The impact of spiders and high temperatures on cereal aphid (Rhopalosiphum padi) numbers in an irrigated perennial grass pasture in South Australia

1992 ◽  
Vol 121 (1) ◽  
pp. 19-26 ◽  
Author(s):  
PAUL J. DE BARRO
Keyword(s):  
High Temperatures ◽  
Rhopalosiphum Padi ◽  
Perennial Grass ◽  
South Australia ◽  
Cereal Aphid ◽  
The Impact

Influence of High-Temperatures on the Survival of Rhopalosiphum-Padi (L) (Hemiptera, Aphididae) in Irrigated Perennial Grass Pastures in South-Australia

1993 ◽  
Vol 41 (2) ◽  
pp. 123 ◽  
Author(s):  
PJ Debarro ◽  
DA Maelzer
Keyword(s):  
Field Experiment ◽  
Rhopalosiphum Padi ◽  
Perennial Grass ◽  
South Australia ◽  
Maximum Temperature ◽  
Daily Maximum Temperature ◽  
Daily Maximum ◽  
Air Temperatures ◽  
Exposure Temperature ◽  
C 32

A field experiment in a perennial grass pasture showed that the survival of Rhopalosiphum padi (L.) (Hemiptera: Aphididae) was reduced when aphids were exposed to air temperatures of at least 36-degrees-C (32-degrees-C at the base of the sward). The longevity, rate of reproduction and fecundity of individuals also declined as the exposure temperature and duration of exposure increased. The results of the field experiment were later corroborated by sampling an aphid population every 4-6 days over summer and regressing aphid numbers on daily maximum temperature and duration of exposure to temperature. A model is proposed to estimate the numbers of aphids that survive in refuge areas over summer in relation to temperature-induced mortality.

The yield of perennial grass stands on drained organic soils of Steppe

2016 ◽  
Vol 1 (90) ◽  
pp. 92-97
Author(s):  
I.T. Slusar ◽  
V.A. Serbenyuk ◽  
A.N. Gera ◽  
A.P. Solyanik ◽  
A.A. Tarasenko
Keyword(s):  
Zinc Sulphate ◽  
Foliar Application ◽  
Perennial Grass ◽  
Mineral Fertilizer ◽  
Dry Weight ◽  
Research Area ◽  
Organic Soils ◽  
Growth Promoters ◽  
Cobalt Sulfate ◽  
The Impact

Research on the impact of the introduction of micro fertilizers and growth promoters on a background of mineral fertilizer and without N90R45К120 spent on old peat in shallow carbonate floodplain r.Supiy, Yahotyn Kyiv region. Power peat horizon about 60-70 cm, 7,4-7,6 pH of the aqueous extract, stupas schedule 56-60%, density 0,49-0,52 assembly soil, total nitrogen content (%) - 1.9; gross forms of phosphorus - 0,4, potassium 0.2, 20% lime. In experiments studying biological rehoplant, radustym, Biolan, emistim, Jets, humisol, plantafol, radyfarm and micronutrients: copper, boric acid, manganese sulphate, zinc sulphate, potassium humates. Treatment drugs conducted in the spring by spraying mixtures. Space research area of 60 m2, three-time repetition. It is established that the use of growth stimulants and micronutrients in the background N90R45К120 provided the highest yield mixtures of years, against making BIOLan - 9.9 t / ha Radyfarmu - 9.6 t / ha Radostymu 9.3 t / ha dry weight. In areas for making other preparations were intermediate yield growth rates - 0.5 - 2.0 t / ha dry weight. Also good gains herbage yields obtained by making all kinds of micronutrients and growth stimulants in the background without making makrodobryv which was within 5.3 - 6.9 t / ha to control without fertilization - 4.5 t / ha dry weight. In deep peat copper fertilizer (25 kg / ha of copper sulphate or 5 kg / ha pirytnoho cinders) in all zones should be making every 3-4 years, and zinc, cobalt and molybdenum advisable to make time for the growing season, spring, by foliar application in such numbers: ammonium molibdenovokyslyy - 0.3 kg / ha; cobalt sulfate - 3 kg / ha zinc sulphate 0.5 kg / ha or placers these salts should be mixed with major fertilizer.

