Automatic Identification Systems – the Effects of Class B on the Use of Class A Systems

2006 ◽  
Vol 59 (2) ◽  
pp. 335-347 ◽  
Author(s):  
Andy Norris
Keyword(s):  
Low Cost ◽  
International Maritime Organization ◽  
Automatic Identification ◽  
International Electrotechnical Commission ◽  
Market Place ◽  
Data Link ◽  
Class A ◽  
Class B ◽  
Update Rate ◽  
The Impact

The standards for CSTDMA Class B AIS will shortly be published by the International Electrotechnical Commission and equipment will become available during 2006. The perceived benefits that Class B brings to leisure craft users and its relatively low cost will make it attractive in the market place. A rapid take-up of Class B use can therefore be expected. This paper considers the impact that increased use of Class B will have on users of Class A AIS that are compulsorily fitted to larger vessels to meet the requirements of the International Maritime Organization Safety of Life at Sea convention. The CSTDMA Class B system has been designed to prevent overloading of the AIS VHF data link. This is briefly reviewed but there are a number of other aspects that need to be considered. These include: the increased garbling of Class B messages compared to those of Class A; the problems accruing from the low update rate of Class B information; the increase in display information that will need to be managed; and the possible increase in inappropriate manoeuvres of leisure craft caused by misplaced reliance on AIS. As a result of the investigation the paper highlights the fact that Class B users must not assume that their own presence, in the form of Class B transmissions, will be particularly visible on the bridge of many SOLAS vessels. This will continue to be the case for many years into the future, until such vessels are mandated to carry radar with AIS target overlay capability.

scholarly journals The Impact of Space-Based AIS Antenna Orientation on In-Orbit AIS Detection Performance

2019 ◽  
Vol 9 (16) ◽  
pp. 3319 ◽  
Author(s):  
Wahyudi Hasbi ◽  
Kamirul ◽  
Mohammad Mukhayadi ◽  
Udo Renner
Keyword(s):  
Detection Performance ◽  
Monopole Antenna ◽  
Automatic Identification ◽  
Identification System ◽  
Class A ◽  
Flight Direction ◽  
Maritime Surveillance ◽  
Class B ◽  
Message Reception ◽  
The Impact

In this paper, a study on the impact of changing the space-based Automatic Identification System (AIS) monopole antenna orientation on its message reception performance in orbit has been conducted. The study has been carried out by maneuvering the attitude of LAPAN-A2, an equatorial orbiting microsatellite with AIS antenna fixedly mounted on the satellite’s body, into the desired orientation. Based on the analysis of the datasets collected during the maneuver, the orientation of AIS monopole antenna 45° toward its flight direction increases the overall detection performance of the AIS message, including class A ship to 208.80% and also class B ships to 175.93%. This orientation also increases the detection of AIS messages in ocean areas having low detection probability due to AIS signal collision. The result of this research could become a reference in order to specify AIS antenna position and orientation in a small satellite carrying a space-based AIS system for maritime surveillance & monitoring purposes.

scholarly journals Design and Validation of an Adjustable Large-Scale Solar Simulator

2021 ◽  
Vol 11 (4) ◽  
pp. 1964
Author(s):  
Daniele Colarossi ◽  
Eleonora Tagliolini ◽  
Paolo Principi ◽  
Roberto Fioretti
Keyword(s):  
Large Scale ◽  
Design Procedure ◽  
Spatial Arrangement ◽  
Luminous Flux ◽  
International Electrotechnical Commission ◽  
Solar Simulator ◽  
Class A ◽  
Pv Panel ◽  
Temporal Instability ◽  
Class B

This work presents an adjustable large-scale solar simulator based on metal halide lamps. The design procedure is described with regards to the construction and spatial arrangement of the lamps and the designed optical system. Rotation and translation of the lamp array allow setting the direction and the intensity of the luminous flux on the horizontal plane. To validate the built model, irradiance nonuniformity and temporal instability tests were carried out assigning Class A, B, or C for each test, according to the International Electrotechnical Commission (IEC) standards requirements. The simulator meets the Class C standards on a 200 × 90 cm test plane, Class B on 170 × 80 cm, and Class A on 80 × 40 cm. The temporal instability returns Class A results for all the measured points. Lastly, a PV panel is characterized by tracing the I–V curve under simulated radiation, under outdoor natural sunlight, and with a numerical method. The results show a good approximation.

