A note on the melting-point of paraffins and fatty acids

1938 ◽  
Vol 34 (3) ◽  
pp. 459-464 ◽  
Author(s):  
E. B. Moullin

The purpose of this note is to draw attention to a certain correspondence between the melting-points of normal paraffins and of fatty acids and to indicate a simple interpretation of this phenomenon. If the number of carbon atoms in a normal paraffin is plotted against the corresponding melting temperature, all the points in the diagram lie very close to a smooth curve drawn among them. If a similar diagram is made for the fatty acids, the points corresponding to an even number of carbon atoms lie on a curve of the same character as that found for paraffins. The points for an odd number of carbon atoms lie on a separate but similar curve, exemplifying the well-known alternation property.

1991 ◽  
Vol 69 (11) ◽  
pp. 2707-2711 ◽  
Author(s):  
Craig L. Frank

Ground squirrels are small herbivores that hibernate during winter. The ecological–nutritional limitations on hibernation are virtually unknown, but one constraint may be the melting point of stored fat. Lipids must be fluid to be metabolizable, and body temperatures maintained during hibernation are usually 30 °C below the melting point of typical mammalian fats. Fats containing greater amounts of unsaturated fatty acids, however, have correspondingly lower melting points. White adipose tissue was sampled from free-ranging Belding's ground squirrels, Spermophilus beldingi, during both the summer and fall. The lipids were twice as unsaturated as those of other rodent species, most of the increased unsaturation being due to the accumulation of plant-produced polyunsaturated fatty acids derived from the animals' diet. The melting points of S. beldingi fats were consequently 25 °C lower than those of other mammals. These results suggest that ground squirrels may depend upon their plant diet for the polyunsaturates necessary to produce the lipids with low melting points that are needed for hibernation.


1963 ◽  
Vol 41 (5) ◽  
pp. 1188-1196 ◽  
Author(s):  
M. R. Barr ◽  
B. A. Dunell ◽  
R. F. Grant

Nuclear magnetic resonance spectra and the infrared absorption between 700 and 750 cm−1 have been observed at temperatures near the melting points of the even-numbered fatty acids from C18 to C10. The results are interpreted as indicating breakdown of crystalline character and onset of liquid-like motion at scattered points in the solid structure several degrees below the melting point, and increasing in extent as the melting point is approached.


2020 ◽  
Vol 75 (05) ◽  
pp. 6265-2020
Author(s):  
BALJI Y. A. ◽  
ADILBEKOV J. SH. ◽  
WIŚNIEWSKI J. ◽  
BEŁKOT Z. ◽  
ANUSZ K.

The aim of the research was to develop a method for determining the species affinity of animal hair by determining its melting temperature. The research material was selected from hair samples of livestock and wild animals. We investigated 170 hairs of 16 animal species and humans. The hair melting point was determined by an automated system for melting temperature determination Opti Melt (MPA100). In the present study, we suggest that species affiliation can be effectively determined by examining physical properties of hair, in particular by determining its melting temperature. The hair melting temperatures for different animal species are in different ranges, but the initial melting points for hair of certain animal species are similar. For example, the initial melting point for cat, sheep, hare, rabbit, and rat hair ranged from 100 to 111 ° C, and the hair of the wolf, bear, and fox began to melt at 139.2 to 141.2 ° C. The results of this research make it possible to determine the species affinity of animals according to their hair melting temperature, which had not been done before. The proposed method yields rapid results and can be used as an auxiliary method in ambiguous cases in which data obtained by microscopic examination are insufficient. It will greatly facilitate the work of forensic specialists, enriching the arsenal of available methods.


1976 ◽  
Vol 49 (1) ◽  
pp. 170-178 ◽  
Author(s):  
G. Gianotti ◽  
A. Capizzi ◽  
L. Del Giudice

Abstract The thermodynamic parameters of fusion and crystallization kinetics of cis-polyoctenamer were investigated. We adopted the cryoscopic method based on the melting point decrease in the presence of diluents, using toluene as a diluent. It was also possible to determine the equilibrium melting temperature by extrapolating the “kinetic” melting points, measured on polymers crystallized at various temperatures. The dependence of ΔHu and Teq on the cis content allows evaluation of their values for all-cis-polyoctenamer. Conclusions about the elastomeric properties of the polymer are drawn.


