Sensitivity of composite floor system response at elevated temperatures to structural features

2014 ◽  
Vol 58 ◽  
pp. 115-128 ◽  
Author(s):  
Therese P. McAllister
Author(s):  
Armin Morasaei ◽  
Aria Ghabussi ◽  
Soheila Aghlmand ◽  
Maziar Yazdani ◽  
Shahrizan Baharom ◽  
...  

2014 ◽  
Vol 2014 ◽  
pp. 1-23 ◽  
Author(s):  
H. F. Wang ◽  
G. Chen

Support looseness fault is a type of common fault in aeroengine. Serious looseness fault would emerge under larger unbalanced force, which would cause excessive vibration and even lead to rubbing fault, so it is important to analyze and recognize looseness fault effectively. In this paper, based on certain type turbofan engine structural features, a rotor-support-casing whole model for certain type turbofan aeroengine is established. The rotor and casing systems are modeled by means of the finite element beam method; the support systems are modeled by lumped-mass model; the support looseness fault model is also introduced. The coupled system response is obtained by numerical integral method. In this paper, based on the casing acceleration signals, the impact characteristics of symmetrical stiffness and asymmetric stiffness models are analyzed, finding that the looseness fault would lead to the longitudinal asymmetrical characteristics of acceleration time domain wave and the multiple frequency characteristics, which is consistent with the real trial running vibration signals. Asymmetric stiffness looseness model is verified to be fit for aeroengine looseness fault model.


SPE Journal ◽  
2011 ◽  
Vol 17 (01) ◽  
pp. 11-19 ◽  
Author(s):  
Maura Puerto ◽  
George J. Hirasaki ◽  
Clarence A. Miller ◽  
Julian R. Barnes

Summary A systematic study was made of phase behavior of alkoxyglycidylether sulfonates (AGESs). These surfactants were screened with either NaCl-only brines or NaCl-only brines and n-octane at water/ oil ratio (WOR) ~1 for temperatures between approximately 85 and 120°C. All test cases were free of alcohols and other cosolvents. Classical Winsor phase behavior was observed in most scans, with optimal salinities ranging from less than 1% NaCl to more than 20% NaCl for AGESs with suitable combinations of hydrophobe and alkoxy chain type [ethylene oxide (EO) or propylene oxide (PO)] and chain length. Oil solubilization was high, indicating that ultralow interfacial tensions existed near optimal conditions. The test results for 120°C at WOR~1 have been summarized in a map, which might provide a useful guide for initial selection of such surfactants for EOR processes. Saline solutions of AGESs separate at elevated temperatures into two liquid phases (the cloud-point phenomenon), which may be problematic when they are injected into high-temperature reservoirs. An example is provided that indicates that this situation can be alleviated by blending suitable AGES and internal olefin sulfonate (IOS) surfactants. Synergy between the two types of surfactant resulted in transparent, single-phase aqueous solutions for some blends, but not for the individual surfactants, over a range of conditions including in synthetic seawater. Such blends are promising because both AGES and IOS surfactants have structural features that can be adjusted during manufacture to give a range of properties to suit reservoir conditions (temperature, salinity, and crude-oil type).


2021 ◽  
pp. 21-24
Author(s):  
M. B. Alikin ◽  
K. D. Alekseeva ◽  
D. A. Panfilov ◽  
N. A. Lavrov ◽  
I. M. Dvorko

The objects of research are oligomers-hardeners obtained by aminolysis of secondary polyethylene terephthalate (PET) and polycarbonate (PC) household waste with an aliphatic amine (PEP).The epoxy-diane resin of the ED-20 brand was chosen as the binder cured by the obtained oligomers due to its availability, good properties, acceptable viscosity, and wide applicability. The study of some parameters of the curing of thermosetting resin by industrial and synthesized hardeners is carried out.The gelation times at elevated temperatures (in the range from 50 to 100°C) and the activation energies of epoxy compositions were determined, and the conversion of epoxy groups during curing at room temperature was studied. The analysis of the obtained data showed that the structural features of macromolecules caused by the introduction of PET and PC fragments have a negligible effect on the activation energy and affect only when cured at room temperature and increase the viability of the compositions, while the gelation time at elevated temperatures in the case of all the studied hardeners is almost the same.


2014 ◽  
Vol 5 (2) ◽  
pp. 77-96 ◽  
Author(s):  
Anil Agarwal ◽  
Kristi Selden ◽  
Amit Varma

This paper presents a qualitative assessment of the influence of the composite floor system and shear-tab connections on the stability behavior of a typical mid-rise (10-story) steel building subjected to corner compartment fires. A ten-story steel building with composite floor systems was designed following the design practices in the US. The building had an interior core of reinforced concrete (RC) shear walls to resist the lateral loads. Effects of gravity loads and fire conditions were simulated using the finite element method and numerical analysis techniques. The concrete material model used in the numerical simulations was benchmarked using experimental data from concrete slab thermal tests. The results from the numerical investigations indicated that at elevated temperatures, the composite beam undergoes elongation, sagging and rotation at the beam ends. This results in additional rotation and compression demands on the connections at the ends. The shear-tab connections provided significant negative moment resistance at the beam ends at elevated temperatures. This negative moment resistance at the shear-tab connections increased the flexural capacity of the composite beam by effectively redistributing the moment demands due to the applied gravity loads.


