scholarly journals Discovering formation of ice 0 by low-frequency measurement data

2022 ◽  
Vol 962 (1) ◽  
pp. 012028
Author(s):  
A O Orlov ◽  
S V Tsyrenzhapov
Keyword(s):  
Phase Transition ◽  
Dielectric Permittivity ◽  
Measurement Data ◽  
Low Frequency ◽  
Supercooled Water ◽  
Frequency Measurement ◽  
Low Frequencies ◽  
Probing Signal ◽  
Electric Parameters ◽  
Silicate Materials

Abstract In this work, low-frequency characteristics of wetted nanoporous silicate materials were measured, as well as the specimen’s own low-frequency electric fluctuations at the frequencies of 1…100 Hz. The measurements at low frequencies were conducted at different voltages of the probing signal. A capacity cell was used in making the measurements. In the experiments, at the temperatures below –25…–30 °C, non-linearity of the medium was discovered. The experiments on the study of the specimen’s own electric fluctuations at these temperatures revealed their essential increase. These temperatures are below the point of phase transition of supercooled water to recently discovered ferroelectric ice 0. Based on the measurements made, a conclusion was made regarding formation of this modification of ice in the nanosize pores of the wetted materials under study. Ice 0 is a ferroelectric; therefore, its formation from deeply supercooled water may have a significant impact on the electric parameters of wetted bodies at the temperatures below –23 °C. At the interface of such ice with another dielectric, a thin layer with practically metallic conductivity emerges. Such a layer influences not only the non-linear dependence of dielectric permittivity on the electric field but also increases attenuation of electromagnetic radiation in a medium.

scholarly journals Very low-frequency IEPE accelerometer calibration and application to a wind energy structure

2021 ◽  
Author(s):  
Clemens Jonscher ◽  
Benedikt Hofmeister ◽  
Tanja Grießmann ◽  
Raimund Rolfes
Keyword(s):  
Measurement Data ◽  
Low Frequency ◽  
Calibration Procedure ◽  
Low Noise ◽  
Energy Structure ◽  
Frequency Range ◽  
Low Frequencies ◽  
Iir Filters ◽  
Very Low Frequency ◽  
Ac Response

Abstract. In this work, we present an experimental setup for very low-frequency calibration measurements of low-noise Integrated Electronics Piezo Electric (IEPE) accelerometers and a customised signal conditioner design for using IEPE sensor down to 0.05Hz. AC-response IEPE accelerometer and signal conditioners have amplitude and phase deviations at low frequencies. As the standard calibration procedure in the low-frequency range is technically challenging, IEPE accelerometers with standard signal conditioners are usually used in frequency ranges above 1 Hz. Vibrations on structures with low eigenfrequencies like wind turbines are thus often monitored using DC-coupled micro-electro-mechanical systems (MEMS) capacitive accelerometers. This sensor type suffers from higher noise levels compared to IEPE sensors. To apply IEPE sensors instead of MEMS sensors, in this work the calibration of the entire measurement chain of three different IEPE sensors with the customised signal conditioner is performed with a low-frequency centrifuge. The IEPE sensors are modelled using IIR filters to apply the calibration to time-domain measurement data of a wind turbine support structure. This procedure enables an amplitude and phase-accurate vibration analysis with IEPE sensors in the low-frequency range down to 0.05 Hz.

scholarly journals Causal gravitational waves as a probe of free streaming particles and the expansion of the Universe

2021 ◽  
Vol 2021 (2) ◽  
Author(s):  
Anson Hook ◽  
Gustavo Marques-Tavares ◽  
Davide Racco
Keyword(s):  
Phase Transition ◽  
Gravitational Waves ◽  
Gravity Waves ◽  
Wave Spectrum ◽  
Spectral Feature ◽  
Low Frequency ◽  
Low Frequencies ◽  
Expansion Of The Universe ◽  
The Difference ◽  
The Universe

Abstract The low frequency part of the gravitational wave spectrum generated by local physics, such as a phase transition or parametric resonance, is largely fixed by causality, offering a clean window into the early Universe. In this work, this low frequency end of the spectrum is analyzed with an emphasis on a physical understanding, such as the suppressed production of gravitational waves due to the excitation of an over-damped harmonic oscillator and their enhancement due to being frozen out while outside the horizon. Due to the difference between sub-horizon and super-horizon physics, it is inevitable that there will be a distinct spectral feature that could allow for the direct measurement of the conformal Hubble rate at which the phase transition occurred. As an example, free-streaming particles (such as the gravity waves themselves) present during the phase transition affect the production of super-horizon modes. This leads to a steeper decrease in the spectrum at low frequencies as compared to the well-known causal k3 super-horizon scaling of stochastic gravity waves. If a sizable fraction of the energy density is in free-streaming particles, they even lead to the appearance of oscillatory features in the spectrum. If the universe was not radiation dominated when the waves were generated, a similar feature also occurs at the transition between sub-horizon to super-horizon causality. These features are used to show surprising consequences, such as the fact that a period of matter domination following the production of gravity waves actually increases their power spectrum at low frequencies.

