The effect of ambient air temperature and precipitation on monthly counts of salmonellosis in four regions of Kazakhstan, Central Asia, in 2000–2010

2013 ◽  
Vol 142 (3) ◽  
pp. 608-615 ◽  
Author(s):  
A. M. GRJIBOVSKI ◽  
A. KOSBAYEVA ◽  
B. MENNE

SUMMARYWe studied associations between monthly counts of laboratory-confirmed cases of salmonellosis, ambient air temperature and precipitation in four settings in Kazakhstan. We observed a linear association between the number of cases of salmonellosis and mean monthly temperature during the same months only in Astana: an increase of 1°C was associated with a 5·5% [95% confidence interval (CI) 2·2–8·8] increase in the number of cases. A similar association, although not reaching the level of significance was observed in the Southern Kazakhstan region (3·5%, 95% CI −2·1 to 9·1). Positive association with precipitation with lag 2 was found in Astana: an increase of 1 mm was associated with a 0·5% (95% CI 0·1–1·0) increase in the number of cases. A similar association, but with lag 0 was observed in Southern Kazakhstan region (0·6%, 95% CI 0·1–1·1). The results may have implications for the future patterns of salmonellosis in Kazakhstan with regard to climate change.

Author(s):  
Bair Tsydypov ◽  

The geoecological features of the transformation of individual components of the natural environment (vegetation, soils, surface waters) in different climatic zones of the north of Central Asia under climate change have been identified. Trends of NDVI, air temperature and precipitation were calculated for the wet (1980-1998) and dry (1999-2017) periods. A statistically significant trend was established for an increase in air temperature and a decrease in precipitation. The situation of extreme low water in the Baikal basin in 2014-2015 is discussed. During the wet period, positive NDVI trends are observed for almost the entire study area, while the dry period is characterized by a significant increase in negative NDVI trends.


1982 ◽  
Vol 17 (1) ◽  
pp. 135-148
Author(s):  
P.T. Wong ◽  
D.S. Mavinic

Abstract The treatability of a municipal leachate (BOD5 = 8090 mg/L) was investigated, by aerobic biostabilization, at a nutrient loading of BOD5:N:P of 100:3.2:1.1. The first stage effluents were subsequently polished by lime-magnesium coagulation. The ranges of ambient air temperature and sludge age studied were 5° to 25°C and 5 to 20 days, respectively. In the biostabilization phase, a BOD5:N:P loading of 100:3.2:1.1 was found to be “adequate” for treatment. Organic and metal removals in the first stage units were excellent. Under all conditions investigated, except for the two units close to washout conditions (5-day sludge age units at 5° and 10°C), BOD5 and COD removals of at least 99.4 and 96.4 percent, respectively, were achieved. Similarly, removal rates for most of the metals monitored were greater than 90 percent. In general, the removal of residual contaminants was not enhanced significantly by the addition of magnesium in the lime-magnesium polishing step.


Molecules ◽  
2021 ◽  
Vol 26 (11) ◽  
pp. 3398
Author(s):  
Yi Long ◽  
Kun Liu ◽  
Yongli Zhang ◽  
Wenzhe Li

Inorganic cesium lead halide perovskites, as alternative light absorbers for organic–inorganic hybrid perovskite solar cells, have attracted more and more attention due to their superb thermal stability for photovoltaic applications. However, the humid air instability of CsPbI2Br perovskite solar cells (PSCs) hinders their further development. The optoelectronic properties of CsPbI2Br films are closely related to the quality of films, so preparing high-quality perovskite films is crucial for fabricating high-performance PSCs. For the first time, we demonstrate that the regulation of ambient temperature of the dry air in the glovebox is able to control the growth of CsPbI2Br crystals and further optimize the morphology of CsPbI2Br film. Through controlling the ambient air temperature assisted crystallization, high-quality CsPbI2Br films are obtained, with advantages such as larger crystalline grains, negligible crystal boundaries, absence of pinholes, lower defect density, and faster carrier mobility. Accordingly, the PSCs based on as-prepared CsPbI2Br film achieve a power conversion efficiency of 15.5% (the maximum stabilized power output of 15.02%). Moreover, the optimized CsPbI2Br films show excellent robustness against moisture and oxygen and maintain the photovoltaic dark phase after 3 h aging in an air atmosphere at room temperature and 35% relative humidity (R.H.). In comparison, the pristine films are completely converted to the yellow phase in 1.5 h.


