scholarly journals Process Parameter Identification in Thin Film Flows Driven by a Stretching Surface

2014 ◽  
Vol 2014 ◽  
pp. 1-12 ◽  
Author(s):  
Satyananda Panda ◽  
Mathieu Sellier ◽  
M. C. S. Fernando ◽  
M. K. Abeyratne

The flow of a thin liquid film over a heated stretching surface is considered in this study. Due to a potential nonuniform temperature distribution on the stretching sheet, a temperature gradient occurs in the fluid which produces surface tension gradient at the free surface of the thin film. As a result, the free surface deforms and these deformations are advected by the flow in the stretching direction. This work focuses on the inverse problem of reconstructing the sheet temperature distribution and the sheet stretch rate from observed free surface variations. This work builds on the analysis of Santra and Dandapat (2009) who, based on the long-wave expansion of the Navier-Stokes equations, formulate a partial differential equation which describes the evolution of the thickness of a film over a nonisothermal stretched surface. In this work, we show that after algebraic manipulation of a discrete form of the governing equations, it is possible to reconstruct either the unknown temperature field on the sheet and hence the resulting heat transfer or the stretching rate of the underlying surface. We illustrate the proposed methodology and test its applicability on a range of test problems.

Fluids ◽  
2019 ◽  
Vol 4 (4) ◽  
pp. 198
Author(s):  
Mohammad Irshad Khodabocus ◽  
Mathieu Sellier ◽  
Volker Nock

The evolution of a thin liquid film subject to a volatile solvent source and an air-blow effect which modifies locally the surface tension and leads to Marangoni-induced flow is shown to be governed by a degenerate fourth order nonlinear parabolic h-evolution equation of the type given by ∂ t h = − div x M 1 h ∂ x 3 h + M 2 h ∂ x h + M 3 h , where the mobility terms M 1 h and M 2 h result from the presence of the source and M 3 h results from the air-blow effect. Various authors assume M 2 h ≈ 0 and exclude the air-blow effect into M 3 h . In this paper, the authors show that such assumption is not necessarily correct, and the inclusion of such effect does disturb the dynamics of the thin film. These emphasize the importance of the full definition t → · grad γ = grad x γ + ∂ x h grad y γ of the surface tension gradient at the free surface in contrast to the truncated expression t → · grad γ ≈ grad x γ employed by those authors and the effect of the air-blow flowing over the surface.


Author(s):  
B. Elie ◽  
G. Reliquet ◽  
P.-E. Guillerm ◽  
O. Thilleul ◽  
P. Ferrant ◽  
...  

This paper compares numerical and experimental results in the study of the resonance phenomenon which appears between two side-by-side fixed barges for different sea-states. Simulations were performed using SWENSE (Spectral Wave Explicit Navier-Stokes Equations) approach and results are compared with experimental data on two fixed barges with different headings and bilges. Numerical results, obtained using the SWENSE approach, are able to predict both the frequency and the magnitude of the RAO functions.


2021 ◽  
Vol 153 (A2) ◽  
Author(s):  
Q Yang ◽  
W Qiu

Slamming forces on 2D and 3D bodies have been computed based on a CIP method. The highly nonlinear water entry problem governed by the Navier-Stokes equations was solved by a CIP based finite difference method on a fixed Cartesian grid. In the computation, a compact upwind scheme was employed for the advection calculations and a pressure-based algorithm was applied to treat the multiple phases. The free surface and the body boundaries were captured using density functions. For the pressure calculation, a Poisson-type equation was solved at each time step by the conjugate gradient iterative method. Validation studies were carried out for 2D wedges with various deadrise angles ranging from 0 to 60 degrees at constant vertical velocity. In the cases of wedges with small deadrise angles, the compressibility of air between the bottom of the wedge and the free surface was modelled. Studies were also extended to 3D bodies, such as a sphere, a cylinder and a catamaran, entering calm water. Computed pressures, free surface elevations and hydrodynamic forces were compared with experimental data and the numerical solutions by other methods.


1994 ◽  
Vol 61 (3) ◽  
pp. 629-633 ◽  
Author(s):  
S. H. Smith

When a stretching surface is moved quickly, for a short period of time, a pulse is transmitted to the surrounding fluid. Here we describe an exact solution in terms of a similarity variable for the Navier-Stokes equations which represents the effect of this pulse for two-dimensional flow. The unusual feature is that this solution is only valid for a limited range of the Reynolds number; outside this domain unbounded velocities result.


2021 ◽  
Vol 3 (10) ◽  
Author(s):  
Anna Samoilova ◽  
Alexander Nepomnyashchy

Abstract A novel type of Marangoni convection was predicted theoretically a decade ago. The thin liquid film atop a substrate of low thermal conductivity was considered. In the case of heating from below, the Marangoni convection emerges not only in a conventional stationary regime, but also as oscillatory flows. Specifically, the oscillatory Marangoni convection emerges if (1) the heat flux from the free surface is small, and (2) the large-scale deformation of the free surface is allowed. During the past decade, this novel Marangoni convection was detected and investigated in several other theoretical works. The review discusses the recent achievements in studying the oscillatory Marangoni convection in a thin film heated from below. The guiding data for observation of the oscillatory regime are also provided.


