scholarly journals Cocoa butter equivalent from Kpangnan butter and Pequi oil

Author(s):  
Saeed Mirzaee Ghazani ◽  
Andrea Madalena Guedes ◽  
Rosemar Antoniassi ◽  
Alejandro Marangoni

Novel cocoa butter equivalents were designed using dry fractionated Pequi oil and solvent fractionated Kpangnan butter. Static crystallization of binary mixtures of these two fractions into the triclinic form (β2) was achieved after 12 days for all mixtures and after 4 days for the 80:20 w/w and 90:10 w/w fractionated Kpangnan:Pequi oil mixtures. Moreover, after 60 days of storage at 22oC, all binary blends (except 100% fractionated pequi oil and 100% fractionated Kpangnan butter) were crystallized in the most stable triclinic crystal form (β1). Here we also discovered an unusual melting behavior for the fractionaled 30:70 w/w and 20:80 w/w fractionated Kpangnan:Pequi oil mixtures, where after 4 days of static crystallization at room 22oC, these mixtures displayed higher than predicted melting points, 41.89 oC and 33.32 oC, respectively. This suggested a faster kinetics of transformation to the triclinic β2 form for those mixtures. Our results suggest that the 30:70 w/w fractionated Kpangnan:Pequi oil mixture with a melting point of 34oC after 60 days storage at 22oC, a stable triclinic β2 form, and a triglyceride composition of 28% POP, 4.6% POS and 33% SOS displayed solid state characteristics, melting point and crystal structure, of a commercial cocoa butter equivalent.

1976 ◽  
Vol 49 (1) ◽  
pp. 170-178 ◽  
Author(s):  
G. Gianotti ◽  
A. Capizzi ◽  
L. Del Giudice

Abstract The thermodynamic parameters of fusion and crystallization kinetics of cis-polyoctenamer were investigated. We adopted the cryoscopic method based on the melting point decrease in the presence of diluents, using toluene as a diluent. It was also possible to determine the equilibrium melting temperature by extrapolating the “kinetic” melting points, measured on polymers crystallized at various temperatures. The dependence of ΔHu and Teq on the cis content allows evaluation of their values for all-cis-polyoctenamer. Conclusions about the elastomeric properties of the polymer are drawn.


2010 ◽  
Vol 72 ◽  
pp. 46-52 ◽  
Author(s):  
Laurent Royer ◽  
Stéphane Mathieu ◽  
Christophe Liebaut ◽  
Pierre Steinmetz

For energy production and also for the glass industry, finding new refractory alloys which could permit to increase the process temperatures to 1200°C or more is a permanent challenge. Chromium base alloys can be good candidates, considering the melting point of Cr itself, and also its low corrosion rate in molten glass. Two families of alloys have been studied for this purpose, Cr-Mo-W and Cr-Ta-X alloys (X= Mo, Si..). A finer selection of compositions has been done, to optimize their chemical and mechanical properties. Kinetics of HT oxidation by air, of corrosion by molten glass and also creep properties of several alloys have been measured up to 1250°C. The results obtained with the best alloys (Cr-Ta base) give positive indications as regards the possibility of their industrial use.


1995 ◽  
Vol 398 ◽  
Author(s):  
Joshua W. Kriesel ◽  
Susanne M. Lee

ABSTRACTUsing rf sputtering and post-deposition annealing in a differential scanning calorimeter (DSC), we manufactured bulk (4000 nm) films of crystalline Ge0.83Sn0.17. This Sn concentration is much greater than the solid solubility limit of Sn in Ge (x ≤ 0.01). Continued annealing thermally induces Sn phase separation from the alloy, limiting the ultimate attainable grain size in the metastable crystals. We examine, here, the mechanisms and kinetics of the processes limiting the size of the Ge0.83Sn0.17 polycrystals. From a combination of DSC, electron microprobe, and x-ray diffraction (XRD) measurements, we propose phase transformation mechanisms corresponding to crystallization of amorphous Ge0.83Sn0.17, crystallization of an as-yet unidentified phase of Sn, and phase separation of Sn from the Ge1-xSnx crystals. We were unable to observe the unidentified phase of Sn in XRD, but the phase must be present in the material to account for the quantitative discrepancies (as much as 8 at.%) in Sn percentages determined from each of the DSC, XRD, and electron microprobe measurements. Our models for the various transformation kinetics were corroborated by the subsequent phase-separated Sn melting behavior observed in the DSC: two Sn melting endotherms, one of which was 20–100°C lower than the bulk melting temperature of Sn. This depressed temperature endotherm we speculate represents liquefaction of nanometer-sized (β–Sn clusters.


