scholarly journals Sediment yield over glacial cycles: A conceptual model

Author(s):  
Gilles Antoniazza ◽  
Stuart N Lane

The temporal variability in sediment export yield from glaciers over a timescale of multiple glacial cycles (e.g. 1 × 102 − 1 × 106 years) is of interest for a wide range of applications in glaciology, sedimentology, geomorphology, climatology and environmental engineering. However, the time required for the products of glacial erosion to be transferred through glaciated catchments and the extent to which glacially-conditioned sediment can be transiently stored within them are still poorly constrained and a matter of debate within the community. We propose a conceptual model of the variability in sediment exported from glaciers over multiple glacial cycles based on a literature review. Sediment yield is likely to be highly variable through a glacial cycle, notably between phases of glacier advance, retreat and re-advance due to changes in ice velocity and erosion rates, ice and meltwater transport capacity, and in glacially-conditioned sediment accessibility at the bed. Typically, early phases of glacier retreat and re-advance are expected to lead to the highest increase in sediment yield due to the ease with which the products of bedrock erosion can be accessed and reworked. In contrast, later phases of glacial (re)advance, once glacially-conditioned sedimentary sources become exhausted, may be characterized by intermediate rates of sediment export yield maintained through bedrock erosion. The latest phases of deglaciation, once glacially-conditioned sedimentary sources are either exhausted, stabilized or disconnected from active processes of sediment transfer, are likely to have the lowest rate of export. The conceptual model proposed in this paper fills a gap in the literature by developing a continuous pattern of sediment yield rate variability over the course of multiple glacial cycles, with wider implications for future research. However, its systematic applicability to various glacier settings and glaciations needs more field and modeling data to validate it.

2014 ◽  
Vol 70 (7) ◽  
Author(s):  
Christiono Utomo ◽  
Rosli Mohamad Zin ◽  
Rozana Zakaria ◽  
Yani Rahmawati

A group decision must be made when a design process is conducted by more than one person. In this situation, negotiation plays an important role in many design decision. Value Management (VM) is one of design decision methodology in construction. By involving multi disciplines, collaboration and teamwork, negotiation becomes an important role on VM using a value-based group design decision. This paper provides an approach to develop a conceptual model of agreement options for group decision in building wall system selection using value criteria which are function and cost. The characteristic of value criteria has not been applied on previous researches. Existing models which are commonly accepted are optimization-based models, for example aggregation methods, but these are not able to solve the problem of value criteria on VM. Group decision needs to identify the goals that can be optimized and those that can be compromised in order to reach an agreement among decision makers. Agreement options are determined by identifying the potential decision makers followed by determining the optimal solution for each sub-group. Five stages are conducted to identify and determine agreement options as a conceptual model which are determining the weighting factor of criteria for each decision maker; grading alternative for each evaluation criteria; scoring every alternative for every decision maker; determining the optimal solution; and determining the fitness factor of an alternative solution The agreement option model is facilitated to better design decision. The model developed in this research can be used for any development research on group decision and negotiation in design process within the construction industry. Future research in the application of this methodology in many field of decision will build a wide range of knowledge to solve the theoretical and practical gap between automated design and automated negotiation.  


Author(s):  
Anthony S-Y Leong ◽  
David W Gove

Microwaves (MW) are electromagnetic waves which are commonly generated at a frequency of 2.45 GHz. When dipolar molecules such as water, the polar side chains of proteins and other molecules with an uneven distribution of electrical charge are exposed to such non-ionizing radiation, they oscillate through 180° at a rate of 2,450 million cycles/s. This rapid kinetic movement results in accelerated chemical reactions and produces instantaneous heat. MWs have recently been applied to a wide range of procedures for light microscopy. MWs generated by domestic ovens have been used as a primary method of tissue fixation, it has been applied to the various stages of tissue processing as well as to a wide variety of staining procedures. This use of MWs has not only resulted in drastic reductions in the time required for tissue fixation, processing and staining, but have also produced better cytologic images in cryostat sections, and more importantly, have resulted in better preservation of cellular antigens.