2019 ◽  
Vol 872 ◽  
pp. 407-437 ◽  
Author(s):  
M. Muradoglu ◽  
F. Romanò ◽  
H. Fujioka ◽  
J. B. Grotberg

Surfactant-laden liquid plug propagation and rupture occurring in lower lung airways are studied computationally using a front-tracking method. The plug is driven by an applied constant pressure in a rigid axisymmetric tube whose inner surface is coated by a thin liquid film. The evolution equations of the interfacial and bulk surfactant concentrations coupled with the incompressible Navier–Stokes equations are solved in the front-tracking framework. The numerical method is first validated for a surfactant-free case and the results are found to be in good agreement with the earlier simulations of Fujioka et al. (Phys. Fluids, vol. 20, 2008, 062104) and Hassan et al. (Intl J. Numer. Meth. Fluids, vol. 67, 2011, pp. 1373–1392). Then extensive simulations are performed to investigate the effects of surfactant on the mechanical stresses that could be injurious to epithelial cells, such as pressure and shear stress. It is found that the liquid plug ruptures violently to induce large pressure and shear stress on airway walls and even a tiny amount of surfactant significantly reduces the pressure and shear stress and thus improves cell survivability. However, addition of surfactant also delays the plug rupture and thus airway reopening.


1999 ◽  
Vol 396 ◽  
pp. 37-71 ◽  
Author(s):  
LEONID BREVDO ◽  
PATRICE LAURE ◽  
FREDERIC DIAS ◽  
THOMAS J. BRIDGES

The film flow down an inclined plane has several features that make it an interesting prototype for studying transition in a shear flow: the basic parallel state is an exact explicit solution of the Navier–Stokes equations; the experimentally observed transition of this flow shows many properties in common with boundary-layer transition; and it has a free surface, leading to more than one class of modes. In this paper, unstable wavepackets – associated with the full Navier–Stokes equations with viscous free-surface boundary conditions – are analysed by using the formalism of absolute and convective instabilities based on the exact Briggs collision criterion for multiple k-roots of D(k, ω) = 0; where k is a wavenumber, ω is a frequency and D(k, ω) is the dispersion relation function.The main results of this paper are threefold. First, we work with the full Navier–Stokes equations with viscous free-surface boundary conditions, rather than a model partial differential equation, and, guided by experiments, explore a large region of the parameter space to see if absolute instability – as predicted by some model equations – is possible. Secondly, our numerical results find only convective instability, in complete agreement with experiments. Thirdly, we find a curious saddle-point bifurcation which affects dramatically the interpretation of the convective instability. This is the first finding of this type of bifurcation in a fluids problem and it may have implications for the analysis of wavepackets in other flows, in particular for three-dimensional instabilities. The numerical results of the wavepacket analysis compare well with the available experimental data, confirming the importance of convective instability for this problem.The numerical results on the position of a dominant saddle point obtained by using the exact collision criterion are also compared to the results based on a steepest-descent method coupled with a continuation procedure for tracking convective instability that until now was considered as reliable. While for two-dimensional instabilities a numerical implementation of the collision criterion is readily available, the only existing numerical procedure for studying three-dimensional wavepackets is based on the tracking technique. For the present flow, the comparison shows a failure of the tracking treatment to recover a subinterval of the interval of unstable ray velocities V whose length constitutes 29% of the length of the entire unstable interval of V. The failure occurs due to a bifurcation of the saddle point, where V is a bifurcation parameter. We argue that this bifurcation of unstable ray velocities should be observable in experiments because of the abrupt increase by a factor of about 5.3 of the wavelength across the wavepacket associated with the appearance of the bifurcating branch. Further implications for experiments including the effect on spatial amplification rate are also discussed.


2015 ◽  
Vol 1105 ◽  
pp. 105-109 ◽  
Author(s):  
Varvara Yu. Gordeeva ◽  
Andrey V. Lyushnin

Evaporation of a thin layer of a polar liquid (water) having a free surface and located on a solid substrate is investigated. A surfactant is solved in the liquid film. The surface tension is a linear function of the surface concentration of the surfactant. The surface energy of the solid-liquid interface is a nonmonotonic function of the layer thickness and is the sum of the Van der Waals interaction and the specific interaction of the double electric layer on the interface. The effect of the solvable surfactant on the dynamics of the propagation of the evaporation front in the thin liquid film is analyzed in the long-wave approximation in the system of Navier-Stokes equations.


Author(s):  
Iraj Saeedpanah ◽  
M. Shayanfar ◽  
E. Jabbari ◽  
Mohammad Haji Mohammadi

Free surface flows are frequently encountered in hydraulic engineering problems including water jets, weirs and around gates. An iterative solution to the incompressible two-dimensional vertical steady Navier-Stokes equations, comprising momentum and continuity equations, is used to solve for the priori unknown free surface, the velocity and the pressure fields. The entire water body is covered by a unstructured finite element grid which is locally refined. The dynamic boundary condition is imposed for the free surface where the pressure vanishes. This procedure is done continuously until the normal velocities components vanish. To overcome numerical errors and oscillations encountering in convection terms, the SUPG (streamline upwinding Petrov-Galerkin) method is applied. The solution method is tested for different discharges onto a standard spillway geometries. The results shows good agreement with available experimental data.


Sign in / Sign up

Export Citation Format

Share Document