High-sensitivity AlGaN/GaN magnetoresistive sensor device by profiling the AlGaN layer

2021 ◽  
Author(s):  
Lingxi Xia ◽  
Yung C. Liang
Keyword(s):  
High Sensitivity ◽  
Algan Layer ◽  
Magnetoresistive Sensor ◽  
Sensor Device

scholarly journals A two-stage amplified PZT sensor for monitoring lung and heart sounds in discharged pneumonia patients

2021 ◽  
Vol 7 (1) ◽  
Author(s):  
Hongbin Chen ◽  
Shuai Yu ◽  
Haiyang Liu ◽  
Jie Liu ◽  
Yongguang Xiao ◽  
...  
Keyword(s):  
High Sensitivity ◽  
Cost Effective ◽  
High Ratio ◽  
Heart Sounds ◽  
Two Stage ◽  
Diagnosis And Prognosis ◽  
Sensor Device ◽  
Cost Effective Alternative ◽  
A Charge ◽  
Highly Sensitive Detection

AbstractAssessment of lung and heart states is of critical importance for patients with pneumonia. In this study, we present a small-sized and ultrasensitive accelerometer for continuous monitoring of lung and heart sounds to evaluate the lung and heart states of patients. Based on two-stage amplification, which consists of an asymmetric gapped cantilever and a charge amplifier, our accelerometer exhibited an extremely high ratio of sensitivity to noise compared with conventional structures. Our sensor achieves a high sensitivity of 9.2 V/g at frequencies less than 1000 Hz, making it suitable to use to monitor weak physiological signals, including heart and lung sounds. For the first time, lung injury, heart injury, and both lung and heart injuries in discharged pneumonia patients were revealed by our sensor device. Our sound sensor also successfully tracked the recovery course of the discharged pneumonia patients. Over time, the lung and heart states of the patients gradually improved after discharge. Our observations were in good agreement with clinical reports. Compared with conventional medical instruments, our sensor device provides rapid and highly sensitive detection of lung and heart sounds, which greatly helps in the evaluation of lung and heart states of pneumonia patients. This sensor provides a cost-effective alternative approach to the diagnosis and prognosis of pneumonia and has the potential for clinical and home-use health monitoring.

scholarly journals A Novel Type Room Temperature Surface Photovoltage Gas Sensor Device 

2018 ◽  
Author(s):  
Monika Kwoka ◽  
Michal A. Borysiewicz ◽  
Pawel Tomkiewicz ◽  
Anna Piotrowska ◽  
Jacek Szuber
Keyword(s):  
Gas Sensor ◽  
Room Temperature ◽  
Gas Sensing ◽  
Signal To Noise Ratio ◽  
High Sensitivity ◽  
Fast Response ◽  
Surface Photovoltage ◽  
Kelvin Probe ◽  
Sensor Device ◽  
Developed Surface

In this paper a novel type of a highly sensitive gas sensor device based on the surface photovoltage effect is described. The developed surface photovoltage gas sensor is based on a reverse Kelvin probe approach. As the active gas sensing electrode the porous ZnO nanostructured thin films are used deposited by the direct current (DC) reactive magnetron sputtering method exhibiting the nanocoral surface morphology combined with an evident surface nonstoichiometry related to the unintentional surface carbon and water vapor contaminations. Among others, the demonstrated SPV gas sensor device exhibits a high sensitivity of 1 ppm to NO2 with a signal to noise ratio of about 50 and a fast response time of several seconds under the room temperature conditions.