scholarly journals The impact of point defects in n-type GaN layers on thermal decomposition of InGaN/GaN QWs

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Mikolaj Grabowski ◽  
Ewa Grzanka ◽  
Szymon Grzanka ◽  
Artur Lachowski ◽  
Julita Smalc-Koziorowska ◽  
...  
Keyword(s):  
Quantum Wells ◽  
High Temperatures ◽  
Point Defects ◽  
X Ray Diffraction ◽  
Helium Ions ◽  
X Ray ◽  
Sapphire Substrates ◽  
Transmission Electron ◽  
The Impact ◽  
Ingan Quantum Wells

AbstractThe aim of this paper is to give an experimental evidence that point defects (most probably gallium vacancies) induce decomposition of InGaN quantum wells (QWs) at high temperatures. In the experiment performed, we implanted GaN:Si/sapphire substrates with helium ions in order to introduce a high density of point defects. Then, we grew InGaN QWs on such substrates at temperature of 730 °C, what caused elimination of most (but not all) of the implantation-induced point defects expanding the crystal lattice. The InGaN QWs were almost identical to those grown on unimplanted GaN substrates. In the next step of the experiment, we annealed samples grown on unimplanted and implanted GaN at temperatures of 900 °C, 920 °C and 940 °C for half an hour. The samples were examined using Photoluminescence, X-ray Diffraction and Transmission Electron Microscopy. We found out that the decomposition of InGaN QWs started at lower temperatures for the samples grown on the implanted GaN substrates what provides a strong experimental support that point defects play important role in InGaN decomposition at high temperatures.

scholarly journals Influence of Fabric Weave on Thermal Radiation Resistance and Water Vapor Permeability

Polymers ◽  
2020 ◽  
Vol 12 (3) ◽  
pp. 525
Author(s):  
Ana Kiš ◽  
Snježana Brnada ◽  
Stana Kovačević
Keyword(s):  
High Temperatures ◽  
High Performance ◽  
Thermal Protection ◽  
Water Vapor Permeability ◽  
Radiant Heat ◽  
The Body ◽  
Vapor Permeability ◽  
Weave Structure ◽  
Fabric Structures ◽  
The Impact

In this work, aramid fibers were used to develop new, high-performance fabrics for high-temperature protective clothing. The research was based on the impact of the weave structure on fabric resistance to radiant heat. The goals of the research were primarily related to the development of new fabric structures created by the weave structure, which gives better protection of the body against high temperatures in relation to the standard weave structures that are used today. According to the results obtained it can be concluded that the fabric weave significantly affects the fabric structure, which consequently determines the effectiveness of protection against high temperatures. The justification for the use of multi-weft and strucks weave structure, which provides greater thermal protection and satisfactory breathability than commonly used weave structures, was ascertained.

Analysis of Ferroelectric Microcapacitors by Scanning Probe Microscope

2004 ◽  
Vol 811 ◽  
Author(s):  
Nobuhiro Kin ◽  
Koichiro Honda
Keyword(s):  
High Temperatures ◽  
Low Temperatures ◽  
Evaluation System ◽  
Ferroelectric Material ◽  
Scanning Probe Microscope ◽  
Scanning Probe ◽  
Electrical Heater ◽  
Device Processing ◽  
Probe Microscope ◽  
The Impact

ABSTRACTTo develop higher density FRAM requires reducing cell size. Therefore, the size effects resulting from device processing and the material's physical properties must be measured. Therefore, analyzing the electric characteristics of a single bit cell capacitor has become important. Two known characteristics of ferroelectric material are that the Vc increases at low temperatures, and the Pr falls at high temperatures. To further evaluate the impact of temperature on ferroelectrics, we constructed a new evaluation system based on a scanning probe microscope, that can measure the electric characteristics of a single bit cell capacitor. This system can be used in the temperature range from −120 degrees to 300 degrees C. We accomplished this by circulating liquid nitrogen around a SPM stage and by using an electrical heater. We measured the electrical properties of ferroelectric microcapacitors by using a sample with IrOx/PZT/Pt structure. Our measurements revealed that 2Pr really increases at low temperatures, and Pr decreases at high temperatures. That is, we have shown that Vc increases 30% at low temperatures and Pr decreases 10% also in an actual FRAM single bit cell capacitor.