scholarly journals Seismic vulnerability of dwellings at Sete Cidades Volcano (S. Miguel Island, Azores)

2006 ◽  
Vol 6 (1) ◽  
pp. 41-48 ◽  
Author(s):  
A. Gomes ◽  
J. L. Gaspar ◽  
G. Queiroz
Keyword(s):  
Seismic Event ◽  
Seismic Vulnerability ◽  
Field Survey ◽  
Civil Protection ◽  
Volcanic Origin ◽  
Class A ◽  
Class B ◽  
The Impact ◽  
Human Losses ◽  
Made In

Abstract. Since the settlement of S. Miguel Island (Azores), in the XV century, several earthquakes caused important human losses and severe damages on the island. Sete Cidades Volcano area, located in the westernmost part of the island, was attained by strong seismic crises of tectonic and volcanic origin and major events reached a maximum historical intensity of IX (European Macroseismic Scale 1998) in this zone. Aiming to evaluate the impact of a future major earthquakes, a field survey was carried out in ten parishes of Ponta Delgada County, located on the flanks of Sete Cidades volcano and inside it is caldera. A total of 7019 buildings were identified, being 4351 recognized as dwellings. The total number of inhabitants in the studied area is 11429. In this work, dwellings were classified according to their vulnerability to earthquakes (Classes A to F), using the structure types table of the EMS-98, adapted to the types of constructions made in the Azores. It was concluded that 76% (3306) of the houses belong to Class A, and 17% (740) to Class B, which are the classes of higher vulnerability. If the area is affected by a seismic event with intensity IX it is estimated, that 57% (2480) to 77% (3350) of the dwellings will partially or totally collapse and 15% (652) to 25% (1088) will need to be rehabilitated. In this scenario, considering the average of inhabitants per house for each parish, 82% (9372) to 92% (10515) of the population will be affected. The number of deaths, injured and dislodged people will pose severe problems to the civil protection authorities and will cause social and economic disruption in the entire archipelago.

Computer simulation study about the dependence of amorphous silicon photonic waveguides efficiency on the material quality

2020 ◽  
Vol 90 (3) ◽  
pp. 30502
Author(s):  
Alessandro Fantoni ◽  
João Costa ◽  
Paulo Lourenço ◽  
Manuela Vieira
Keyword(s):  
Amorphous Silicon ◽  
High Throughput Screening ◽  
Simulation Analysis ◽  
Low Cost ◽  
Deposition Process ◽  
Large Area ◽  
Sidewall Roughness ◽  
Sensing Applications ◽  
Fabrication Defects ◽  
The Impact

Amorphous silicon PECVD photonic integrated devices are promising candidates for low cost sensing applications. This manuscript reports a simulation analysis about the impact on the overall efficiency caused by the lithography imperfections in the deposition process. The tolerance to the fabrication defects of a photonic sensor based on surface plasmonic resonance is analysed. The simulations are performed with FDTD and BPM algorithms. The device is a plasmonic interferometer composed by an a-Si:H waveguide covered by a thin gold layer. The sensing analysis is performed by equally splitting the input light into two arms, allowing the sensor to be calibrated by its reference arm. Two different 1 × 2 power splitter configurations are presented: a directional coupler and a multimode interference splitter. The waveguide sidewall roughness is considered as the major negative effect caused by deposition imperfections. The simulation results show that plasmonic effects can be excited in the interferometric waveguide structure, allowing a sensing device with enough sensitivity to support the functioning of a bio sensor for high throughput screening. In addition, the good tolerance to the waveguide wall roughness, points out the PECVD deposition technique as reliable method for the overall sensor system to be produced in a low-cost system. The large area deposition of photonics structures, allowed by the PECVD method, can be explored to design a multiplexed system for analysis of multiple biomarkers to further increase the tolerance to fabrication defects.

