Influence of stand structure on forest biomass sustainability

2022 ◽  
pp. 327-352
Author(s):  
Ana Cristina Gonçalves
2012 ◽  
Vol 9 (8) ◽  
pp. 3381-3403 ◽  
Author(s):  
T. R. Feldpausch ◽  
J. Lloyd ◽  
S. L. Lewis ◽  
R. J. W. Brienen ◽  
M. Gloor ◽  
...  

Abstract. Aboveground tropical tree biomass and carbon storage estimates commonly ignore tree height (H). We estimate the effect of incorporating H on tropics-wide forest biomass estimates in 327 plots across four continents using 42 656 H and diameter measurements and harvested trees from 20 sites to answer the following questions: 1. What is the best H-model form and geographic unit to include in biomass models to minimise site-level uncertainty in estimates of destructive biomass? 2. To what extent does including H estimates derived in (1) reduce uncertainty in biomass estimates across all 327 plots? 3. What effect does accounting for H have on plot- and continental-scale forest biomass estimates? The mean relative error in biomass estimates of destructively harvested trees when including H (mean 0.06), was half that when excluding H (mean 0.13). Power- and Weibull-H models provided the greatest reduction in uncertainty, with regional Weibull-H models preferred because they reduce uncertainty in smaller-diameter classes (≤40 cm D) that store about one-third of biomass per hectare in most forests. Propagating the relationships from destructively harvested tree biomass to each of the 327 plots from across the tropics shows that including H reduces errors from 41.8 Mg ha−1 (range 6.6 to 112.4) to 8.0 Mg ha−1 (−2.5 to 23.0). For all plots, aboveground live biomass was −52.2 Mg ha−1 (−82.0 to −20.3 bootstrapped 95% CI), or 13%, lower when including H estimates, with the greatest relative reductions in estimated biomass in forests of the Brazilian Shield, east Africa, and Australia, and relatively little change in the Guiana Shield, central Africa and southeast Asia. Appreciably different stand structure was observed among regions across the tropical continents, with some storing significantly more biomass in small diameter stems, which affects selection of the best height models to reduce uncertainty and biomass reductions due to H. After accounting for variation in H, total biomass per hectare is greatest in Australia, the Guiana Shield, Asia, central and east Africa, and lowest in east-central Amazonia, W. Africa, W. Amazonia, and the Brazilian Shield (descending order). Thus, if tropical forests span 1668 million km2 and store 285 Pg C (estimate including H), then applying our regional relationships implies that carbon storage is overestimated by 35 Pg C (31–39 bootstrapped 95% CI) if H is ignored, assuming that the sampled plots are an unbiased statistical representation of all tropical forest in terms of biomass and height factors. Our results show that tree H is an important allometric factor that needs to be included in future forest biomass estimates to reduce error in estimates of tropical carbon stocks and emissions due to deforestation.


Author(s):  
Ana Cristina Gonçalves ◽  
Isabel Malico ◽  
Adélia M.O. Sousa

As long as care is taken regarding stand and forest sustainability, forest biomass is an interesting alternative to fossil fuels because of its historical use as an energy source, its relative abundance and availability worldwide, and the fact that it is carbon-neutral. This study encompasses the revision of the state of the sources of forest biomass for energy and their estimation, the impacts on forests of biomass removal, the current demand and use of forest biomass for energy, and the most used energy conversion technologies. Forests can provide large amounts of biomass that can be used for energy. However, as the resources are limited, the increasing demand for biomass brings about management challenges. Stand structure is determinant for the amount of residues produced. Biomass can be estimated with high accuracy using both forest inventory and remote sensing. Yet, remote sensing enables biomass estimation and monitoring in shorter time periods. Different bioenergy uses and conversion technologies are characterized by different efficiencies, which should be a factor to consider in the choice of the best suited technology. Carefully analyzing the different options in terms of available conversion technologies, end-uses, costs, environmental benefits, and alternative energy vectors is of utmost importance.