2019 ◽  
Vol 50 (4) ◽  
pp. 693-702 ◽  
Author(s):  
Christine Holyfield ◽  
Sydney Brooks ◽  
Allison Schluterman

Purpose Augmentative and alternative communication (AAC) is an intervention approach that can promote communication and language in children with multiple disabilities who are beginning communicators. While a wide range of AAC technologies are available, little is known about the comparative effects of specific technology options. Given that engagement can be low for beginning communicators with multiple disabilities, the current study provides initial information about the comparative effects of 2 AAC technology options—high-tech visual scene displays (VSDs) and low-tech isolated picture symbols—on engagement. Method Three elementary-age beginning communicators with multiple disabilities participated. The study used a single-subject, alternating treatment design with each technology serving as a condition. Participants interacted with their school speech-language pathologists using each of the 2 technologies across 5 sessions in a block randomized order. Results According to visual analysis and nonoverlap of all pairs calculations, all 3 participants demonstrated more engagement with the high-tech VSDs than the low-tech isolated picture symbols as measured by their seconds of gaze toward each technology option. Despite the difference in engagement observed, there was no clear difference across the 2 conditions in engagement toward the communication partner or use of the AAC. Conclusions Clinicians can consider measuring engagement when evaluating AAC technology options for children with multiple disabilities and should consider evaluating high-tech VSDs as 1 technology option for them. Future research must explore the extent to which differences in engagement to particular AAC technologies result in differences in communication and language learning over time as might be expected.


2015 ◽  
Vol 25 (1) ◽  
pp. 15-23 ◽  
Author(s):  
Ryan W. McCreery ◽  
Elizabeth A. Walker ◽  
Meredith Spratford

The effectiveness of amplification for infants and children can be mediated by how much the child uses the device. Existing research suggests that establishing hearing aid use can be challenging. A wide range of factors can influence hearing aid use in children, including the child's age, degree of hearing loss, and socioeconomic status. Audiological interventions, including using validated prescriptive approaches and verification, performing on-going training and orientation, and communicating with caregivers about hearing aid use can also increase hearing aid use by infants and children. Case examples are used to highlight the factors that influence hearing aid use. Potential management strategies and future research needs are also discussed.


2009 ◽  
Vol 23 (4) ◽  
pp. 191-198 ◽  
Author(s):  
Suzannah K. Helps ◽  
Samantha J. Broyd ◽  
Christopher J. James ◽  
Anke Karl ◽  
Edmund J. S. Sonuga-Barke

Background: The default mode interference hypothesis ( Sonuga-Barke & Castellanos, 2007 ) predicts (1) the attenuation of very low frequency oscillations (VLFO; e.g., .05 Hz) in brain activity within the default mode network during the transition from rest to task, and (2) that failures to attenuate in this way will lead to an increased likelihood of periodic attention lapses that are synchronized to the VLFO pattern. Here, we tested these predictions using DC-EEG recordings within and outside of a previously identified network of electrode locations hypothesized to reflect DMN activity (i.e., S3 network; Helps et al., 2008 ). Method: 24 young adults (mean age 22.3 years; 8 male), sampled to include a wide range of ADHD symptoms, took part in a study of rest to task transitions. Two conditions were compared: 5 min of rest (eyes open) and a 10-min simple 2-choice RT task with a relatively high sampling rate (ISI 1 s). DC-EEG was recorded during both conditions, and the low-frequency spectrum was decomposed and measures of the power within specific bands extracted. Results: Shift from rest to task led to an attenuation of VLFO activity within the S3 network which was inversely associated with ADHD symptoms. RT during task also showed a VLFO signature. During task there was a small but significant degree of synchronization between EEG and RT in the VLFO band. Attenuators showed a lower degree of synchrony than nonattenuators. Discussion: The results provide some initial EEG-based support for the default mode interference hypothesis and suggest that failure to attenuate VLFO in the S3 network is associated with higher synchrony between low-frequency brain activity and RT fluctuations during a simple RT task. Although significant, the effects were small and future research should employ tasks with a higher sampling rate to increase the possibility of extracting robust and stable signals.


Author(s):  
Trần Thanh Nhàn

In order to observe the end of primary consolidation (EOP) of cohesive soils with and without subjecting to cyclic loading, reconstituted specimens of clayey soils at various Atterberg’s limits were used for oedometer test at different loading increments and undrained cyclic shear test followed by drainage with various cyclic shear directions and a wide range of shear strain amplitudes. The pore water pressure and settlement of the soils were measured with time and the time to EOP was then determined by different methods. It is shown from observed results that the time to EOP determined by 3-t method agrees well with the time required for full dissipation of the pore water pressure and being considerably larger than those determined by Log Time method. These observations were then further evaluated in connection with effects of the Atterberg’s limit and the cyclic loading history.


2020 ◽  
Author(s):  
Sina Faizollahzadeh Ardabili ◽  
Amir Mosavi ◽  
Pedram Ghamisi ◽  
Filip Ferdinand ◽  
Annamaria R. Varkonyi-Koczy ◽  
...  