2021 ◽  
Vol ahead-of-print (ahead-of-print) ◽  
Author(s):  
Younes Bahammou ◽  
Mounir Kouhila ◽  
Haytem Moussaoui ◽  
Hamza Lamsyehe ◽  
Zakaria Tagnamas ◽  
...  

PurposeThis work aims to study the hydrothermal behavior of mortar cement toward certain environmental factors (ambient air temperature and air velocity) based on its drying kinetics data. The objective is to provide a better understanding and controlling the stability of mortar structures, which integrate the sorption phenomenon, drying process, air pressure and intrinsic characteristics. This leads to predict the comportment of mortar structures in relation with main environmental factors and minimize the risk of cracking mortar structures at an early age.Design/methodology/approachThermokinetic study was carried out in natural and forced convection solar drying at three temperatures 20, 30 and 40°C and three air velocities (1, 3 and 5 m.s-1). The empirical and semiempirical models tested successfully describe the drying kinetics of mortar. These models simulate the drying process of water absorbed by capillarity, which is the most common humidity transfer mechanism in building materials and contain parameters with physical significance, which integrate the effect of several environmental factors and intrinsic characteristics of mortar structures.FindingsThe models simulate the drying process of water absorbed by capillarity, which is the most common humidity transfer mechanism in building materials and contain parameters with physical significance, which integrate the effect of several environmental factors and intrinsic characteristics of mortar structures. The average activation energy obtained expressed the temperature effect on the mortar diffusivity. The drying constant and the diffusion coefficient can be used to predict the influence of these environmental factors on the drying behavior of various building materials and therefore on their durability.Originality/valueEvaluation of the effect of several environmental factors and intrinsic characteristics of mortar structures on their durability.


10.1289/ehp92 ◽  
2016 ◽  
Vol 124 (12) ◽  
pp. 1882-1890 ◽  
Author(s):  
Maria C. Mirabelli ◽  
Ambarish Vaidyanathan ◽  
W. Dana Flanders ◽  
Xiaoting Qin ◽  
Paul Garbe

1958 ◽  
Vol 38 (2) ◽  
pp. 148-159 ◽  
Author(s):  
M. A. MacDonald ◽  
J. M. Bell

This report presents effects of low temperatures on the feed consumption and efficiency of milk production of six mature, lactating, Holstein-Friesian cows that were confined in stanchions for three fortnightly experimental periods during which ambient temperatures measured in degree-hours per day (d-h/day) ranged from 110 to 1152 and daily minimum ambient air temperature (DMAAT) varied from 0° to 38°F. Applying results obtained, it was calculated that as temperatures decreased, i.e., d-h/day increased from 100 to 1200 and DMAAT decreased from 40° to 0°F, average daily intakes of total dry matter, hay, and gross and digestible Calories increased approximately 6.4 lb., 5.3 lb., 13 Therms and 9 Therms, respectively. Each of these increases was statistically significant at the 1 per cent level. Reductions in temperature also decreased gross and net caloric efficiencies of milk production approximately 10 and 8.5 per cent, respectively. These decreases were significant at the 2 per cent level. No correlation was evident between crude protein utilization and temperature.Results indicated that thermal stress was not overcome adequately by supplementary hay intake alone and that appetite stimulation by low temperatures had a carry-over effect continuing at least 24 hours. For continued efficient milk production during winters where low ambient temperatures are prevalent these results suggest it is necessary to provide some form of building insulation, ambient heat and/or provide a high energy supplement to otherwise adequate production rations.


