Effect of Hydrogen Treatment on Room -Temperature Electric-Field Induced Properties in Narrow-Gap ZnCdHgTe Thin Films

2004 ◽  
Vol 813 ◽  
Author(s):  
Galina M. Khlyap ◽  
Petro G. Sydorchuk ◽  
Jacek Polit
Keyword(s):  
Thin Films ◽  
Room Temperature ◽  
Hydrogen Treatment ◽  
Narrow Gap ◽  
Glass Substrates ◽  
Semiconductor Thin Films ◽  
Visible Wavelength Range ◽  
Current Voltage ◽  
Before And After ◽  
First Time

ABSTRACTThe effect of hydrogen treatment on room temperature electric properties of narrow-gap semiconductor thin films ZnxCdyHg1−z−yTe (0 < x < 0.50, 0.20 < y < 0.40) is investigated for the first time. ZnCdHgTe films of 2 – 5 [.proportional]m thickness were grown on glass substrates by pulsed laser deposition technique. As-grown films were thermally treated in the flow of molecular H2 at 200°C during 24 hours. Comparison between electric characteristics measured before and after hydrogenation showed sufficient changes of the film resistance and appearance of photosensitivity in the visible wavelength range. Study of current-voltage characteristics of the films revealed appearance and significant change of diode-like properties.

A1Bi3C6 Thin Films as NO Sensors

2006 ◽  
Vol 915 ◽  
Author(s):  
Halyna Khlyap ◽  
Violetta Bilozertseva ◽  
Nina Dyakonenko ◽  
Dmitrii Gaman ◽  
Andrey Mamalui ◽  
...  
Keyword(s):  
Thin Films ◽  
Room Temperature ◽  
Film Surface ◽  
Electrophysical Properties ◽  
Growth Morphology ◽  
Vacuum Level ◽  
Glass Substrates ◽  
Aggressive Environment ◽  
Vacuum Technology ◽  
Before And After

AbstractThe paper reports experimental data on growth, morphology, NO sensitivity and electrophysical properties of A1Bi3C6 thin films obtained by means of simple vacuum technology. The investigated samples were condensed onto the glass substrates under deposition rate 0.1-0.5 nm/s at T = 300 K and vacuum level P = 10-3 Pa. AFM investigations of the film surface before and after interaction with aggressive environment demonstrated sufficient sensitivity of the film relief to the aggressive component. Room-temperature electric field-induced characteristics were investigated for metal-semiconductor (MS) Cr/NaBiTe2 structures.

Smart Heterostructures Based on Solid Solution ZnCdHgTe

2003 ◽  
Vol 785 ◽  
Author(s):  
Galina M. Khlyap ◽  
Petro G. Sydorchuk ◽  
Jacek Polit ◽  
Macej Oszwaldowsky
Keyword(s):  
Thin Films ◽  
Solid Solution ◽  
Spectral Range ◽  
Room Temperature ◽  
Signal Frequency ◽  
Applied Bias ◽  
Current Voltage ◽  
Wide Range ◽  
Capacitance Voltage ◽  
First Time

ABSTRACTCurrent – voltage (IVC) and capacitance – voltage (CVC) of heterostructures (Cd, Zn)Te/ZnCdHgTe are studied for the first time. Thin films ZnxCdyHg1-x-yTe were grown on monocrystalline (111) CdTe and ZnTe substrates by PLE technology. Deposition was carried out on substrates held at temperatures near 290 K. The thickness of investigated films was estimated to be about 5 μm. Electric characteristics of the as-grown structures were examined under T = 77–290 K in the wide range of applied bias. All investigated samples have demonstrated diode-like IVC and CVC under test signal frequency f = 1 kHz. Heterostructures CdTe/ZnCdHgTe have exhibited a room temperature photosensitivity in spectral range 0.50–0.65 μm.

scholarly journals Reactive Dual Magnetron Sputtering: A Fast Method for Preparing Stoichiometric Microcrystalline ZnWO4 Thin Films

Surfaces ◽  
2021 ◽  
Vol 4 (2) ◽  
pp. 106-114
Author(s):  
Yannick Hermans ◽  
Faraz Mehmood ◽  
Kerstin Lakus-Wollny ◽  
Jan P. Hofmann ◽  
Thomas Mayer ◽  
...  
Keyword(s):  
Thin Films ◽  
Magnetron Sputtering ◽  
Photoelectron Spectroscopy ◽  
Fast Method ◽  
X Ray Diffraction ◽  
X Ray ◽  
Glass Substrates ◽  
Post Annealing ◽  
Rf Signal ◽  
First Time

Thin films of ZnWO4, a promising photocatalytic and scintillator material, were deposited for the first time using a reactive dual magnetron sputtering procedure. A ZnO target was operated using an RF signal, and a W target was operated using a DC signal. The power on the ZnO target was changed so that it would match the sputtering rate of the W target operated at 25 W. The effects of the process parameters were characterized using optical spectroscopy, X-ray diffraction, and scanning electron microscopy, including energy dispersive X-ray spectroscopy as well as X-ray photoelectron spectroscopy. It was found that stoichiometric microcrystalline ZnWO4 thin films could be obtained, by operating the ZnO target during the sputtering procedure at a power of 55 W and by post-annealing the resulting thin films for at least 10 h at 600 °C. As FTO coated glass substrates were used, annealing led as well to the incorporation of Na, resulting in n+ doped ZnWO4 thin films.