2004 ◽  
Vol 44 (7) ◽  
pp. 663 ◽  
Author(s):  
R. K. Tume

Marbling refers to the appearance of white flecks of fatty tissue between muscle fibre bundles. The whiteness and opacity of the fat is important for visual assessment of marbling and depends on the crystallisation of the triacylglycerols within the fat cells. In the living animal, fat is in a liquid state. With chilling, the triacylglycerols undergo phase changes (solidify) and become opaque. The temperature at which this occurs is largely dependent upon the melting points of the individual fatty acids. Marbling fat can comprise a diverse range of fatty acids and each has an individual melting point (e.g. palmitoleic melts at 0°C; stearic melts at 70°C). The visual appearance of marbling will thus depend on the melting points of the constituent fatty acids at chiller temperature. The high melting point stearic acid can vary significantly in content across groups of cattle and has a major influence on the physical properties and visual appearance of marbling fat. The effects of nutrition, seasonal and climatic variation are reviewed and linked to marbling appearance and fat hardness.


2008 ◽  
Vol 580-582 ◽  
pp. 319-322 ◽  
Author(s):  
Manabu Tanaka ◽  
Kentaro Yamamoto ◽  
Tashiro Shinichi ◽  
John J. Lowke

Study of current attachment at thermionic cathode for TIG arc at atmospheric pressure is attempted from numerical calculations of arc-electrodes unified model. The calculations show that the maximum temperature of arc plasma close to the cathode tip for W-2% ThO2 reaches 19,000 K and it is the highest value in comparison with the other temperatures for W-2% La2O3 and W-2% CeO2, because the current attachment at the cathode tip is constricted by a centralized limitation of liquid area of ThO2 due to its higher melting point. The calculations also show that, in cases of W- 2% La2O3 and W-2% CeO2, the liquid areas of La2O3 and Ce2O3 are widely expanded at the cathode tip due to their lower melting points and then produce uniform current attachments at the cathode. It is concluded that the current attachment at thermionic cathode is strongly dependent on work function, melting point and Richardson constant of emitter materials.


2000 ◽  
Vol 13 (2) ◽  
pp. 185-214 ◽  
Author(s):  
Geoffrey Livesey

AbstractAlthough stearic acid is a saturated fatty acid, its influence on plasma cholesterol acid other health variables is neutral; possibly owing in part to poor absorption. Reduced absorption of stearic acid from particular triacylglycerols, cocoa butter and novel fats formulated with short- and long-chain acid triacylglycerol molecules (Salatrims) has been attributed to high intakes. However, the circumstances and causes of poor stearic acid digestion from triacylglycerols are unclear; published data were therefore collected and analysed, with emphasis on human studies. Of twenty-eight studies conducted in adults, most are in men (>90%). The assertion that reduced absorption is due to a high intake of stearoyl groups is not supported: dietary intakes of stearoyl of 0·05–0·65 g stearic acid equivalent/kg body weight (cf typical intake of 0·2 g stearic acid equivalent/kg body weight in the Western diet) indicate that the ‘true’ digestibility of stearoyl is 0·98 (SE 0·01) g/g, with apparent digestibility less than this value at low intakes owing to endogenous stearic acid excretion and to inter-publication variation of unidentified cause. The neutral health impact of stearic acid must be due to factors other than availability. Exceptions include cocoa butter, Salatrims and tristearin, for which digestibility is an additional factor. The efficiency with which human subjects digest stearoyl from cocoa butter still remains uncertain, while the digestion of total long-chain fat from this source is 0·89–0·95 g/g, high in comparison with 0·33 g/g for Salatrim 23CA and 0·15 g/g for tristearin in their prepared states. Salatrims contain the highest proportion of long-chain fatty acids that are stearic acid-rich other than tristearin, which is the main component of fully-hydrogenated soyabean and rapeseed oil. Analysis shows that apparent digestibility of stearic acid is associated with stearoyl density within the triacylglycerol molecule and that, in Salatrims, the occurrence of short-chain fatty acids in place of long-chain fatty acids increases this density. Soap formation appears not to be a major factor in the reduced digestion of stearic acid from tristearin under regular dietary circumstances, but both microcrystallinity and reduced digestibility of tri-, di- and monostearoylglycerols appears to be important. Solubilisation of high-melting-point tristearin in low-melting-point oils improves the digestibility of its stearic acid, particularly when emulsified or liquidized at above melting point. However, without such artificial aids, the digestive tracts of the rat, dog and man have a low capacity for emulsifying and digesting stearic acid from tristearin. Reduced digestibility of stearic acid from Salatrim 23CA also appears to be attributable to reduced digestibility of di- and monostearoylglycerols and is particularly due to remnants with the 1- or 3-stearoylglycerol intact after initial hydrolytic cleavage. Short-chain organic acid in Salatrim 23CA, which is readily hydrolysed, leaves such remnants. Unlike tristearin, Salatrim 23CA melts at body temperature and mixing it with low-melting-point oils is not expected to cause further disruption of microcrystalline structures to aid digestibility of its stearoyl groups. The low digestibility of stearoyl in Salatrim 23CA, together with the occurrence of short-chain organic acids in this product, account for its relatively low nutritional energy value (about 20 kJ (5 kcal)/g) compared with traditional fats (37 kJ (9 kcal)/g) and low fat value (<20:37 kJ/kJ; <5:9 kcal/kcal) relative to traditional fats. In part these differences are because of minor effects of Salatrim 23CA on the excretion of other fat and protein, due to the bulking properties of this poorly-digestible fat.


