scholarly journals Micro- and macroscopic simulation of periodic metamaterials

2008 ◽  
Vol 6 ◽  
pp. 77-82 ◽  
Author(s):  
R. Schuhmann ◽  
B. Bandlow ◽  
G. Lubkowski ◽  
T. Weiland

Abstract. In order to characterize three-dimensional, left-handed metamaterials (LHM) we use electromagnetic field simulations of unit cells. For waves traveling in one of the main directions of the periodic LHM-arrays, the analysis is concentrated on the calculation of global quantities of the unit cells, such as scattering parameters or dispersion diagrams, and a careful interpretation of the results. We show that the concept of equivalent material values – which may be negative in a narrow frequency range – can be validated by large "global" simulations of a wedge structure. We also discuss the limitations of this concept, since in some cases the macroscopic behavior of an LHM cannot be accurately described by equivalent material values.

Author(s):  
М.Р. Литвинов ◽  
А.С. Спиридонова ◽  
Р.В. Литвинов ◽  
Д.А. Конкин

The dispersion of the propagation constants of TE2-modes in a thin left-handed film on a substrate with the Kerr effect has been considered in a narrow frequency range near the zero of a group velocity of the mode. It is shown that such dispersion can be controlled by varying the intensity of the light field with a change in frequency. The conditions, under which the propagation constants remain constant when the frequency changes, have been determined. Soliton-like wave packets have been considered.


Author(s):  
A. F. Marshall ◽  
J. W. Steeds ◽  
D. Bouchet ◽  
S. L. Shinde ◽  
R. G. Walmsley

Convergent beam electron diffraction is a powerful technique for determining the crystal structure of a material in TEM. In this paper we have applied it to the study of the intermetallic phases in the Cu-rich end of the Cu-Zr system. These phases are highly ordered. Their composition and structure has been previously studied by microprobe and x-ray diffraction with sometimes conflicting results.The crystalline phases were obtained by annealing amorphous sputter-deposited Cu-Zr. Specimens were thinned for TEM by ion milling and observed in a Philips EM 400. Due to the large unit cells involved, a small convergence angle of diffraction was used; however, the three-dimensional lattice and symmetry information of convergent beam microdiffraction patterns is still present. The results are as follows:1) 21 at% Zr in Cu: annealed at 500°C for 5 hours. An intermetallic phase, Cu3.6Zr (21.7% Zr), space group P6/m has been proposed near this composition (2). The major phase of our annealed material was hexagonal with a point group determined as 6/m.


Author(s):  
Joachim Frank

Cryo-electron microscopy combined with single-particle reconstruction techniques has allowed us to form a three-dimensional image of the Escherichia coli ribosome.In the interior, we observe strong density variations which may be attributed to the difference in scattering density between ribosomal RNA (rRNA) and protein. This identification can only be tentative, and lacks quantitation at this stage, because of the nature of image formation by bright field phase contrast. Apart from limiting the resolution, the contrast transfer function acts as a high-pass filter which produces edge enhancement effects that can explain at least part of the observed variations. As a step toward a more quantitative analysis, it is necessary to correct the transfer function in the low-spatial-frequency range. Unfortunately, it is in that range where Fourier components unrelated to elastic bright-field imaging are found, and a Wiener-filter type restoration would lead to incorrect results. Depending upon the thickness of the ice layer, a varying contribution to the Fourier components in the low-spatial-frequency range originates from an “inelastic dark field” image. The only prospect to obtain quantitatively interpretable images (i.e., which would allow discrimination between rRNA and protein by application of a density threshold set to the average RNA scattering density may therefore lie in the use of energy-filtering microscopes.


2021 ◽  
pp. 152808372110013
Author(s):  
Vivek R Jayan ◽  
Lekhani Tripathi ◽  
Promoda Kumar Behera ◽  
Michal Petru ◽  
BK Behera

The internal geometry of composite material is one of the most important factors that influence its performance and service life. A new approach is proposed for the prediction of internal geometry and tensile behavior of the 3 D (three dimensional) woven fabrics by creating the unit cell using mathematical coding. In many technical applications, textile materials are subjected to rates of loading or straining that may be much greater in magnitude than the regular household applications of these materials. The main aim of this study is to provide a generalized method for all the structures. By mathematical coding, unit cells of 3 D woven orthogonal, warp interlock and angle interlock structures have been created. The study then focuses on developing code to analyze the geometrical parameters of the fabric like fabric thickness, areal density, and fiber volume fraction. Then, the tensile behavior of the coded 3 D structures is studied in Ansys platform and the results are compared with experimental values for authentication of geometrical parameters as well as for tensile behavior. The results show that the mathematical coding approach is a more efficient modeling technique with an acceptable error percentage.


1981 ◽  
Vol 1 (10) ◽  
pp. 801-810 ◽  
Author(s):  
Karl A. Piez ◽  
Benes L. Trus

A specific fibril model is presented consisting of bundles of five-stranded microfibrils, which are usually disordered (except axially) but under lateral compression become ordered. The features are as follows (where D = 234 residues or 67 nm): (1) D-staggered collagen molecules 4.5 D long in the helical microfibril have a left-handed supercoil with a pitch of 400–700 residues, but microfibrils need not have helical symmetry. (2) Straight-tilted 0.5-D overlap regions on a near-hexagonal lattice contribute the discrete x-ray diffraction reflections arising from lateral order, while the gap regions remain disordered. (3) The overlap regions are equivalent, but are crystallographically distinguished by systematic displacements from the near-hexagonal lattice. (4) The unit cell is the same as in a recently proposed three-dimensional crystal model, and calculated intensities in the equatorial region of the x-ray diffraction pattern agree with observed values.