2008 ◽  
Vol 580-582 ◽  
pp. 319-322 ◽  
Author(s):  
Manabu Tanaka ◽  
Kentaro Yamamoto ◽  
Tashiro Shinichi ◽  
John J. Lowke

Study of current attachment at thermionic cathode for TIG arc at atmospheric pressure is attempted from numerical calculations of arc-electrodes unified model. The calculations show that the maximum temperature of arc plasma close to the cathode tip for W-2% ThO2 reaches 19,000 K and it is the highest value in comparison with the other temperatures for W-2% La2O3 and W-2% CeO2, because the current attachment at the cathode tip is constricted by a centralized limitation of liquid area of ThO2 due to its higher melting point. The calculations also show that, in cases of W- 2% La2O3 and W-2% CeO2, the liquid areas of La2O3 and Ce2O3 are widely expanded at the cathode tip due to their lower melting points and then produce uniform current attachments at the cathode. It is concluded that the current attachment at thermionic cathode is strongly dependent on work function, melting point and Richardson constant of emitter materials.


2000 ◽  
Vol 13 (2) ◽  
pp. 185-214 ◽  
Author(s):  
Geoffrey Livesey

AbstractAlthough stearic acid is a saturated fatty acid, its influence on plasma cholesterol acid other health variables is neutral; possibly owing in part to poor absorption. Reduced absorption of stearic acid from particular triacylglycerols, cocoa butter and novel fats formulated with short- and long-chain acid triacylglycerol molecules (Salatrims) has been attributed to high intakes. However, the circumstances and causes of poor stearic acid digestion from triacylglycerols are unclear; published data were therefore collected and analysed, with emphasis on human studies. Of twenty-eight studies conducted in adults, most are in men (>90%). The assertion that reduced absorption is due to a high intake of stearoyl groups is not supported: dietary intakes of stearoyl of 0·05–0·65 g stearic acid equivalent/kg body weight (cf typical intake of 0·2 g stearic acid equivalent/kg body weight in the Western diet) indicate that the ‘true’ digestibility of stearoyl is 0·98 (SE 0·01) g/g, with apparent digestibility less than this value at low intakes owing to endogenous stearic acid excretion and to inter-publication variation of unidentified cause. The neutral health impact of stearic acid must be due to factors other than availability. Exceptions include cocoa butter, Salatrims and tristearin, for which digestibility is an additional factor. The efficiency with which human subjects digest stearoyl from cocoa butter still remains uncertain, while the digestion of total long-chain fat from this source is 0·89–0·95 g/g, high in comparison with 0·33 g/g for Salatrim 23CA and 0·15 g/g for tristearin in their prepared states. Salatrims contain the highest proportion of long-chain fatty acids that are stearic acid-rich other than tristearin, which is the main component of fully-hydrogenated soyabean and rapeseed oil. Analysis shows that apparent digestibility of stearic acid is associated with stearoyl density within the triacylglycerol molecule and that, in Salatrims, the occurrence of short-chain fatty acids in place of long-chain fatty acids increases this density. Soap formation appears not to be a major factor in the reduced digestion of stearic acid from tristearin under regular dietary circumstances, but both microcrystallinity and reduced digestibility of tri-, di- and monostearoylglycerols appears to be important. Solubilisation of high-melting-point tristearin in low-melting-point oils improves the digestibility of its stearic acid, particularly when emulsified or liquidized at above melting point. However, without such artificial aids, the digestive tracts of the rat, dog and man have a low capacity for emulsifying and digesting stearic acid from tristearin. Reduced digestibility of stearic acid from Salatrim 23CA also appears to be attributable to reduced digestibility of di- and monostearoylglycerols and is particularly due to remnants with the 1- or 3-stearoylglycerol intact after initial hydrolytic cleavage. Short-chain organic acid in Salatrim 23CA, which is readily hydrolysed, leaves such remnants. Unlike tristearin, Salatrim 23CA melts at body temperature and mixing it with low-melting-point oils is not expected to cause further disruption of microcrystalline structures to aid digestibility of its stearoyl groups. The low digestibility of stearoyl in Salatrim 23CA, together with the occurrence of short-chain organic acids in this product, account for its relatively low nutritional energy value (about 20 kJ (5 kcal)/g) compared with traditional fats (37 kJ (9 kcal)/g) and low fat value (<20:37 kJ/kJ; <5:9 kcal/kcal) relative to traditional fats. In part these differences are because of minor effects of Salatrim 23CA on the excretion of other fat and protein, due to the bulking properties of this poorly-digestible fat.


