scholarly journals Deliquescence probability maps of Mars and key limiting factors using GCM model calculations

Icarus ◽  
2022 ◽  
pp. 114856
Author(s):  
Bernadett D. Pál ◽  
Ákos Kereszturi
Keyword(s):  
Limiting Factors ◽  
Model Calculations ◽  
Probability Maps

Effects of Ambipolar Diffusion on Prominence Thread Models

1994 ◽  
Vol 144 ◽  
pp. 315-321 ◽  
Author(s):  
M. G. Rovira ◽  
J. M. Fontenla ◽  
J.-C. Vial ◽  
P. Gouttebroze
Keyword(s):  
Energy Balance ◽  
Transition Region ◽  
Ambipolar Diffusion ◽  
Line Profiles ◽  
Balance Equations ◽  
Model Calculations ◽  
Partial Frequency ◽  
Frequency Redistribution ◽  
Partial Frequency Redistribution ◽  
Theoretical Structure

AbstractWe have improved previous model calculations of the prominence-corona transition region including the effect of the ambipolar diffusion in the statistical equilibrium and energy balance equations. We show its influence on the different parameters that characterize the resulting prominence theoretical structure. We take into account the effect of the partial frequency redistribution (PRD) in the line profiles and total intensities calculations.

Effects of sterilization modes on the mechanical strengths of plaster of paris implants

1989 ◽  
Vol 47 ◽  
pp. 890-891
Author(s):  
K. Cowden ◽  
B. Giammara ◽  
T. Devine ◽  
J. Hanker
Keyword(s):  
Gamma Radiation ◽  
Calcium Sulfate ◽  
Significant Loss ◽  
Potassium Sulfate ◽  
Limiting Factors ◽  
Radiation Sterilization ◽  
Plaster Of Paris ◽  
Hardness Tester ◽  
Dry Heat ◽  
Calcium Sulfate Hemihydrate

Plaster of Paris (calcium sulfate hemihydrate, CaSO4. ½ H2O) has been used as a biomedical implant material since 1892. One of the primary limiting factors of these implants is their mechanical properties. These materials have low compressive and tensile strengths when compared to normal bone. These are important limiting factors where large biomechanical forces exist. Previous work has suggested that sterilization techniques could affect the implant’s strength. A study of plaster of Paris implant mechanical and physical properties to find optimum sterilization techniques therefore, could lead to a significant increase in their application and promise for future use as hard tissue prosthetic materials.USG Medical Grade Calcium Sulfate Hemihydrate Types A, A-1 and B, were sterilized by dry heat and by gamma radiation. Types A and B were additionally sterilized with and without the setting agent potassium sulfate (K2SO4). The plaster mixtures were then moistened with a minimum amount of water and formed into disks (.339 in. diameter x .053 in. deep) in polyethylene molds with a microspatula. After drying, the disks were fractured with a Stokes Hardness Tester. The compressive strengths of the disks were obtained directly from the hardness tester. Values for the maximum tensile strengths σo were then calculated: where (P = applied compression, D = disk diameter, and t = disk thickness). Plaster disks (types A and B) that contained no setting agent showed a significant loss in strength with either dry heat or gamma radiation sterilization. Those that contained potassium sulfate (K2SO4) did not show a significant loss in strength with either sterilization technique. In all comparisons (with and without K2SO4 and with either dry heat or gamma radiation sterilization) the type B plaster had higher compressive and tensile strengths than that of the type A plaster. The type A-1 plaster however, which is specially modified for accelerated setting, was comparable to that of type B with K2SO4 in both compressive and tensile strength (Table 1).