2011 ◽  
Vol 3 (3) ◽  
pp. 170 ◽  
Author(s):  
Ailton Marcolino Liberato ◽  
José Ivaldo B. De Brito

A presente pesquisa teve por objetivo investigar possíveis alterações em componentes do balanço hídrico climático, associadas a diferentes cenários (A2 e B2) das mudanças climáticas do IPCC, para a Amazônia Ocidental (Acre, Amazonas, Rondônia e Roraima). Os dados climatológicos de temperatura do ar e totais de precipitação pluvial usados como referência neste estudo, são oriundos do INMET (1961-2005), da CEPLAC (1983-1999) e da reanálise do NCEP/NCAR (1983-1995). O método utilizado na elaboração do balanço hídrico é o de Thornthwaite e Mather (1957) modificado por Krishan (1980). Os resultados das projeções mostram tendência de clima mais seco, diminuição na umidade do solo, redução na vazão dos rios, aumento no risco de incêndio e diminuição no escoamento superficial e sub-superficial para a Amazônia Ocidental até 2100.Palavras-chave: cenários, índices climáticos, Amazônia. Influence of Climate Change on Water Budget of Western Amazonia ABSTRACTThe main objective of this study was investigate possible alterations in the climatic water budget components associated with different scenarios (A2 and B2) of the IPCC to Amazonian Western (Acre, Amazonas, Rondônia and Roraima). The climatological data of air temperature and precipitation from the INMET (1961-2005), CEPLAC (1983-1999) and NCEP/NCAR reanalysis (1983-1995) were used in the present study. The Thornthwaite and Mather (1955) method was used in the elaboration of the climatic water budget modified by Krishan (1980). The results of the projections show drier climate trends and decrease of the soil moisture, reduction in the rivers discharge, increase in the fire risk and decrease in the runoff for the Amazonian Western up to 2100. Keywords: scenarios, climate index, Amazonian.


Author(s):  
V. V. Hrynchak

The decision about writing this article was made after familiarization with the "Brief Climatic Essay of Dnepropetrovsk City (prepared based on observations of 1886 – 1937)" written by the Head of the Dnipropetrovsk Weather Department of the Hydrometeorological Service A. N. Mikhailov. The guide has a very interesting fate: in 1943 it was taken by the Nazis from Dnipropetrovsk and in 1948 it returned from Berlin back to the Ukrainian Hydrometeorological and Environmental Directorate of the USSR, as evidenced by a respective entry on the Essay's second page. Having these invaluable materials and data of long-term weather observations in Dnipro city we decided to analyze climate changes in Dnipropetrovsk region. The article presents two 50-year periods, 1886-1937 and 1961-2015, as examples. Series of observations have a uniform and representative character because they were conducted using the same methodology and results processing. We compared two main characteristics of climate: air temperature and precipitation. The article describes changes of average annual temperature values and absolute temperature values. It specifies the shift of seasons' dates and change of seasons' duration. We studied the changes of annual precipitation and peculiarities of their seasonable distribution. Apart from that peculiarities of monthly rainfall fluctuations and their heterogeneity were specified. Since Dnipro city is located in the center of the region the identified tendencies mainly reflect changes of climatic conditions within the entire Dnipropetrovsk region.


Author(s):  
Henriks Putāns ◽  
Viktorija Zagorska ◽  
Imants Ziemelis ◽  
Zanis Jesko

A flat plate solar collector with cell polycarbonate absorber and transparent cover has been made and its experimental investigation carried out. The collector consists of a wooden box, into which, a layer of heat insulation with a mirror film and 4 mm thick cell polycarbonate sheet, as the absorber, are placed. The coherence between collector’s efficiency, heat carrier and ambient air temperature, as well as intensity of the solar radiation and heat power in the experimental investigation has been obtained. During the experimental examination the maximum temperature of the heat carrier reached 80˚C at the intensity of solar radiation about 0.8 kW/m2 and ambient air temperature around 32˚C. The efficiency of the collector reached 33-60%, depending on the intensity of solar radiation and surrounding air temperature.


Sign in / Sign up

Export Citation Format

Share Document