Preliminary Studies on the Dielectric Permittivity in the Isotropic and Mesophase of Cholesteryl Oleyl Carbonate

2002 ◽  
Vol 57 (3-4) ◽  
pp. 126-128 ◽  
Author(s):  
Sebastian Pawlus ◽  
Malgorzata Zasada ◽  
S. J. Rzoska
Keyword(s):  
Phase Transition ◽  
Dielectric Permittivity ◽  
Dielectric Spectroscopy ◽  
Low Frequency ◽  
Broad Temperature Range ◽  
Phase Detection ◽  
Temperature Range ◽  
Simple Detection

The phase detection in cholesteryl oleyl carbonate was studied over a broad temperature range by dielectric spectroscopy. Tests were conducted in the static and the low frequency ionic regions. They point to the possibility of relatively simple detection of phase transition. Some manifestations of pretransitional behaviours were also found. - Pacs: 64.70Md, 77.22Ch, 64.30+t

scholarly journals A phase-locked loop using ESO-based loop filter for grid-connected converter: performance analysis

2021 ◽  
Author(s):  
Baoling Guo ◽  
Seddik Bacha ◽  
Mazen Alamir ◽  
Julien Pouget
Keyword(s):  
Performance Analysis ◽  
Frequency Domain ◽  
Low Frequency ◽  
Experimental Tests ◽  
Frequency Measurement ◽  
Phase Locked Loop ◽  
Frequency Domain Analysis ◽  
Loop Filter ◽  
Control Stability ◽  
Unbalanced Grid

AbstractAn extended state observer (ESO)-based loop filter is designed for the phase-locked loop (PLL) involved in a disturbed grid-connected converter (GcC). This ESO-based design enhances the performances and robustness of the PLL, and, therefore, improves control performances of the disturbed GcCs. Besides, the ESO-based LF can be applied to PLLs with extra filters for abnormal grid conditions. The unbalanced grid is particularly taken into account for the performance analysis. A tuning approach based on the well-designed PI controller is discussed, which results in a fair comparison with conventional PI-type PLLs. The frequency domain properties are quantitatively analysed with respect to the control stability and the noises rejection. The frequency domain analysis and simulation results suggest that the performances of the generated ESO-based controllers are comparable to those of the PI control at low frequency, while have better ability to attenuate high-frequency measurement noises. The phase margin decreases slightly, but remains acceptable. Finally, experimental tests are conducted with a hybrid power hardware-in-the-loop benchmark, in which balanced/unbalanced cases are both explored. The obtained results prove the effectiveness of ESO-based PLLs when applied to the disturbed GcC.

scholarly journals Earless toads sense low frequencies but miss the high notes

2017 ◽  
Vol 284 (1864) ◽  
pp. 20171670 ◽  
Author(s):  
Molly C. Womack ◽  
Jakob Christensen-Dalsgaard ◽  
Luis A. Coloma ◽  
Juan C. Chaparro ◽  
Kim L. Hoke
Keyword(s):  
High Frequency ◽  
Species Differences ◽  
Low Frequency ◽  
Auditory Brainstem ◽  
Low Frequencies ◽  
Hearing Sensitivity ◽  
Sensory Pathways ◽  
Airborne Sound ◽  
Vibrational Sensitivity ◽  
Species Specific

Sensory losses or reductions are frequently attributed to relaxed selection. However, anuran species have lost tympanic middle ears many times, despite anurans' use of acoustic communication and the benefit of middle ears for hearing airborne sound. Here we determine whether pre-existing alternative sensory pathways enable anurans lacking tympanic middle ears (termed earless anurans) to hear airborne sound as well as eared species or to better sense vibrations in the environment. We used auditory brainstem recordings to compare hearing and vibrational sensitivity among 10 species (six eared, four earless) within the Neotropical true toad family (Bufonidae). We found that species lacking middle ears are less sensitive to high-frequency sounds, however, low-frequency hearing and vibrational sensitivity are equivalent between eared and earless species. Furthermore, extratympanic hearing sensitivity varies among earless species, highlighting potential species differences in extratympanic hearing mechanisms. We argue that ancestral bufonids may have sufficient extratympanic hearing and vibrational sensitivity such that earless lineages tolerated the loss of high frequency hearing sensitivity by adopting species-specific behavioural strategies to detect conspecifics, predators and prey.

