channel surface
Recently Published Documents


TOTAL DOCUMENTS

355
(FIVE YEARS 78)

H-INDEX

33
(FIVE YEARS 5)

2022 ◽  
Vol 327 ◽  
pp. 255-262
Author(s):  
Nai Yong Li ◽  
Wei Min Mao ◽  
Xiao Xin Geng ◽  
Peng Yu Yan

The semi-solid slurry of 6061 aluminum alloy was prepared by the serpentine channel pouring process. The influence of graphite serpentine channel and copper serpentine channel on the slurry was comparative analyzed. The effect of pouring temperature on the slurry microstructure was also investigated. The results indicate that both copper and graphite serpentine channel can be used to prepare semi-solid slurry with spherical primary grains. Compared with a permanent casting, the microstructure of the semi-solid slurry was significantly improved and refined. With the increase of pouring temperature, the average equivalent grain diameter of the primary phase grains in the semi-solid slurry increases gradually, but the shape factor decreases gradually. When the pouring temperature increased from 675 °C to 690 °C, a high quality semi-solid slurry can be obtained. Comparing the two kinds of serpentine channel, it is found that the copper serpentine channel can make the primary grains finer, and the average equivalent grain size was 63 μm. However, the solidified shell near the inner graphite serpentine channel surface was thinner than that of the copper serpentine channel. In conclusion, the graphite serpentine channel is more suitable for preparing semi-solid 6061 aluminum alloy slurry.


Author(s):  
Yoshito Koyama ◽  
Nobuyuki Ohmori ◽  
Hideya Momose ◽  
Shin-ichi Yamada ◽  
Hiroshi Kurita

2021 ◽  
Author(s):  
Shijin Yu ◽  
Wenzhen Zhu ◽  
Zhuohao Xiao ◽  
Jiahao Tong ◽  
Quanya Wei ◽  
...  

Abstract The application of iron oxide as anode of lithium-ion batteries is hindered by its poor cycle stability, low rate performance and large voltage hysteresis. To address these problems, multi-channel surface modified amorphous Fe2O3 nanospheres were synthesized by using a facile hydrothermal method, which exhibited outstanding electrochemical performances. According to crystalline state and microstructure, it was found that surface structure of the amorphous Fe2O3 nanospheres can be controlled by adjusting the reaction time, due to the synergistic effect of ripening and hydrogen ion etching. Owing to the isotropic nature and the absence of grain boundaries, the amorphous Fe2O3 nanospheres could withstand high strains during the intercalation of lithium ions. Meanwhile, the multi-channel surface structure can not only increase the contact area between Fe2O3 nanospheres and electrolyte, but also reserve space for volume expansion after lithium storage, thereby effectively alleviating the volume change during the intercalation-deintercalation of lithium ions. As confirmed by the Galvanostatic intermittent titration analysis results, the amorphous Fe2O3 electrode had higher Li+ diffusion coefficient than the crystalline counterpart. As a result, the multi-channel surface modified amorphous Fe2O3 electrode exhibited higher specific capacity, more stable cycle performance and narrower voltage hysteresis. It is believed that amorphous metal oxides have great potential as high-performance anode of next-generation lithium-ion batteries.


Nanomaterials ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 3311
Author(s):  
Yadong Zhang ◽  
Xiaoting Sun ◽  
Kunpeng Jia ◽  
Huaxiang Yin ◽  
Kun Luo ◽  
...  

The degradation of InSe film and its impact on field effect transistors are investigated. After the exposure to atmospheric environment, 2D InSe flakes produce irreversible degradation that cannot be stopped by the passivation layer of h-BN, causing a rapid decrease for InSe FETs performance, which is attributed to the large number of traps formed by the oxidation of 2D InSe and adsorption to impurities. The residual photoresist in lithography can cause unwanted doping to the material and reduce the performance of the device. To avoid contamination, a high-performance InSe FET is achieved by a using hard shadow mask instead of the lithography process. The high-quality channel surface is manifested by the hysteresis of the transfer characteristic curve. The hysteresis of InSe FET is less than 0.1 V at Vd of 0.2, 0.5, and 1 V. And a high on/off ratio of 1.25 × 108 is achieved, as well relative high Ion of 1.98 × 10−4 A and low SS of 70.4 mV/dec at Vd = 1 V are obtained, demonstrating the potential for InSe high-performance logic device.


Author(s):  
Shujie Shi ◽  
Teresa M. Buck ◽  
Andrew J. Nickerson ◽  
Jeffrey L. Brodsky ◽  
Thomas R. Kleyman

The mammalian paraoxonases have been linked to protection against oxidative stress. However, the physiological roles of members in this family (PON1, PON2 and PON3) are still being characterized. PON2 and PON3 are expressed in the aldosterone-sensitive distal nephron of the kidney and have been shown to negatively regulate expression of the epithelial sodium channel (ENaC), a trimeric ion channel that orchestrates salt and water homeostasis. To date, the nature of this phenomenon has not been explored. Therefore, to investigate the mechanism by which PON2 regulates ENaC, we expressed PON2 along with the ENaC subunits in Fisher Rat Thyroid (FRT) cells, a system that is amenable to biochemical analyses of ENaC assembly and trafficking. We found that PON2 primarily resides in the endoplasmic reticulum (ER) in FRT cells, and its expression reduces the abundance of each ENaC subunit, reflecting enhanced subunit turnover. In contrast, no effect on the levels of mRNAs encoding the ENaC subunits was evident. Inhibition of lysosome function with chloroquine or NH4Cl did not alter the inhibitory effect of PON2 on ENaC expression. In contrast, PON2 accelerates ENaC degradation in a proteasome-dependent manner and acts prior to ENaC subunits ubiquitination. As a result of the enhanced ENaC subunits ubiquitination and degradation, both channel surface expression and ENaC-mediated Na+ transport in FRT cells were reduced by PON2. Together, our data suggest that PON2 functions as an ER chaperone to monitor ENaC biogenesis and redirect the channel for ER associated degradation.


Sensors ◽  
2021 ◽  
Vol 21 (23) ◽  
pp. 8015
Author(s):  
Joonyoung Jung ◽  
Dong-Woo Lee ◽  
Yong Ki Son ◽  
Bae Sun Kim ◽  
Hyung Cheol Shin

We propose a novel dual-channel electromyography (EMG) spatio-temporal differential (DESTD) method that can estimate volitional electromyography (vEMG) signals during time-varying functional electrical stimulation (FES). The proposed method uses two pairs of EMG signals from the same stimulated muscle to calculate the spatio-temporal difference between the signals. We performed an experimental study with five healthy participants to evaluate the vEMG signal estimation performance of the DESTD method and compare it with that of the conventional comb filter and Gram–Schmidt methods. The normalized root mean square error (NRMSE) values between the semi-simulated raw vEMG signal and vEMG signals which were estimated using the DESTD method and conventional methods, and the two-tailed t-test and analysis of variance were conducted. The results showed that under the stimulation of the gastrocnemius muscle with rapid and dynamically modulated stimulation intensity, the DESTD method had a lower NRMSE compared to the conventional methods (p< 0.01) for all stimulation intensities (maximum 5, 10, 15, and 20 mA). We demonstrated that the DESTD method could be applied to wearable EMG-controlled FES systems because it estimated vEMG signals more effectively compared to the conventional methods under dynamic FES conditions and removed unnecessary FES-induced EMG signals.


Sign in / Sign up

Export Citation Format

Share Document