Mosaic Mapping: A Means of Tiling Images to Shorten Acquisition Speed for Lower - Magnification SEM Images and Wavelength Dispersive Spectrometers (WDS) X-Ray Maps

1996 ◽  
Vol 54 ◽  
pp. 438-439
Author(s):  
J.D. Geller ◽  
C.R. Herrington
Keyword(s):  
Limiting Factors ◽  
X Rays ◽  
Angular Range ◽  
Acceptance Angle ◽  
Sem Images ◽  
Worst Case ◽  
X Ray ◽  
Focusing Distance ◽  
Layered Crystals ◽  
Working Distance

The minimum magnification for which an image can be acquired is determined by the design and implementation of the electron optical column and the scanning and display electronics. It is also a function of the working distance and, possibly, the accelerating voltage. For secondary and backscattered electron images there are usually no other limiting factors. However, for x-ray maps there are further considerations. The energy-dispersive x-ray spectrometers (EDS) have a much larger solid angle of detection that for WDS. They also do not suffer from Bragg’s Law focusing effects which limit the angular range and focusing distance from the diffracting crystal. In practical terms EDS maps can be acquired at the lowest magnification of the SEM, assuming the collimator does not cutoff the x-ray signal. For WDS the focusing properties of the crystal limits the angular range of acceptance of the incident x-radiation. The range is dependent upon the 2d spacing of the crystal, with the acceptance angle increasing with 2d spacing. The natural line width of the x-ray also plays a role. For the metal layered crystals used to diffract soft x-rays, such as Be - O, the minimum magnification is approximately 100X. In the worst case, for the LEF crystal which diffracts Ti - Zn, ˜1000X is the minimum.

Influence of stable iodine on the uptake of the thyroid – model vs. experiment

2001 ◽  
Vol 40 (01) ◽  
pp. 31-37 ◽  
Author(s):  
U. Wellner ◽  
E. Voth ◽  
H. Schicha ◽  
K. Weber
Keyword(s):  
Time Course ◽  
Compartment Model ◽  
The Body ◽  
Iodine Uptake ◽  
Model Calculations ◽  
Physiological Conditions ◽  
Iodine Supply ◽  
Predicted Values ◽  
The Individual ◽  
Stable Iodine

Summary Aim: The influence of physiological and pharmacological amounts of iodine on the uptake of radioiodine in the thyroid was examined in a 4-compartment model. This model allows equations to be derived describing the distribution of tracer iodine as a function of time. The aim of the study was to compare the predictions of the model with experimental data. Methods: Five euthyroid persons received stable iodine (200 μg, 10 mg). 1-123-uptake into the thyroid was measured with the Nal (Tl)-detector of a body counter under physiological conditions and after application of each dose of additional iodine. Actual measurements and predicted values were compared, taking into account the individual iodine supply as estimated from the thyroid uptake under physiological conditions and data from the literature. Results: Thyroid iodine uptake decreased from 80% under physiological conditions to 50% in individuals with very low iodine supply (15 μg/d) (n = 2). The uptake calculated from the model was 36%. Iodine uptake into the thyroid did not decrease in individuals with typical iodine supply, i.e. for Cologne 65-85 μg/d (n = 3). After application of 10 mg of stable iodine, uptake into the thyroid decreased in all individuals to about 5%, in accordance with the model calculations. Conclusion: Comparison of theoretical predictions with the measured values demonstrated that the model tested is well suited for describing the time course of iodine distribution and uptake within the body. It can now be used to study aspects of iodine metabolism relevant to the pharmacological administration of iodine which cannot be investigated experimentally in humans for ethical and technical reasons.

PERSPECTIVE DEVELOPMENT OF WORLD PRODUCTION OF FEEDS FOR AQUACULTURE: ALTERNATIVE SOURCES OF RAW MATERIALS

2017 ◽  
pp. 67-78
Author(s):  
Lina Yurievna Lagutkina
Keyword(s):  
Raw Materials ◽  
Limiting Factors ◽  
Current Status ◽  
Feed Production ◽  
The World ◽  
Market Trends ◽  
Alternative Sources ◽  
World Industry ◽  
First Time ◽  
A Current

The author of the article discloses the prospects of development of the world feed production for aquaculture based on the analysis of key innovative technological and market trends. The author specifies that shortage, high cost, low ecological compatibility of traditional raw materials - fish flour - are among major limiting factors in the development of production of feeds for aquaculture. This fact, in turn, limits sustainable development of aquaculture both in Russia, and in the world in general. The article presents the overview of a current status of the world industry of feed production in aquaculture, where the regional situation is studied, as well. For the first time, there is given the outlook of innovative technologies in feed production based on the alternative sources of protein (on the example of projects of leading aquabiotechnological companies) which will determine industry’s objectives for the mid-term perspective.