Author(s):  
KARINE CRISTINE KAUFMANN ◽  
ODINEI HESS GONÇALVES ◽  
EVANDRO BONA ◽  
FERNANDA VITÓRIA LEIMANN

Critical temperature indicators (CTI) find applications in food industry in cases when defrost may not occur or a specific temperature may not be reached, , indicating changes through visual changes, such as melting, color changes, etc. Lipid mixtures are promising candidates to formulate CTI since the final melting point of the mixture may be manipulated by the proportion of each lipid. In this work a lipid mixture consisting of stearic acid, lard and peanut oil was used to develop a CTI mixture. Simplex-lattice and Simplex-centroid experimental designs were compared to modelling the melting temperature of the lipid mixture. Addition of axial points to the experimental design improved predictive ability of the models while the inclusion of inverse terms was necessary to improve models accuracy. Simplex-lattice design presented an improved ability to predict the melting point of binary mixtures, while the simplex-centroid design resulted in an improved model for predicting melting point of the ternary mixtures


Author(s):  
Ke Xue ◽  
Shuyi Lv ◽  
Chunlei Zhu

Naturally-occurring saturated fatty acids (NSFAs) have emerged as a class of promising biomaterials due to their low cost, chemical stability, well-defined melting points, large heat of fusion, reversible solid-liquid phase...


2021 ◽  
Author(s):  
Shin-Pon Ju ◽  
Chen-Chun Li

Abstract The melting mechanism of single crystal and polycrystalline Nb 20.6 Mo 21.7 Ta 15.6 W 21.1 V 21.0 RHEAs was investigated by the molecular dynamics (MD) simulation using the 2NN MEAM potential. For the single crystal RHEA, the density profile displays an abrupt drop from 11.25 to 11.00 g/cm 3 at temperatures from 2910 to 2940 K, indicating all atoms begin significant local structural rearrangement. For polycrystalline RHEAs, a two-stage melting process is found. In the first melting stage, the melting of the grain boundary (GB) regions firstly occurs at the pre-melting temperature, which is relatively lower than the corresponding system-melting point. At the pre-melting temperature, most GB atoms have enough kinetic energies to leave their equilibrium positions, and then gradually induce the rearrangement of grain atoms close to GB. In the second melting stage at the melting point, most grain atoms have enough kinetic energies to rearrange, resulting in the chemical short-ranged order (CSRO) changes of all pairs.


Sign in / Sign up

Export Citation Format

Share Document