2008 ◽  
Vol 38 (8) ◽  
pp. 2081-2096 ◽  
Author(s):  
K. R. Sherrill ◽  
M. A. Lefsky ◽  
J. B. Bradford ◽  
M. G. Ryan

This study evaluates the relative ability of simple light detection and ranging (lidar) indices (i.e., mean and maximum heights) and statistically derived canonical correlation analysis (CCA) variables attained from discrete-return lidar to estimate forest structure and forest biomass variables for three temperate subalpine forest sites. Both lidar and CCA explanatory variables performed well with lidar models having slightly higher explained variance and lower root mean square error. Adjusted R2 values were 0.93 and 0.93 for mean height, 0.74 and 0.73 for leaf area index, and 0.93 and 0.85 for all carbon in live biomass for the lidar and CCA explanatory regression models, respectively. The CCA results indicate that the primary source of variability in canopy structure is related to forest height, biomass, and total leaf area, and the second most important source of variability is related to the amount of midstory foliage and tree density. When stand age is graphed as a function of individual plot scores for canonicals one and two, there is a clear relationship with stand age and the development of stand structure. Lidar-derived biomass and related estimates developed in this work will be used to parameterize decision-support tools for analysis of carbon cycle impacts as part of the North American Carbon Program.


2012 ◽  
Vol 9 (3) ◽  
pp. 2567-2622 ◽  
Author(s):  
T. R. Feldpausch ◽  
J. Lloyd ◽  
S. L. Lewis ◽  
R. J. W. Brienen ◽  
E. Gloor ◽  
...  

Abstract. Above-ground tropical tree biomass and carbon storage estimates commonly ignore tree height. We estimate the effect of incorporating height (H) on forest biomass estimates using 37 625 concomitant H and diameter measurements (n = 327 plots) and 1816 harvested trees (n = 21 plots) tropics-wide to answer the following questions: 1. For trees of known biomass (from destructive harvests) which H-model form and geographic scale (plot, region, and continent) most reduces biomass estimate uncertainty? 2. How much does including H relationship estimates derived in (1) reduce uncertainty in biomass estimates across 327 plots spanning four continents? 3. What effect does the inclusion of H in biomass estimates have on plot- and continental-scale forest biomass estimates? The mean relative error in biomass estimates of the destructively harvested trees was half (mean 0.06) when including H, compared to excluding H (mean 0.13). The power- and Weibull-H asymptotic model provided the greatest reduction in uncertainty, with the regional Weibull-H model preferred because it reduces uncertainty in smaller-diameter classes that contain the bulk of biomass per hectare in most forests. Propagating the relationships from destructively harvested tree biomass to each of the 327 plots from across the tropics shows errors are reduced from 41.8 Mg ha−1 (range 6.6 to 112.4) to 8.0 Mg ha−1 (−2.5 to 23.0) when including $H$. For all plots, above-ground live biomass was 52.2±17.3 Mg ha−1 lower when including H estimates (13%), with the greatest reductions in estimated biomass in Brazilian Shield forests and relatively no change in the Guyana Shield, central Africa and southeast Asia. We show fundamentally different stand structure across the four forested tropical continents, which affects biomass reductions due to $H$. African forests store a greater portion of total biomass in large-diameter trees and trees are on average larger in diameter. This contrasts to forests on all other continents where smaller-diameter trees contain the greatest fractions of total biomass. After accounting for variation in $H$, total biomass per hectare is greatest in Australia, the Guyana Shield, and Asia and lowest in W. Africa, W. Amazonia, and the Brazilian Shield (descending order). Thus, if closed canopy tropical forests span 1668 million km2 and store 285 Pg C, then the overestimate is 35 Pg C if H is ignored, and the sampled plots are an unbiased statistical representation of all tropical forest in terms of biomass and height factors. Our results show that tree $H$ is an important allometric factor that needs to be included in future forest biomass estimates to reduce error in estimates of pantropical carbon stocks and emissions due to deforestation.


2021 ◽  
Author(s):  
Anchi Wu ◽  
Xuli Tang ◽  
Andi Li ◽  
Xin Xiong ◽  
Juxiu Liu ◽  
...  