Behaviour ◽  
1981 ◽  
Vol 76 (3-4) ◽  
pp. 223-249 ◽  
Author(s):  
Douglas G. Richards

AbstractIn numerous species of passerine birds the initial few notes of the song have a narrow frequency range and wide temporal spacing when compared with the rest of the song. This structure is well adapted for high detectability when the song is acoustically degraded during passage through the environment. The song of the rufous-sided towhee (Pipilo eythrophtalmus) consists of relatively tonal introductory syllables followed by a complex rapid trill. The trill is capable of carrying more information than the introduction, but is inherently less detectable at a distance owing to degradation by reverberation, amplitude fluctuation, and frequency-dependent attenuation. Signal detection theory predicts that the detectability of the trill will be increased when it is preceded by the introductory syllables, owing to the removal of uncertainty concerning the time of arrival of the signal. This is alerted detection. I performed field experiments using playback of recorded song to towhees to test the hypothesis that these introductory syllables facilitate detection of conspecific song at a distance. Tape recordings of normal and artificially degraded full songs, introduction, and trills were played to territorial male towhees. Normal songs, degraded songs, and normal trills elicited strong territorial defense responses, indicating recognition as adequate species-specific song, and confirming that sufficient information is contained in the trill for species recognition. Degraded trills alone elicited little response. Both normal and degraded introductions also elicited little response, demonstrating that the increased response to a degraded full song over that to a degraded trill is not due to any species-specific characteristics of the introduction, but rather to its function as an alerting stimulus.


Myoglobin from the common seal ( Phoca vitulina ) when crystallized from ammonium sulphate forms monoclinic crystals with space group the unit cell, a = 57·9Å, b = 29·6Å, c = 106·4Å, β = 102°15', contains four molecules. The method of isomorphous replacement has been used in an investigation of the centrosymmetric b -axis projection in which it has been possible to determine signs for nearly all the h0l reflexions having spacings greater than 4Å. Three independent heavy-atom derivatives were employed and the signs so determined have been used to compute a map of the electron density projected on the (010) plane. This projection has been interpreted in terms of the molecule of sperm-whale myoglobin, as deduced by Bodo, Dintzis, Kendrew & Wyckoff (1959) from a three-dimensional Fourier synthesis to 6Å resolution. The results of the interpretation show that the two myoglobin molecules are very similar in form (tertiary structure) in spite of the differences in their amino-acid composition. The relative orientation of the two unit cells with respect to the myoglobin molecule is given and a comparison is made of the positions of the heavy atoms in each molecule.


2021 ◽  
pp. 1-35
Author(s):  
Rick Dehner ◽  
Pranav Sriganesh ◽  
Ahmet Selamet ◽  
Keith Miazgowicz

Abstract The present study focuses on the acoustics of a turbocharger centrifugal compressor from a spark-ignition internal combustion engine. Whoosh noise is typically the primary concern for this type of compressor, which is loosely characterized by broadband sound elevation in the 4 to 13 kHz range. To identify the generation mechanism of broadband whoosh noise, the present study combines three approaches: three-dimensional (3D) computational fluid dynamics (CFD) predictions, experiments, and modal decomposition of 3D CFD results. After establishing the accuracy of predictions, flow structures and time-resolved pressures are closely examined in the vicinity of the main blade leading edge. This reveals the presence of rotating instabilities that may interact with the rotor blades to generate noise. An azimuthal modal decomposition is performed on the predicted pressure field to determine the number of cells and the frequency content of these rotating instabilities. The strength of the rotating instabilities and the frequency range in which noise is generated as a consequence of the rotor-rotating instability interaction, is found to correspond well with the qualitative trend of the whoosh noise that is measured several duct diameters upstream of the rotor blades. The variation of whoosh frequency range between low and high rotational speeds is interpreted through this analysis. It is also found that the whoosh noise primarily propagates along the duct as acoustic azimuthal modes. Hence, the inlet duct diameter, which governs the cut-off frequency for multi-dimensional acoustic modes, determines the lower frequency bound of the broadband noise.


2013 ◽  
Vol 2013 ◽  
pp. 1-12 ◽  
Author(s):  
Mohammad Alibakhshi Kenari

A variety of antennas have been engineered with MTMs and MTM-inspired constructs to improve their performance characteristics. This report describes the theory of MTMs and its utilization for antenna's techniques. The design and modeling of two MTM structures withε-μconstitutive parameters for patch antennas are presented. The framework presents two novel ultrawideband (UWB) shrinking patch antennas filled with composite right-/left-handed transmission line (CRLH-TL) structures. The CRLH-TL is presented as a general TL possessing both left-handed (LH) and right-handed (RH) natures. The CRLH-TL structures enhance left-handed (LH) characteristics which enable size reduction and large frequency bandwidth. The large frequency bandwidth and good radiation properties can be obtained by adjusting the dimensions of the patches and CRLH-TL structures. This contribution demonstrates the possibility of reducing the size of planar antennas by using LH-transmission lines. Two different types of radiators are investigated—a planar patch antenna composed of fourO-formed unit cells and a planar patch antenna composed of sixO-shaped unit cells. A CRLH-TL model is employed to design and compare these two approaches and their realization with a varying number ofL-Cloaded unit cells. Two representative antenna configurations have been selected and subsequently optimized with full-wave electromagnetic analysis. Return loss and radiation pattern simulations of these antennas prove the developed concept.


Sign in / Sign up

Export Citation Format

Share Document