Thermal conversion of CBD grown ZnS thin films to ZnO

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Kooliyankal Naseema ◽  
Kaniyamkandy Ribin ◽  
Nidiyanga Navya ◽  
Prasoon Prasannan
Keyword(s):  
Thin Films ◽  
Low Cost ◽  
Thermal Conversion ◽  
X Ray Diffraction ◽  
Xrd Pattern ◽  
Glass Substrates ◽  
Anion Substitution ◽  
Nano Crystalline ◽  
Before And After ◽  
Uv Visible

AbstractNano crystalline zinc sulfide thin films were deposited onto glass substrates by chemical bath deposition method. One of the samples was annealed at 300 °C for 2 h in air using a muffle furnace. The prepared thin films were investigated by X-ray diffraction (XRD), UV–visible spectroscopy (UV–vis), photoluminescence spectroscopy (PL), scanning electron microscopy (SEM) and Raman spectroscopy (FT-R) studies before and after annealing. The analysis confirmed the thermal-induced anion substitution and conversion of ZnS crystal to ZnO wurtzite crystal. XRD pattern showed that these films were phase pure and polycrystalline in nature. Optical band gap was found to be 3.86 eV for ZnS and 3.21 eV for ZnO. The films prepared by this simple, low-cost technique are suitable for photovoltaic and optoelectronic applications.

scholarly journals Effect of Pb dopant On A.C mechanism of ZnS thin films

2019 ◽  
Vol 12 (25) ◽  
pp. 80-88
Author(s):  
Salma M. Shaban
Keyword(s):  
Thin Films ◽  
Room Temperature ◽  
Atomic Weight ◽  
Thickness Effect ◽  
Frequency Effect ◽  
Frequency Range ◽  
Glass Substrates ◽  
Evaporation Technique ◽  
Vacuum Evaporation Technique ◽  
Effect Of Doping

Vacuum evaporation technique was used to prepare pure and doped ZnS:Pb thin films at10% atomic weight of Pb element onto glass substrates at room temperature for 200 nm thickness. Effect of doping on a.c electrical properties such as, a.c conductivity, real, and imaginary parts of dielectric constant within frequency range (10 KHz - 10 MHz) are measured. The frequency dependence of a.c conductivity is matched with correlated barrier hoping especially at higher frequency. Effect of doping on behavior of a.c mechanism within temperature range 298-473 K was studied.

scholarly journals Optical and Structural Properties of CdS Quantum Dots Synthesized Using (MW-CBD) Technique

2020 ◽  
pp. 44-52
Author(s):  
Ahmed Ahmed S. Abed ◽  
Sattar J. Kasim ◽  
Abbas F. Abbas
Keyword(s):  
Thin Films ◽  
Quantum Dots ◽  
Room Temperature ◽  
Energy Gap ◽  
Cds Nanoparticles ◽  
Cds Quantum Dots ◽  
Optical Energy Gap ◽  
Glass Substrates ◽  
High Adhesion ◽  
Uv Visible

In the present study, the microwave heating method was used to prepare cadmium sulfide quantum dots CdSQDs films. CdS nanoparticles size average obtained as (7nm). The morphology, structure and composition of prepared CdSQDs were examined using (FE-SEM), (XRD) and (EDX). Optical properties of CdSQDs thin films formed and deposited onto glass substrates have been studied at room temperature using UV/ Visible spectrophotometer within the wavelength of (300-800nm), and Photoluminescence (PL) spectrum. The optical energy gap (Eg) which estimated using Tauc relation was equal (2.6eV). Prepared CdS nanoparticles thin films are free from cracks, pinholes and have high adhesion to substrate.

Fe doping-stabilized γ-Ga2O3 thin films with a high room temperature saturation magnetic moment

2020 ◽  
Vol 8 (2) ◽  
pp. 536-542 ◽  
Author(s):  
Yuanqi Huang ◽  
Ang Gao ◽  
Daoyou Guo ◽  
Xia Lu ◽  
Xiao Zhang ◽  
...  
Keyword(s):  
Thin Film ◽  
Thin Films ◽  
Magnetic Moment ◽  
Room Temperature ◽  
Fe Doping ◽  
Saturation Magnetic Moment ◽  
First Time

A thermostable Fe-doped γ-Ga2O3 thin film with a high room temperature saturation magnetic moment of 5.73 μB/Fe has been obtained for the first time.

Sign in / Sign up

Export Citation Format

Share Document