Trophic interactions between three species of cereal aphid (Hemiptera: Aphididae) and spring wheat (Poaceae): implications for pest management

2007 ◽  
Vol 139 (6) ◽  
pp. 850-863 ◽  
Author(s):  
Samuel M. Migui ◽  
Robert J. Lamb
Keyword(s):  
Spring Wheat ◽  
Trophic Interactions ◽  
Plant Biomass ◽  
Rhopalosiphum Padi ◽  
Aphid Species ◽  
Economic Damage ◽  
Cereal Aphids ◽  
Cereal Aphid ◽  
Economic Thresholds ◽  
Specific Impact

AbstractThe susceptibilities of genetically diverse Canadian spring wheats, Triticum aestivum L. and Triticum durum Desf., to three aphid species, Rhopalosiphum padi (L.), Sitobion avenae (Fabricius), and Schizaphis graminum (Rondani), were investigated. Trophic interactions measured as changes in biomass of aphids and wheat plants were used to quantify levels of resistance, components of resistance, and impact of aphids on yield. Plants in field cages were infested with small numbers of aphids for 21 days at heading. These plants were usually more suitable for the development of S. avenae and S. graminum than of R. padi. Partial resistance, measured as seed production by infested plants as a proportion of that by a control, varied from 11% to 59% for different aphid species and wheat classes when all wheat plants were infested at the same stage. Cultivars within wheat classes responded similarly to each of the aphid species. None of the wheat cultivars showed agriculturally effective levels of antibiosis. The specific impact of each aphid species and wheat class varied from 5 to 15 mg of plant biomass lost for each milligram of biomass gained by the aphids. Canadian Western Red Spring wheat had a lower specific impact and therefore was more tolerant to aphids than the other two classes, but not tolerant enough to avoid economic damage at the aphid densities observed. Plants did not compensate for feeding damage after aphid feeding ceased, based on the higher specific impacts observed for mature plants than for plants that were heading. The interactions between aphids and plants show that current economic thresholds probably underestimate the damage caused by cereal aphids to Canadian spring wheat.

scholarly journals Impact of High Temperature on Post-Exercise Albuminuria in Dogs

Animals ◽  
2020 ◽  
Vol 10 (11) ◽  
pp. 1988
Author(s):  
Urszula Pasławska ◽  
Barbara Szczepankiewicz ◽  
Aleksandra Bednarska ◽  
Robert Pasławski
Keyword(s):  
High Temperatures ◽  
Healthy Adult ◽  
Statistical Significance ◽  
Abdominal Ultrasound ◽  
Strenuous Exercise ◽  
Movement Activity ◽  
Post Exercise ◽  
Intensive Exercise ◽  
Before And After ◽  
The Impact

The literature suggests that strenuous exercise and exposure to high temperatures may cause physiologic proteinuria, but to our knowledge there have been no studies that have assessed the effect of high temperatures on the occurrence of post-exercise albuminuria in dogs. The goal of the study was to assess the impact of high temperatures on the occurrence of albuminuria. Thirteen healthy adult dogs—eight female (62%) and five male (38%) had to run 5 km at a temperature of 25 °C in grasslands which took about 30–40 min. Dogs underwent clinical examinations: echocardiography, abdominal ultrasound, blood hematology and biochemistry and urinalysis, including the ratio of albumin to creatinine (UAC). Baseline UAC was on the borderline of statistical significance for female dogs, but not for male dogs, before and after exercise. UAC was 0.31 ± 0.56 mg/mmol for female dogs and 0.36 ± 0.60 mg/mmol in male dogs before exercise. Immediately after exercise, UAC was 0.51 ± 0.58 mg/mmol in female dogs and 0.31 ± 0.40 mg/mmol in male dogs. Thus, a period of about 30–40 min of intensive exercise at high temperatures (25 °C) did not lead to increased albuminuria. This suggests that there is no need to limit the movement activity before urine tests in dogs, even at high temperatures, before urinalysis.

Sign in / Sign up

Export Citation Format

Share Document