2004 ◽  
Vol 87 (5) ◽  
pp. 1153-1163 ◽  
Author(s):  
Manuela Buchgraber ◽  
Chiara Senaldi ◽  
Franz Ulberth ◽  
Elke Anklam

Abstract The development and in-house testing of a method for the detection and quantification of cocoa butter equivalents in cocoa butter and plain chocolate is described. A database consisting of the triacylglycerol profile of 74 genuine cocoa butter and 75 cocoa butter equivalent samples obtained by high-resolution capillary gas liquid chromatography was created, using a certified cocoa butter reference material (IRMM-801) for calibration purposes. Based on these data, a large number of cocoa butter/cocoa butter equivalent mixtures were arithmetically simulated. By subjecting the data set to various statistical tools, reliable models for both detection (univariate regression model) and quantification (multivariate model) were elaborated. Validation data sets consisting of a large number of samples (n = 4050 for detection, n = 1050 for quantification) were used to test the models. Excluding pure illipé fat samples from the data set, the detection limit was determined between 1 and 3% foreign fat in cocoa butter. Recalculated for a chocolate with a fat content of 30%, these figures are equal to 0.3–0.9% cocoa butter equivalent. For quantification, the average error for prediction was estimated to be 1.1% cocoa butter equivalent in cocoa butter, without prior knowledge of the materials used in the blend corresponding to 0.3% in chocolate (fat content 30%). The advantage of the approach is that by using IRMM-801 for calibration, the established mathematical decision rules can be transferred to every testing laboratory.


2016 ◽  
Vol 78 (6-12) ◽  
Author(s):  
Reiza Mutia ◽  
Dayang Norulfairuz Abang Zaidel ◽  
Ida Idayu Muhamad

The study to find cocoa butter equivalent (CBE) as an alternative to cocoa butter (CB) from available and low cost commercial oils or fats has been increased recently. Current study investigates the blending of hard palm oil mid-fraction (PMF) with canola oil to produce high nutritional CBE using immobilized lipase from Rhizomucor miehei. The experiments were designed using Response Surface Methodology (RSM) to optimize the percentage of saturated-unsaturated-saturated (StUSt) triacylglycerols (TAGs). The experiment was performed at hard PMF concentration of 50 to 90% (w/w), lipozyme load between 5% and 10% (based on the weight of substrate) with a reaction time between 2 to 14 hours. The best reaction conditions to attain this target was 89.35% (w/w) of hard PMF concentration, 2 hours of reaction time, and 5% (based on the weight of substrate) of lipozyme load, resulting CBE which contains 64.44±1.18% of StUSt. The addition of canola oil improved the nutritional value of CBE which was marked by the higher percentage of linoleic acid (omega-6, 4.53±0.06%) and linolenic acid (omega-3, 0.74±0.14%) in CBE than CB (omega-6, 2.68±0.34%). Enzymatic interesterification was not altering fatty acid content in the CBE, especially linoleic acid (omega-6) and linolenic acid (omega-3) which was characterized by no significant difference (p > 0.05) between the fatty acid profile of initial mixture (before interesterification) and CBE (after interesterification).


Sign in / Sign up

Export Citation Format

Share Document