol-gel method

Electrophysical properties of SnO2-ZnO thin films prepared by sol-gel method have been studied. The resistance of thin films have a temperature hysteresis, the films resistance decreases up to two times when the temperature reaches 210-300 °C and returns to its initial value when cooling down to 90-30 °C. That phenomenon can be explained by the processes of thermal generation - recombination of electrons, and adsorption - desorption of oxygen on the surface of the films.

Heat and Mass Transfer Impact on Differential Type Nanofluid with Carbon Nanotubes: A Study of Fractional Order System

This paper is an analysis of flow of MHD CNTs of second grade nano-fluid under the influence of first order chemical reaction, suction, thermal generation and magnetic field. The fluid is flowing through a porous medium. For the study of heat and mass transfer, we applied the newly introduced differential operators to model such flow. The equations for heat, mass and momentum are established in the terms of Caputo (C), Caputo–Fabrizio (CF) and Atangana–Baleanu in Caputo sense (ABC) fractional derivatives. This shows the novelty of this work. The equations for heat, mass and momentum are established in the terms of Caputo (C), Caputo–Fabrizio (CF) and Atangana–Baleanu in Caputo sense (ABC) fractional derivatives. The solutions are evaluated by employing Laplace transform and inversion algorithm. The flow in momentum profile due to variability in the values of parameters are graphically illustrated among C, CF and ABC models. It is concluded that fluid velocity showed decreasing behavior for χ, P, ℏ2, Mo, Pr, ℵ and Sc while it showed increasing behavior for Gr, Gm, κ and Ao. Moreover, ABC fractional operator presents larger memory effect than C and CF fractional operators.

Specific Features of Renewable Energy Development in the World and Russia

The purpose of the article is to study the theoretical and practical aspects of investment activities in the field of renewable energy in the world and in Russia. To achieve this goal, during the development of theoretical material, a systematic analysis of existing approaches to the assessment of financing mechanisms for renewable energy projects was carried out. Statistical and econometric research tools include correlation analysis and multivariate regression analysis. The article examines the development of renewable energy, its benefits, and investments in the industry. The financial risks and barriers associated with financing renewable energy projects are considered. The development of the industry over the past 10 years is analyzed, taking into account the impact of the COVID-19 pandemic on the electricity industry in general and on renewable energy in a number of countries. It is established that the world is shifting to the use of renewable energy sources, and in Russia they are not being given due attention. It is revealed that the existing thermal generation units in Russia are of great age and are to be decommissioned in the near future. The current state of renewable energy in Russia, measures to support it and the rate of its development are investigated. The technical potential of wind and solar power plants in the Russian Federation is considered within the aim of diversifying electricity production. The factors that negatively affect the development of the renewable energy industry are identified.

Diacetyl and Other Ketones in e-Cigarette Aerosols: Some Important Sources and Contributing Factors

Background: Concerns over the presence of the diketones 2,4 butanedione (DA) and 2,3 pentanedione (AP) in e-cigarettes arise from their potential to cause respiratory diseases. Their presence in e-liquids is a primary source, but they may potentially be generated by glycerol (VG) and propylene glycol (PG) when heated to produce aerosols. Factors leading to the presence of AP, DA and acetoin (AC) in e-cigarette aerosols were investigated. We quantified direct transfer from e-liquids, examined thermal degradation of major e-liquid constituents VG, PG and 1,3 propanediol (1,3 PD) and the potential for AC, AP and DA production from sugars and flavor additives when heated in e-cigarettes.Method: Transfers of AC, AP and DA from e-liquids to e-cigarette aerosols were quantified by comparing aerosol concentrations to e-liquid concentrations. Thermal generation from VG, PG or 1,3 PD e-liquids was investigated by measuring AC, AP and DA emissions as a function of temperature in an e-cigarette. Thermal generation of AC, AP and DA from sugars was examined by aerosolising e-liquids containing sucrose, fructose or glucose in an e-cigarette. Pyrolytic formation of AP and DA from a range of common flavors was assessed using flash pyrolysis techniques.Results: AC transfer efficiency was >90%, while AP and DA were transferred less efficiently (65%) indicating losses during aerosolisation. Quantifiable levels of DA were generated from VG and PG, and to a lesser extent 1,3 PD at coil temperatures >300°C. Above 350°C AP was generated from VG and 1,3 PD but not PG. AC was not generated from major constituents, although low levels were generated by thermal reduction of DA. Aerosols from e-liquids containing sucrose contained quantifiable (>6 ng/puff) levels of DA at all sucrose concentrations tested, with DA emissions increasing with increasing device power and concentration. 1% glucose, fructose or sucrose e-liquids gave comparable DA emissions. Furanose ring compounds also generate DA and AP when heated to 250°C.Conclusions: In addition to less than quantitative direct transfer from the e-liquid, DA and AP can be present in the e-cigarette aerosol due to thermal decomposition reactions of glycols, sugars and furanonse ring flavors under e-cigarette operating conditions.

Biosynthesis of Silver Nanoparticles and Their Applications in Harvesting Sunlight for Solar Thermal Generation

Silver (Ag) nanoparticles (NPs) have been synthesized through an easy, inexpensive, and ecofriendly method. Petroselinum crispum, parsley, leaf extract was utilized as a reducing, capping, and stabilizing agent, without using any hazardous chemical materials, for producing Ag NPs. The biosynthesized Ag NPs were characterized using different characterization techniques, namely UV-Vis, FT-IR spectroscopy, X-ray diffraction (XRD), X-ray Photoelectron Spectroscopy (XPS), dynamic light scattering (DLS), zeta potential, differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), transmission electron microscope (TEM), field emission scanning electron microscopy (FESEM), and energy-dispersive X-ray (EDX) analysis to investigate the optical, thermal, structural, morphological, and chemical properties of the plant extract and the biosynthesized Ag NPs. After that, the biosynthesized Ag NPs were utilized in harvesting sunlight for solar thermal generation. Surface plasmon resonance (SPR) for the green synthesized Ag NPs with the dark color were adjusted at nearly 450 nm. Once the Ag NPs are excited at the SPR, a large amount of heat is released, which causes a change in the local refractive index surrounding the Ag NPs. The released heat from the Ag NPs under the solar irradiation at the precise wavelength of plasmon resonance significantly increased the temperature of the aqueous medium. Different percentages of Ag NPs were dispersed in water and then exposed to the sunlight to monitor the temperature of the suspension. It was found that the temperature of the aqueous medium reached its highest point when 0.3 wt. % of Ag NPs was utilized. This investigation is rare and unique, and it shows that utilizing a small amount of the biosynthesized Ag NPs can increase the temperature of the aqueous medium remarkably.