Several outbreak prediction models for COVID-19 are being used by officials around the world to make informed-decisions and enforce relevant control measures. Among the standard models for COVID-19 global pandemic prediction, simple epidemiological and statistical models have received more attention by authorities, and they are popular in the media. Due to a high level of uncertainty and lack of essential data, standard models have shown low accuracy for long-term prediction. Although the literature includes several attempts to address this issue, the essential generalization and robustness abilities of existing models needs to be improved. This paper presents a comparative analysis of machine learning and soft computing models to predict the COVID-19 outbreak as an alternative to SIR and SEIR models. Among a wide range of machine learning models investigated, two models showed promising results (i.e., multi-layered perceptron, MLP, and adaptive network-based fuzzy inference system, ANFIS). Based on the results reported here, and due to the highly complex nature of the COVID-19 outbreak and variation in its behavior from nation-to-nation, this study suggests machine learning as an effective tool to model the outbreak. This paper provides an initial benchmarking to demonstrate the potential of machine learning for future research. Paper further suggests that real novelty in outbreak prediction can be realized through integrating machine learning and SEIR models.


2019 ◽  
Vol 20 (3) ◽  
pp. 251-264 ◽  
Author(s):  
Yinlu Feng ◽  
Zifei Yin ◽  
Daniel Zhang ◽  
Arun Srivastava ◽  
Chen Ling

The success of gene and cell therapy in clinic during the past two decades as well as our expanding ability to manipulate these biomaterials are leading to new therapeutic options for a wide range of inherited and acquired diseases. Combining conventional therapies with this emerging field is a promising strategy to treat those previously-thought untreatable diseases. Traditional Chinese medicine (TCM) has evolved for thousands of years in China and still plays an important role in human health. As part of the active ingredients of TCM, proteins and peptides have attracted long-term enthusiasm of researchers. More recently, they have been utilized in gene and cell therapy, resulting in promising novel strategies to treat both cancer and non-cancer diseases. This manuscript presents a critical review on this field, accompanied with perspectives on the challenges and new directions for future research in this emerging frontier.


2021 ◽  
Vol 7 (3) ◽  
pp. e001108
Author(s):  
Omar Heyward ◽  
Stacey Emmonds ◽  
Gregory Roe ◽  
Sean Scantlebury ◽  
Keith Stokes ◽  
...  

Women’s rugby (rugby league, rugby union and rugby sevens) has recently grown in participation and professionalisation. There is under-representation of women-only cohorts within applied sport science and medicine research and within the women’s rugby evidence base. The aims of this article are: Part 1: to undertake a systematic-scoping review of the applied sport science and medicine of women’s rugby, and Part 2: to develop a consensus statement on future research priorities. This article will be designed in two parts: Part 1: a systematic-scoping review, and Part 2: a three-round Delphi consensus method. For Part 1, systematic searches of three electronic databases (PubMed (MEDLINE), Scopus, SPORTDiscus (EBSCOhost)) will be performed from the earliest record. These databases will be searched to identify any sport science and medicine themed studies within women’s rugby. The Preferred Reporting Items for Systematic Reviews and Meta-analyses extension for Scoping Reviews will be adhered to. Part 2 involves a three-round Delphi consensus method to identify future research priorities. Identified experts in women’s rugby will be provided with overall findings from Part 1 to inform decision-making. Participants will then be asked to provide a list of research priority areas. Over the three rounds, priority areas achieving consensus (≥70% agreement) will be identified. This study has received institutional ethical approval. When complete, the manuscript will be submitted for publication in a peer-reviewed journal. The findings of this article will have relevance for a wide range of stakeholders in women’s rugby, including policymakers and governing bodies.


Author(s):  
Takeuchi Ayano

AbstractPublic participation has become increasingly necessary to connect a wide range of knowledge and various values to agenda setting, decision-making and policymaking. In this context, deliberative democratic concepts, especially “mini-publics,” are gaining attention. Generally, mini-publics are conducted with randomly selected lay citizens who provide sufficient information to deliberate on issues and form final recommendations. Evaluations are conducted by practitioner researchers and independent researchers, but the results are not standardized. In this study, a systematic review of existing research regarding practices and outcomes of mini-publics was conducted. To analyze 29 papers, the evaluation methodologies were divided into 4 categories of a matrix between the evaluator and evaluated data. The evaluated cases mainly focused on the following two points: (1) how to maintain deliberation quality, and (2) the feasibility of mini-publics. To create a new path to the political decision-making process through mini-publics, it must be demonstrated that mini-publics can contribute to the decision-making process and good-quality deliberations are of concern to policy-makers and experts. Mini-publics are feasible if they can contribute to the political decision-making process and practitioners can evaluate and understand the advantages of mini-publics for each case. For future research, it is important to combine practical case studies and academic research, because few studies have been evaluated by independent researchers.


Sign in / Sign up

Export Citation Format

Share Document