An integrated low 1/f noise and high-sensitivity CMOS instrumentation amplifier for TMR sensors

2017 ◽  
Vol 31 (08) ◽  
pp. 1750070 ◽  
Author(s):  
Zhiqiang Gao ◽  
Bo Luan ◽  
Jincai Zhao ◽  
Xiaowei Liu
Keyword(s):  
Magnetic Tunnel Junction ◽  
High Sensitivity ◽  
Wheatstone Bridge ◽  
Instrumentation Amplifier ◽  
Noise Spectral Density ◽  
Input Noise ◽  
Magnetoresistive Sensor ◽  
Chip Scale Package ◽  
Equivalent Input Noise ◽  
Dc Current

In this paper, a very low 1/f noise integrated Wheatstone bridge magnetoresistive sensor ASIC based on magnetic tunnel junction (MTJ) technology is presented for high sensitivity measurements. The present CMOS instrumentation amplifier employs the gain-boost folded-cascode structure based on the capacitive-feedback chopper-stabilized technique. By chopping both the input and the output of the amplifier, combined with MTJ magnetoresistive sensitive elements, a noise equivalent magnetoresistance 1 nT/Hz[Formula: see text] at 2 Hz, the equivalent input noise spectral density 17 nV/Hz[Formula: see text](@2Hz) is achieved. The chip-scale package of the TMR sensor and the instrumentation amplifier is only about 5 mm × 5 mm × 1 mm, while the whole DC current dissipates only 2 mA.

Fin-shaped AlGaN/GaN high electron mobility magnetoresistive sensor device

2021 ◽  
Vol 118 (16) ◽  
pp. 162104
Author(s):  
Lingxi Xia ◽  
Kailin Ren ◽  
Chih-Fang Huang ◽  
Yung C. Liang
Keyword(s):  
Electron Mobility ◽  
High Electron ◽  
High Electron Mobility ◽  
Magnetoresistive Sensor ◽  
Sensor Device

scholarly journals Research of Probability-Based Tunneling Magnetoresistive Sensor Static Hysteresis Model

Sensors ◽  
2021 ◽  
Vol 21 (22) ◽  
pp. 7672
Author(s):  
Yutao Li ◽  
Liliang Wang ◽  
Hao Yu ◽  
Zheng Qian
Keyword(s):  
Small Volume ◽  
High Sensitivity ◽  
High Accuracy ◽  
High Order ◽  
Preisach Model ◽  
Hysteresis Model ◽  
Broad Application ◽  
Magnetoresistive Sensor ◽  
Hysteresis Characteristics ◽  
Application Prospects

Tunneling magnetoresistive (TMR) sensors have broad application prospects because of their high sensitivity and small volume. However, the inherent hysteresis characteristics of TMR affect its applications in high accuracy scenarios. It is essential to build a model to describe the attributes of hysteresis of TMR accurately. Preisach model is one of the popular models to describe the behavior of inherent hysteresis for TMR, whereas it presents low accuracy in high-order hysteresis reversal curves. Furthermore, the traditional Preisach model has strict congruence constraints, and the amount of data seriously affects the accuracy. This paper proposes a hysteresis model from a probability perspective. This model has the same computational complexity as the classic Preisach model while presenting higher accuracy, especially in high-order hysteresis reversal curves. When measuring a small amount of data, the error of this method is significantly reduced compared with the classical Preisach model. Besides, the proposed model’s congruence in this paper only needs equal vertical chords.

A high-sensitivity magnetoresistive sensor

1990 ◽  
Author(s):  
J.E. Lenz ◽  
G.F. Rouse ◽  
L.K. Strandjord ◽  
B.B. Pant ◽  
A. Metze ◽  
...  
Keyword(s):  
High Sensitivity ◽  
Magnetoresistive Sensor

Radio Measurements of Coronal Magnetic Fields

1994 ◽  
Vol 144 ◽  
pp. 21-28 ◽  
Author(s):  
G. B. Gelfreikh
Keyword(s):  
Magnetic Field ◽  
Magnetic Fields ◽  
Solar Corona ◽  
Active Regions ◽  
High Sensitivity ◽  
Coronal Magnetic Field ◽  
Transverse Magnetic ◽  
Radio Sources ◽  
Radio Waves ◽  
Solar Active Regions