Abstract Forest ecosystems play an important role in regulating the global carbon, a substantial portion of terrestrial carbon pool which is stored in biomass stocks. However, how multiple biotic (i.e. topography) and abiotic (biodiversity, stand structure, and functional traits) influence forest biomass in natural forests, the relative important of these factors determine biomass is still controversial for subtropical natural forests. We used forest inventory data from nine 1-ha plots at different altitude gradients in China’s subtropical forests. We used multiple analyse to quantify the relative importance of multiple facets of diversity, key functional traits, stand structural attributes, and topography variables in determining forest biomass. We found that multiple facets of diversity and stand structure variables enhances biomass. Specifically, large-diameter trees had a strong positive effect on biomass and were the most important factor in determining biomass. Plant functional traits were closely related to biomass. Community-weighted mean value (CWM) of maximum height positively correlated with biomass, but CWM of wood density negatively correlated biomass. Topographic factors including elevation and slope, had a positive effect on biomass. Moreover, among the aforementioned four types of variables, stand structure had the greatest impact on biomass and is linked to diversity-biomass relationship. Topography mainly indirectly affected biomass by altering multiple diversity and stand structure. Functional traits also directly and indirectly affected biomass. Overall, these results support niche complementarity effect and mass-ratio hypothesis. Our results indicate that biodiversity is essential for maintaining ecosystem functions of species-rich subtropical natural forests. Further, adjusting stand structure may be an effective forest management approach to increase forest carbon storage.


2008 ◽  
Vol 159 (4) ◽  
pp. 80-90 ◽  
Author(s):  
Bogdan Brzeziecki ◽  
Feliks Eugeniusz Bernadzki

The results of a long-term study on the natural forest dynamics of two forest communities on one sample plot within the Białowieża National Park in Poland are presented. The two investigated forest communities consist of the Pino-Quercetum and the Tilio-Carpinetum type with the major tree species Pinus sylvestris, Picea abies, Betula sp., Quercus robur, Tilia cordata and Carpinus betulus. The results reveal strong temporal dynamics of both forest communities since 1936 in terms of tree species composition and of general stand structure. The four major tree species Scots pine, birch, English oak and Norway spruce, which were dominant until 1936, have gradually been replaced by lime and hornbeam. At the same time, the analysis of structural parameters indicates a strong trend towards a homogenization of the vertical stand structure. Possible causes for these dynamics may be changes in sylviculture, climate change and atmospheric deposition. Based on the altered tree species composition it can be concluded that a simple ≪copying≫ (mimicking) of the processes taking place in natural forests may not guarantee the conservation of the multifunctional character of the respective forests.


2012 ◽  
Vol 163 (6) ◽  
pp. 240-246 ◽  
Author(s):  
Thomas A. Nagel ◽  
Jurij Diaci ◽  
Dusan Rozenbergar ◽  
Tihomir Rugani ◽  
Dejan Firm

Old-growth forest reserves in Slovenia: the past, present, and future Slovenia has a small number of old-growth forest remnants, as well as many forest reserves approaching old-growth conditions. In this paper, we describe some of the basic characteristics of these old-growth remnants and the history of their protection in Slovenia. We then trace the long-term development of research in these old-growth remnants, with a focus on methodological changes. We also review some of the recent findings from old-growth research in Slovenia and discuss future research needs. The conceptual understanding of how these forests work has slowly evolved, from thinking of them in terms of stable systems to more dynamic and unpredictable ones due to the influence of natural disturbances and indirect human influences. In accordance with this thinking, the methods used to study old-growth forests have changed from descriptions of stand structure to studies that address natural processes and ecosystem functions.


2015 ◽  
Vol 8 (1) ◽  
pp. 272-275
Author(s):  
Lan Zhang ◽  
Dan Yu ◽  
Caihong Zhang ◽  
Weidong Zhang

Currently, the forest biomass energy development is at an initial stage and the estimation method for the forest biomass energy resource reserve is to be unified and refined although there is a great value and potential in the development and utilization of forest biomass energy in China. Based on the existing studies, the present paper analyzes the origins and types of forest biomass energy resources in the perspective of sustainable forestry management, constructs the estimation model using a bottom-up approach, and estimates the total existing forest biomass energy resource reserve in China based on the data of the 7th Forest Resource Survey. The estimation method and the calculation results provide the important theoretical ground for promoting the rational development of forest biomass energy in China.


Sign in / Sign up

Export Citation Format

Share Document