ASSESSMENT OF MAXIMUM INSTANT DISCHARGE OF VARIOUS FREQUENCY AT UNGAUGED MOUNTAINOUS RIVER KHEMCHIK (TUVA REPUBLIC) BASED ON MATHEMATICAL MODELLING

2019 ◽  
Vol 13 (2) ◽  
pp. 36-51 ◽  
Author(s):  
O. M. Makarieva ◽  
N. V. Nesterova ◽  
G. P. Yampolsky ◽  
E. Y. Kudymova
Keyword(s):  
Coniferous Forest ◽  
Frequency Interval ◽  
Time Step ◽  
Model Calculations ◽  
Runoff Formation ◽  
Emergency Situations ◽  
Daily Streamflow ◽  
Standard Methodology ◽  
Maximum Elevation ◽  
Daily Time Step

Abstract: the article presents the results of application of distributed deterministic hydrological model Hydrograph for estimation of maximum discharge values of different frequency at the ungauged catchment of the Khemchik River (Khemchik village, Tuva Republic). The catchment area is 1750 km2 , the average and maximum elevation — 2200 and 3600 m, respectively. Due to the lack of detailed information, a schematization of the catchment and the parameterization of the model are proposed, based on general ideas about the water balance and the processes of runoff formation of the main landscapes — rocky talus, coniferous forest and steppe. Parameters and algorithms are verified based on the results of streamflow modeling at two studied catchments: the Tapsy River — Kara-Khol (302 km2 ) and the Khemchik River — Iyme (25500 km2 ). Modelling of runoff formation processes with daily time step for the Khemchik River — Khemchik village was conducted for the period 1966–2012 using observational data at Teeli meteorological station. For the transition from daily to instant discharges, the dependence of the observed values of instant and daily streamflow at the studied gauges has been applied. On the basis of simulated discharge series, the frequency curve was built and the obtained curve was compared with the calculation data according to the standard methodology SP 33-101-2003 “Determination of the main calculated hydrological characteristics” using the analogue river. Simulated maximum instant discharges for entire frequency interval of up to 1% are 1.3–5 times higher than the values obtained by standard methodology SP 33-101-2003. The results of model calculations is indirectly confirmed by the evidences of regular flooding of the Khemchik village provided by the Ministry of Emergency Situations of the Tuva Republic, which is not predicted by the values obtained by the standard methods.

Селекция и семеноводство картофеля в Камчатском крае

2018 ◽  
Author(s):  
N.I. Ryakhovskaya ◽  
T.P. Sherstyukova ◽  
M.L. Gamolina
Keyword(s):  
Russian Federation ◽  
Potato Yield ◽  
The State ◽  
Limiting Factors ◽  
State Register ◽  
Region Selection ◽  
New Varieties ◽  
The Russian Federation ◽  
Selection Of

Рассмотрены агроклиматические условия Камчатского края и лимитирующие факторы, сдерживающие рост урожайности картофеля. Приведены характеристики новых сортов картофеля селекции Камчатского НИИСХ созданных в соответствии с приоритетными для региона направлениями селекции, включенных в Государственный реестр селекционных достижений РФ и охраняемых патентами.Agroclimatic conditions of the Kamchatka Krai and limiting factors that restrain the growth of potato yield are considered. The characteristics of new varieties of potatoes of the selection of the Kamchatsky RIA are created in accordance with the priority for the region selection areas included in the State Register of Selection Achievements of the Russian Federation and protected by patents.

Sign in / Sign up

Export Citation Format

Share Document