Three Lowest Optical Modes Simultaneous Generator based on Silicon Multimode interference and Y-Junction Couplers

Author(s):  
Duong Quang Duy ◽  
Ho Duc Tam Linh ◽  
Truong Cao Dung ◽  
Nguyen Tan Hung ◽  
Dang Hoai Bac ◽  
...  
Author(s):  
Linh Duc Tam Ho

We propose a new design of a 2x2 optical chip for switching optical modes based on silicon material. Input lights at fundamental mode of transverse electric (TE) polarization can be selected at the output by appropriately controlling a 180-degree butterfly-shaped phase shifter. The proposed device consists of two multimode interference waveguides MMI and a phase shifter packed in a compact size of 4.2μm x 0.22μm x 110.4μm. We use 3D-BPM numerical simulation method to evaluate optical conversion efficiency of device. The result shows that insertion loss is always less than 1.5dB and crosstalk is always below -30dB in a wavelength range from 1.5  to 1.6 . Moreover, we continue to evaluate the proposed device on the system with signal’s bitrate of 35Gbps, the bit error rate is always less than 10-10 in the whole bandwidth of 100nm.


Sensors ◽  
2021 ◽  
Vol 21 (9) ◽  
pp. 3254
Author(s):  
Yuri Hayashi Isayama ◽  
Hugo Enrique Hernández-Figueroa

A generalization of the concept of multimode interference sensors is presented here for the first time, to the best of our knowledge. The existing bimodal and trimodal sensors correspond to particular cases of those interference sensors. A thorough study of the properties of the multimode waveguide section provided a deeper insight into the behavior of this class of sensors, which allowed us to establish new criteria for designing more sensitive structures. Other challenges of using high-order modes within the sensing area of the device reside in the excitation of these modes and the interpretation of the output signal. To overcome these, we developed a novel structure to excite any desired high-order mode along with the fundamental mode within the sensing section, while maintaining a fine control over the power distribution between them. A new strategy to detect and interpret the output signal is also presented in detail. Finally, we designed a high-order sensor for which numerical simulations showed a theoretical limit of detection of 1.9×10−7 RIU, making this device the most sensitive multimode interference sensor reported so far.


2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Ruishi Qi ◽  
Ning Li ◽  
Jinlong Du ◽  
Ruochen Shi ◽  
Yang Huang ◽  
...  

AbstractDirectly mapping local phonon dispersion in individual nanostructures can advance our understanding of their thermal, optical, and mechanical properties. However, this requires high detection sensitivity and combined spatial, energy and momentum resolutions, thus has been elusive. Here, we demonstrate a four-dimensional electron energy loss spectroscopy technique, and present position-dependent phonon dispersion measurements in individual boron nitride nanotubes. By scanning the electron beam in real space while monitoring both the energy loss and the momentum transfer, we are able to reveal position- and momentum-dependent lattice vibrations at nanometer scale. Our measurements show that the phonon dispersion of multi-walled nanotubes is locally close to hexagonal-boron nitride crystals. Interestingly, acoustic phonons are sensitive to defect scattering, while optical modes are insensitive to small voids. This work not only provides insights into vibrational properties of boron nitride nanotubes, but also demonstrates potential of the developed technique in nanoscale phonon dispersion measurements.


Nanomaterials ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 998
Author(s):  
Diego R. Abujetas ◽  
José A. Sánchez-Gil

Resonant optical modes arising in all-dielectric metasurfaces have attracted much attention in recent years, especially when so-called bound states in the continuum (BICs) with diverging lifetimes are supported. With the aim of studying theoretically the emergence of BICs, we extend a coupled electric and magnetic dipole analytical formulation to deal with the proper metasurface Green function for the infinite lattice. Thereby, we show how to excite metasurface BICs, being able to address their near-field pattern through point-source excitation and their local density of states. We apply this formulation to fully characterize symmetry-protected BICs arising in all-dielectric metasurfaces made of Si nanospheres, revealing their near-field pattern and local density of states, and, thus, the mechanisms precluding their radiation into the continuum. This formulation provides, in turn, an insightful and fast tool to characterize BICs (and any other leaky/guided mode) near fields in all-dielectric (and also plasmonic) metasurfaces, which might be especially useful for the design of planar nanophotonic devices based on such resonant modes.


Photonics ◽  
2021 ◽  
Vol 8 (2) ◽  
pp. 52
Author(s):  
Yue Liu ◽  
Jifang Qiu ◽  
Chang Liu ◽  
Yan He ◽  
Ran Tao ◽  
...  

An optical analog-to-digital converter (OADC) scheme with enhanced bit resolution by using a multimode interference (MMI) coupler as optical quantization is proposed. The mathematical simulation model was established to verify the feasibility and to investigate the robustness of the scheme. Simulation results show that 20 quantization levels (corresponding to 4.32 of effective number of bits (ENOB)) are realized by using only 6 channels, which indicates that the scheme requires much fewer quantization channels or modulators to realize the same amount of ENOB. The scheme is robust and potential for integration.


2021 ◽  
Vol 533 (5) ◽  
pp. 2170019
Author(s):  
Hong Yang ◽  
Guo‐Qing Qin ◽  
Hao Zhang ◽  
Xuan Mao ◽  
Min Wang ◽  
...  

Actuators ◽  
2020 ◽  
Vol 10 (1) ◽  
pp. 7
Author(s):  
Kainan Wang ◽  
Thomas Godfroid ◽  
Damien Robert ◽  
André Preumont

This paper discusses the design and manufacturing of a thin polymer spherical adaptive reflector of diameter D=200 mm, controlled by an array of 25 independent electrodes arranged in a keystone configuration actuating a thin film of PVDF-TrFE in d31-mode. The 5 μm layer of electrostrictive material is spray-coated. The results of the present study confirm that the active material can be modelled by a unidirectional quadratic model and that excellent properties can be achieved if the material is properly annealed. The experimental influence functions of the control electrodes are determined by a quasi-static harmonic technique; they are in good agreement with the numerical simulations and their better circular symmetry indicates a clear improvement in the manufacturing process, as compared to a previous study. The low order optical modes can be reconstructed by combining the 25 influence functions; a regularization technique is used to alleviate the ill-conditioning of the Jacobian and allow to approximate the optical modes with reasonable voltages.


Sensors ◽  
2021 ◽  
Vol 21 (4) ◽  
pp. 1164
Author(s):  
Gongli Xiao ◽  
Yanping Xu ◽  
Hongyan Yang ◽  
Zetao Ou ◽  
Jianyun Chen ◽  
...  

Herein, we propose a tunable plasmonic sensor with Fano resonators in an inverted U-shaped resonator. By manipulating the sharp asymmetric Fano resonance peaks, a high-sensitivity refractive index sensor can be realized. Using the multimode interference coupled-mode theory and the finite element method, we numerically simulate the influences of geometrical parameters on the plasmonic sensor. Optimizing the structure parameters, we can achieve a high plasmonic sensor with the maximum sensitivity for 840 nm/RIUand figure of merit for 3.9 × 105. The research results provide a reliable theoretical basis for designing high sensitivity to the next generation plasmonic nanosensor.


Author(s):  
Shun Wang ◽  
Panting Niu ◽  
Shuhui Liu ◽  
Shun Wu ◽  
Rui-Bo Jin ◽  
...  

2021 ◽  
pp. 100125
Author(s):  
Jonas H. Osório ◽  
William M. Guimarães ◽  
Lu Peng ◽  
Marcos A.R. Franco ◽  
Stephen C. Warren-Smith ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document