A Novel Method for Calcium Carbonate Deposition in Wood That Increases Carbon Dioxide Concentration and Fire Resistance

In this study, a novel method for calcium carbonate deposition in wood that increases carbon dioxide concentration and fire resistance is proposed. The method promoted the mineralization of radiata pine wood microstructure with calcium carbonate by using a process consisting in the vacuum impregnation of wood with a calcium chloride aqueous solution and the subsequent sequential diffusion of gaseous ammonium and carbon dioxide. In the most favorable conditions, the method yielded a weight gain of about 20 wt.% due to mineralization, which implied the accumulation of 0.467 mmol·g−1 of carbon dioxide in the microstructure of wood. In addition, a weight gain of about 8% was sufficient to provide fire resistance to a level similar to that achieved by a commercially available fire-retardant treatment. The feasibility of retaining carbon dioxide directly inside the wood microstructure can be advantageous for developing wood products with enhanced environmental characteristics. This method can be a potential alternative for users seeking materials that could be effective at supporting a full sustainable development.

Calcium Carbonate Scale Inhibition with Ultrasonication and a Commercial Antiscalant

In this study, ultrasonication-assisted calcium carbonate scale inhibition was investigated compared with a commercial antiscalant ATMP (amino tris(methyl phosphonic acid)). The effects of varying ultrasound amplitude, pH, and inhibition duration were evaluated. The inhibition of calcium carbonate scale formation was measured based on the concentration of calcium in the solution after subjecting to different conditions. Scale deposits were also characterized using scanning electron microscopy and X-ray diffraction spectroscopy. Inhibition of scale formation was supported at a pH of 7 for an ultrasound amplitude of 150 W. A 94% calcium carbonate inhibition was recorded when the experiment was carried out with ultrasonication. The use of 5 mg/L ATMP achieved a 90% calcium carbonate inhibition of ATMP. The result of the characterization revealed that the morphology of the crystals was unaffected by ultrasonic irradiation. Sample treatment was performed with two different membranes to evaluate the calcium carbonate deposition, and data reveals that, at identical conditions, ultrasonication provides less deposition when compared to the control experiments.

Pilot study to investigate the effect of long-term exposure to high pCO2 on adult cod (Gadus morhua) otolith morphology and calcium carbonate deposition

To date the study of ocean acidification on fish otolith formation has been mainly focused on larval and juvenile stages. In the present pilot study, wild-captured adult Atlantic cod (Gadus morhua) were exposed to two different levels of pCO2, 422µatm (ambient, low pCO2) or 1091µatm (high pCO2), for a period of 30 weeks (from mid-October to early April 2014–2015) in order to study the effects on otolith size, shape and CaCO3 crystallization amongst other biological parameters. We found that otoliths from cod exposed to high pCO2 were slightly smaller (− 3.4% in length; − 3.3% in perimeter), rounder (− 2.9% circularity and + 4% roundness) but heavier (+ 5%) than the low pCO2 group. Interestingly, there were different effects in males and females; for instance, male cods exposed to high pCO2 exhibited significant changes in circularity (− 3%) and roundness (+ 4%) compared to the low pCO2 males, but without significant changes on otolith dimensions, while females exposed to high pCO2 had smaller otoliths as shown for length (− 5.6%), width (− 2%), perimeter (− 3.5%) and area (− 4.8%). Furthermore, while the majority of the otoliths analysed showed normal aragonite deposition, 10% of fish exposed to 1091µatm of pCO2 had an abnormal accretion of calcite, suggesting a shift on calcium carbonate polymorph crystallization in some individuals under high pCO2 conditions. Our preliminary results indicate that high levels of pCO2 in adult Atlantic cod might affect otolith growth in a gender-specific way. Our findings reveal that otoliths from adult cod are affected by ocean acidification, and we believe that the present study will prompt further research into this currently under-explored area.