2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Ina Remy-Speckmann ◽  
Thomas Bredow ◽  
Martin Lerch

Abstract Two new copper bismuth sulfide halides, CuBi2S3Cl and CuBi2S3Br, were synthesized by a two-step process of ball milling followed by annealing. Both compounds are obtained as dark grey powders and crystallize in the monoclinic space group C2/m with lattice parameters a = 12.9458(11) Å, b = 3.9845(3) Å, c = 9.1024(8) Å and β = 91.150(3)° for the sulfide chloride and a = 13.3498(8) Å, b = 4.1092(2) Å, c = 9.4173(6) Å and β = 90.322(4)° for the sulfide bromide. Also known for related compounds, the copper atoms are strongly disordered. Quantum-chemical calculations suggest that modelling the structure with fixed copper positions does not satisfactorily describe all structural features, which insinuates copper ion mobility at elevated temperatures.


2003 ◽  
Vol 56 (5) ◽  
pp. 357 ◽  
Author(s):  
Teresa M. Treweek ◽  
Amie M. Morris ◽  
John A. Carver

Molecular chaperones are a diverse group of proteins that interact with partially folded protein states to stabilize and prevent their mutual (illicit) association. Proteins require involvement with molecular chaperones throughout their lifespan: from their synthesis and folding through intracellular transport, membrane translocation, and to their ultimate degradation. Small heat-shock proteins (sHsps) are a ubiquitous family of molecular chaperones that are found in all organisms. Unlike many of the well-characterized chaperones, for example from the Hsp60 and Hsp70 families, sHsps are not involved in regulating protein folding. Instead, under conditions of cellular stress, such as elevated temperatures, they interact and stabilize partially folded target proteins to prevent their aggregation and precipitation. Because of this ability, their expression is elevated in many protein diseases that are characterized by protein aggregation and precipitation, including Alzheimer's, Creutzfeldt–Jakob, and Parkinson's diseases. The principal lens protein, α-crystallin, is a sHsp. Its chaperone ability is important in preventing lens protein precipitation and hence in maintaining lens transparency. This review summarizes the salient structural features of sHsps that enable them to act as highly efficient chaperones to prevent protein precipitation under stress conditions. The mechanism of chaperone action and the state of the target protein when interacting with sHsps are also discussed. Finally, diseases in which sHsp expression is elevated are discussed including the potential roles of sHsps and their therapeutic uses in the treatment of these diseases.


Author(s):  
Khaled Melghit

The old classical method for preparing inorganic materials is by the ceramic route or solid state reaction. It consists of mixing the starting materials at an elevated temperature. This method has been used for preparing numerous new materials until today. Three decades ago, the materials science community was aware of soft chemistry synthesis or chimie douce, especially with the emergence of nanotechnology field. Instead of the classical method, which involves high temperature, soft chemistry techniques use lower temperatures. In general, starting materials are dissolved in a liquid phase and different parameters such as pH, temperature and reaction time are adjusted in order to obtain the desired product. By using a lower temperature of preparation, the product obtained shows nanosize particles, with sizes lower than 100 nanometers. In contrast, the ceramic route (or solid state reaction) using higher temperatures leads to bigger particles size that are out of the nanosize range. Also, some interesting phases that are not stable at elevated temperatures (named metastable phases) and are not accessible by the classical method, are now prepared by the soft chemistry technique. Usually these metastable phases have interesting structural features and important physical properties. Adding to that, the product is obtained with a higher level of purity.   


Author(s):  
O.C. de Hodgins ◽  
K. R. Lawless ◽  
R. Anderson

Commercial polyimide films have shown to be homogeneous on a scale of 5 to 200 nm. The observation of Skybond (SKB) 705 and PI5878 was carried out by using a Philips 400, 120 KeV STEM. The objective was to elucidate the structural features of the polymeric samples. The specimens were spun and cured at stepped temperatures in an inert atmosphere and cooled slowly for eight hours. TEM micrographs showed heterogeneities (or nodular structures) generally on a scale of 100 nm for PI5878 and approximately 40 nm for SKB 705, present in large volume fractions of both specimens. See Figures 1 and 2. It is possible that the nodulus observed may be associated with surface effects and the structure of the polymers be regarded as random amorphous arrays. Diffraction patterns of the matrix and the nodular areas showed different amorphous ring patterns in both materials. The specimens were viewed in both bright and dark fields using a high resolution electron microscope which provided magnifications of 100,000X or more on the photographic plates if desired.


Author(s):  
D. F. Blake ◽  
L. F. Allard ◽  
D. R. Peacor

Echinodermata is a phylum of marine invertebrates which has been extant since Cambrian time (c.a. 500 m.y. before the present). Modern examples of echinoderms include sea urchins, sea stars, and sea lilies (crinoids). The endoskeletons of echinoderms are composed of plates or ossicles (Fig. 1) which are with few exceptions, porous, single crystals of high-magnesian calcite. Despite their single crystal nature, fracture surfaces do not exhibit the near-perfect {10.4} cleavage characteristic of inorganic calcite. This paradoxical mix of biogenic and inorganic features has prompted much recent work on echinoderm skeletal crystallography. Furthermore, fossil echinoderm hard parts comprise a volumetrically significant portion of some marine limestones sequences. The ultrastructural and microchemical characterization of modern skeletal material should lend insight into: 1). The nature of the biogenic processes involved, for example, the relationship of Mg heterogeneity to morphological and structural features in modern echinoderm material, and 2). The nature of the diagenetic changes undergone by their ancient, fossilized counterparts. In this study, high resolution TEM (HRTEM), high voltage TEM (HVTEM), and STEM microanalysis are used to characterize tha ultrastructural and microchemical composition of skeletal elements of the modern crinoid Neocrinus blakei.


Sign in / Sign up

Export Citation Format

Share Document