A waveform inversion technique for measuring elastic wave attenuation in cylindrical bars

Geophysics ◽  
1992 ◽  
Vol 57 (6) ◽  
pp. 854-859 ◽  
Author(s):  
Xiao Ming Tang
Keyword(s):  
Elastic Wave ◽  
Wave Attenuation ◽  
Waveform Inversion ◽  
Finite Size ◽  
Low Frequency ◽  
Frequency Range ◽  
Multiple Reflections ◽  
Low Frequencies ◽  
The Time Domain ◽  
Attenuation Values

A new technique for measuring elastic wave attenuation in the frequency range of 10–150 kHz consists of measuring low‐frequency waveforms using two cylindrical bars of the same material but of different lengths. The attenuation is obtained through two steps. In the first, the waveform measured within the shorter bar is propagated to the length of the longer bar, and the distortion of the waveform due to the dispersion effect of the cylindrical waveguide is compensated. The second step is the inversion for the attenuation or Q of the bar material by minimizing the difference between the waveform propagated from the shorter bar and the waveform measured within the longer bar. The waveform inversion is performed in the time domain, and the waveforms can be appropriately truncated to avoid multiple reflections due to the finite size of the (shorter) sample, allowing attenuation to be measured at long wavelengths or low frequencies. The frequency range in which this technique operates fills the gap between the resonant bar measurement (∼10 kHz) and ultrasonic measurement (∼100–1000 kHz). By using the technique, attenuation values in a PVC (a highly attenuative) material and in Sierra White granite were measured in the frequency range of 40–140 kHz. The obtained attenuation values for the two materials are found to be reliable and consistent.

Methods to isolate retrograde and prograde Rayleigh-wave signals

2019 ◽  
Vol 219 (2) ◽  
pp. 975-994 ◽  
Author(s):  
Gabriel Gribler ◽  
T Dylan Mikesell
Keyword(s):  
Rayleigh Wave ◽  
Time Domain ◽  
Fundamental Mode ◽  
Poisson Ratio ◽  
Low Frequency ◽  
Wave Dispersion ◽  
Low Frequencies ◽  
Retrograde Motion ◽  
Mode Identification ◽  
Time Frequency

SUMMARY Estimating shear wave velocity with depth from Rayleigh-wave dispersion data is limited by the accuracy of fundamental and higher mode identification and characterization. In many cases, the fundamental mode signal propagates exclusively in retrograde motion, while higher modes propagate in prograde motion. It has previously been shown that differences in particle motion can be identified with multicomponent recordings and used to separate prograde from retrograde signals. Here we explore the domain of existence of prograde motion of the fundamental mode, arising from a combination of two conditions: (1) a shallow, high-impedance contrast and (2) a high Poisson ratio material. We present solutions to isolate fundamental and higher mode signals using multicomponent recordings. Previously, a time-domain polarity mute was used with limited success due to the overlap in the time domain of fundamental and higher mode signals at low frequencies. We present several new approaches to overcome this low-frequency obstacle, all of which utilize the different particle motions of retrograde and prograde signals. First, the Hilbert transform is used to phase shift one component by 90° prior to summation or subtraction of the other component. This enhances either retrograde or prograde motion and can increase the mode amplitude. Secondly, we present a new time–frequency domain polarity mute to separate retrograde and prograde signals. We demonstrate these methods with synthetic and field data to highlight the improvements to dispersion images and the resulting dispersion curve extraction.

scholarly journals Temperature Dependence of Electrical Properties and Crystal Structure of 0.29Pb(In1/2Nb1/2)O3–0.44Pb(Mg1/3Nb2/3)O3–0.27PbTiO3Single Crystals

2013 ◽  
Vol 2013 ◽  
pp. 1-5
Author(s):  
Qian Li ◽  
Yun Liu ◽  
Andrew Studer ◽  
Zhenrong Li ◽  
Ray Withers ◽  
...  
Keyword(s):  
Crystal Structure ◽  
Phase Transition ◽  
Electrical Properties ◽  
Dielectric Permittivity ◽  
Neutron Diffraction ◽  
Electrical Measurement ◽  
Temperature Dependent ◽  
Electromechanical Properties ◽  
Polar Order

We characterized the temperature dependent (~25–200°C) electromechanical properties and crystal structure of Pb(In1/2Nb1/2)O3-Pb(Mg1/3Nb2/3)O3-PbTiO3single crystals usingin situelectrical measurement and neutron diffraction techniques. The results show that the poled crystal experiences an addition phase transition around 120°C whereas such a transition is absent in the unpoled crystal. It is also found that the polar order persists above the maximum dielectric permittivity temperature at which the crystal shows a well-defined antiferroelectric behavior. The changes in the electrical properties and underlying crystal structure are discussed in the paper.

Sign in / Sign up

Export Citation Format

Share Document