Calcium Transport along the Axial Canal in Acropora

In Acropora, the complex canals in a coral colony connect all polyps to a holistic network, enabling them to collaborate in performing biological processes. There are various types of canals, including calice, axial canals, and other internal canals, with structures that are dynamically altered during different coral growth states due to internal calcium transport. In this study, we investigated the morphological changes in the corallite of six Acropora muricata samples by high resolution micro-computed tomography, observing the patterns of calcium carbonate deposition within axial corallite during processes of new branch formation and truncated tip repair. We visualized the formation of a new branch from a calice and the calcium carbonate deposition in the axial canal. Furthermore, the diameter and volume changes of the axial canal in truncated branches during rebuilding processes were calculated, revealing that the volume ratio of calcareous deposits in the axial canal exhibit significant increases within the first three weeks, returning to levels in the initial state in the following week. This work demonstrates that calcium carbonate can be stored temporarily and then remobilized as needed for rapid growth. The results of this study shed light on the control of calcium carbonate deposition and growth of the axial corallite in Acropora.

Iron ore filtration process improvement through pH modification

The present study presents the effect of pH reduction in iron ore slurry for an iron ore filtration process. A reduction on moisture content and increase on filters throughput was proposed by the pH modification. The experimental procedure included bench scale tests and industrial scale up of the observed results. Additionally, Langelier’s saturation index was applied to determine the optimum pH range for the filtration operation. The calcium carbonate deposition test was developed and evaluated in the present study. A comprehensive evaluation at different pH ranges was performed leading to identify the calcium carbonate deposition critical point.

Experimental Study of EICP Combined with Organic Materials for Silt Improvement in the Yellow River Flood Area

Enzyme-induced carbonate precipitation (EICP) is an emerging biogeotechnical technique that uses free urease to improve soil. Despite its advantages of eliminating complex microbial cultures and reducing reaction byproducts, its efficiency is considered lower than that of microbial induced calcite precipitation (MICP) due to the lack of nucleation sites that induce calcium carbonate deposition. To enhance the strengthening efficiency of EICP for fine-grained soils, an improved EICP method that involves adding an appropriate mass concentration of organic materials (skim milk powder, glutinous rice powder, and brown sugar) into urease solution was proposed and applied to reinforce silt in the Yellow River flood area of China. The preferred concentration and ratio of cementation solution and the optimum concentration of each of the organic materials were determined. Then, the reinforcement effect of the improved EICP at the optimum concentration was compared with the control group, and the reinforcement mechanism for this method was discussed. The results show that after the organic material inclusions, soil strength can be enhanced by 33% compared with EICP-treated soil and is nearly four times higher than that of untreated soil. The superiority of this method over traditional EICP and MICP mainly stems from its ability to provide templates and nucleation sites for calcium carbonate deposition and to improve the size, morphology, and structure of calcium carbonate crystals.

3D Chitin Scaffolds of Marine Demosponge Origin for Biomimetic Mollusk Hemolymph-Associated Biomineralization Ex-Vivo

Structure-based tissue engineering requires large-scale 3D cell/tissue manufacture technologies, to produce biologically active scaffolds. Special attention is currently paid to naturally pre-designed scaffolds found in skeletons of marine sponges, which represent a renewable resource of biomaterials. Here, an innovative approach to the production of mineralized scaffolds of natural origin is proposed. For the first time, a method to obtain calcium carbonate deposition ex vivo, using living mollusks hemolymph and a marine-sponge-derived template, is specifically described. For this purpose, the marine sponge Aplysin aarcheri and the terrestrial snail Cornu aspersum were selected as appropriate 3D chitinous scaffold and as hemolymph donor, respectively. The formation of calcium-based phase on the surface of chitinous matrix after its immersion into hemolymph was confirmed by Alizarin Red staining. A direct role of mollusks hemocytes is proposed in the creation of fine-tuned microenvironment necessary for calcification ex vivo. The X-ray diffraction pattern of the sample showed a high CaCO3 amorphous content. Raman spectroscopy evidenced also a crystalline component, with spectra corresponding to biogenic calcite. This study resulted in the development of a new biomimetic product based on ex vivo synthetized ACC and calcite tightly bound to the surface of 3D sponge chitin structure.

Calcium cyclic carboxylates as structural models for calcium carbonate scale inhibitors

Calcium complexes of cyclic oligocarboxylic acids have been studied as models to understand how subtle changes in molecular structure lead to significant variation in inhibition ability for calcium carbonate deposition