Advancing dairy farming profitability through research

2001 ◽  
pp. 17-22
Author(s):  
J.R. Caradus ◽  
D.A. Clark
Keyword(s):  
Research And Development ◽  
Dairy Cow ◽  
Low Cost ◽  
Pasture Management ◽  
Nitrogen Fertiliser ◽  
Grass Endophyte ◽  
Forage Species ◽  
Development Outcomes ◽  
Dairy Cow Nutrition ◽  
The Impact

The New Zealand dairy industry recognises that to remain competitive it must continue to invest in research and development. Outcomes from research have ensured year-round provision of low-cost feed from pasture while improving productivity. Some of these advances, discussed in this paper, include the use of white clover in pasture, understanding the impacts of grass endophyte, improved dairy cow nutrition, the use of alternative forage species and nitrogen fertiliser to improve productivity, demonstration of the impact of days-in-milk on profitability, and the use of feed budgeting and appropriate pasture management. Keywords: dairy, profitability, research and development

مهارة الكلام منظور من عملية التعلم والتعليم في جامعة باتوسنجكر الاسلامية الحكومية سومطرى الغربية

2019 ◽  
Vol 1 (1) ◽  
Author(s):  
Suharmon Suharmon
Keyword(s):  
Teaching Strategies ◽  
Language Education ◽  
Arabic Language ◽  
Descriptive Statistics ◽  
Quantitative Approach ◽  
Motivation To Learn ◽  
Education Department ◽  
Class A ◽  
Class B ◽  
Speaking Skill

This research aims to obtain infomation about Arabic learning especially speaking skill in Arabic Language Education Department at IAIN Batusangkar. The research uses a quantitative approach. The instruments to collect the data are test and questionnaire. The data were analyzed using descriptive statistics. The results of the research state that the students’ speaking ability at class “ A “ are 28% low, 36% moderate, and 36% high. While, at class “B”, students’ speaking abilities are 36.4% low, 40,9% moderate, and 22.7% high. The cause of students’ low ability is the unappropriateness of teachers’ strategy in teaching speaking. There are about 96% students at class “A” agreed and 86.4% students at class “B” had similar answer. Another cause is students’ low motivation in learning. Class “A” students agreed for about 76% of them and 77% of class “B” students answered the same. From the finding, it can be concluded that the inability of students to speak Arabic can be overcomed by improving teaching strategies and encouraging maximum motivation  to learn Arabic.

Motivating Compliance: Firm Response to Mandatory Disclosure Policies

2018 ◽  
Vol 32 (2) ◽  
pp. 103-119
Author(s):  
Colleen M. Boland ◽  
Chris E. Hogan ◽  
Marilyn F. Johnson
Keyword(s):  
Conflict Of Interest ◽  
Low Cost ◽  
Cost Effective ◽  
Data Availability ◽  
Policy Adoption ◽  
Future Research ◽  
Regulated Firms ◽  
Firm Response ◽  
Disclosure Rules ◽  
The Impact

SYNOPSIS Mandatory existence disclosure rules require an organization to disclose a policy's existence, but not its content. We examine policy adoption frequencies in the year immediately after the IRS required mandatory existence disclosure by nonprofits of various governance policies. We also examine adoption frequencies in the year of the subsequent change from mandatory existence disclosure to a disclose-and-explain regime that required supplemental disclosures about the content and implementation of conflict of interest policies. Our results suggest that in areas where there is unclear regulatory authority, mandatory existence disclosure is an effective and low cost regulatory device for encouraging the adoption of policies desired by regulators, provided those policies are cost-effective for regulated firms to implement. In addition, we find that disclose-and-explain regulatory regimes provide stronger incentives for policy adoption than do mandatory existence disclosure regimes and also discourage “check the box” behavior. Future research should examine the impact of mandatory existence disclosure rules in the year that the regulation is implemented. Data Availability: Data are available from sources cited in the text.

Sign in / Sign up

Export Citation Format

Share Document