AbstractA review of methods of measuring magnetic fields in the solar corona using spectral-polarization observations at microwaves with high spatial resolution is presented. The methods are based on the theory of thermal bremsstrahlung, thermal cyclotron emission, propagation of radio waves in quasi-transverse magnetic field and Faraday rotation of the plane of polarization. The most explicit program of measurements of magnetic fields in the atmosphere of solar active regions has been carried out using radio observations performed on the large reflector radio telescope of the Russian Academy of Sciences — RATAN-600. This proved possible due to good wavelength coverage, multichannel spectrographs observations and high sensitivity to polarization of the instrument. Besides direct measurements of the strength of the magnetic fields in some cases the peculiar parameters of radio sources, such as very steep spectra and high brightness temperatures provide some information on a very complicated local structure of the coronal magnetic field. Of special interest are the results found from combined RATAN-600 and large antennas of aperture synthesis (VLA and WSRT), the latter giving more detailed information on twodimensional structure of radio sources. The bulk of the data obtained allows us to investigate themagnetospheresof the solar active regions as the space in the solar corona where the structures and physical processes are controlled both by the photospheric/underphotospheric currents and surrounding “quiet” corona.

Backscattered Electron Imaging of GaAs/AlGaAs Super Lattice Structures with an Ultra-High- Resolution SEM

1988 ◽  
Vol 46 ◽  
pp. 204-205
Author(s):  
Kazumichi Ogura ◽  
Michael M. Kersker
Keyword(s):  
High Resolution ◽  
Layer Structure ◽  
High Sensitivity ◽  
Beam Current ◽  
Electron Beam Current ◽  
Lattice Structures ◽  
Super Lattice ◽  
Different Types ◽  
Backscattered Electron ◽  
Electron Imaging

Backscattered electron (BE) images of GaAs/AlGaAs super lattice structures were observed with an ultra high resolution (UHR) SEM JSM-890 with an ultra high sensitivity BE detector. Three different types of super lattice structures of GaAs/AlGaAs were examined. Each GaAs/AlGaAs wafer was cleaved by a razor after it was heated for approximately 1 minute and its crosssectional plane was observed.First, a multi-layer structure of GaAs (100nm)/AlGaAs (lOOnm) where A1 content was successively changed from 0.4 to 0.03 was observed. Figures 1 (a) and (b) are BE images taken at an accelerating voltage of 15kV with an electron beam current of 20pA. Figure 1 (c) is a sketch of this multi-layer structure corresponding to the BE images. The various layers are clearly observed. The differences in A1 content between A1 0.35 Ga 0.65 As, A1 0.4 Ga 0.6 As, and A1 0.31 Ga 0.69 As were clearly observed in the contrast of the BE image.

An x-ray microprobe based upon a close-coupled focal-spot / glass capillary arrangement

1992 ◽  
Vol 50 (2) ◽  
pp. 1758-1759
Author(s):  
D. A. Carpenter ◽  
M. A. Taylor
Keyword(s):  
Imaging Techniques ◽  
Fluorescence Analysis ◽  
High Sensitivity ◽  
Specimen Preparation ◽  
X Rays ◽  
Glass Capillary ◽  
Close Coupling ◽  
X Ray ◽  
Point To Point ◽  
Beam Damage

The development of intense sources of x rays has led to renewed interest in the use of microbeams of x rays in x-ray fluorescence analysis. Sparks pointed out that the use of x rays as a probe offered the advantages of high sensitivity, low detection limits, low beam damage, and large penetration depths with minimal specimen preparation or perturbation. In addition, the option of air operation provided special advantages for examination of hydrated systems or for nondestructive microanalysis of large specimens.The disadvantages of synchrotron sources prompted the development of laboratory-based instrumentation with various schemes to maximize the beam flux while maintaining small point-to-point resolution. Nichols and Ryon developed a microprobe using a rotating anode source and a modified microdiffractometer. Cross and Wherry showed that by close-coupling the x-ray source, specimen, and detector, good intensities could be obtained for beam sizes between 30 and 100μm. More importantly, both groups combined specimen scanning with modern imaging techniques for rapid element mapping.

Sign in / Sign up

Export Citation Format

Share Document