Design and Evaluation of a Tunable PUF Architecture for FPGAs

FPGA-based Physical Unclonable Functions (PUF) have emerged as a viable alternative to permanent key storage by turning effects of inaccuracies during the manufacturing process of a chip into a unique, FPGA-intrinsic secret. However, many fixed PUF designs may suffer from unsatisfactory statistical properties in terms of uniqueness, uniformity, and robustness. Moreover, a PUF signature may alter over time due to aging or changing operating conditions, rendering a PUF insecure in the worst case. As a remedy, we propose CHOICE , a novel class of FPGA-based PUF designs with tunable uniqueness and reliability characteristics. By the use of addressable shift registers available on an FPGA, we show that a wide configuration space for adjusting a device-specific PUF response is obtained without any sacrifice of randomness. In particular, we demonstrate the concept of address-tunable propagation delays, whereby we are able to increase or decrease the probability of obtaining “ 1 ”s in the PUF response. Experimental evaluations on a group of six 28 nm Xilinx Artix-7 FPGAs show that CHOICE PUFs provide a large range of configurations to allow a fine-tuning to an average uniqueness between 49% and 51%, while simultaneously achieving bit error rates below 1.5%, thus outperforming state-of-the-art PUF designs. Moreover, with only a single FPGA slice per PUF bit, CHOICE is one of the smallest PUF designs currently available for FPGAs. It is well-known that signal propagation delays are affected by temperature, as the operating temperature impacts the internal currents of transistors that ultimately make up the circuit. We therefore comprehensively investigate how temperature variations affect the PUF response and demonstrate how the tunability of CHOICE enables us to determine configurations that show a high robustness to such variations. As a case study, we present a cryptographic key generation scheme based on CHOICE PUF responses as device-intrinsic secret and investigate the design objectives resource costs, performance, and temperature robustness to show the practicability of our approach.

Overview of current and expected seasonal climatic anomalies for the winter 2021/2022 with their possible impact on the economy, as estimated by the meteorological services of the CIS countries

Based on assessments of the meteorological services of the CIS countries, the skill scores of the consensus forecast for the territory of Northern Eurasia for the summer of 2021 are presented. The results of monitoring circulation patterns in the stratosphere and troposphere over the past summer season are discussed. Climate monitoring and seasonal forecasting results for the current situation are presented. A probabilistic consensus forecast for air temperature and precipitation is presented for the upcoming winter season 2021/2022 in Northern Eurasia. Possible consequences of the impact of the expected anomalies of meteorological parameters on the economy sectors and social life are discussed. Keywords: North Eurasian Climate Forum, North Eurasian Climate Center, consensus forecast, air temperature, precipitation, large-scale atmospheric circulation, hydrodynamic models, sea surface temperature, impacts

Estimates of country level temperature-related mortality damage functions

Many studies project that climate change is expected to cause a significant number of excess deaths. Yet, in integrated assessment models that determine the social cost of carbon (SCC), human mortality impacts do not reflect the latest scientific understanding. We address this issue by estimating country-level mortality damage functions for temperature-related mortality with global spatial coverage. We rely on projections from the most comprehensive published study in the epidemiology literature of future temperature impacts on mortality (Gasparrini et al. in Lancet Planet Health 1:e360–e367, 2017), which estimated changes in heat- and cold-related mortality for 23 countries over the twenty-first century. We model variation in these mortality projections as a function of baseline climate, future temperature change, and income variables and then project future changes in mortality for every country. We find significant spatial heterogeneity in projected mortality impacts, with hotter and poorer places more adversely affected than colder and richer places. In the absence of income-based adaptation, the global mortality rate in 2080–2099 is expected to increase by 1.8% [95% CI 0.8–2.8%] under a lower-emissions RCP 4.5 scenario and by 6.2% [95% CI 2.5–10.0%] in the very high-emissions RCP 8.5 scenario relative to 2001–2020. When the reduced sensitivity to heat associated with rising incomes, such as greater ability to invest in air conditioning, is accounted for, the expected end-of-century increase in the global mortality rate is 1.1% [95% CI 0.4–1.9%] in RCP 4.5 and 4.2% [95% CI 1.8–6.7%] in RCP 8.5. In addition, we compare recent estimates of climate-change induced excess mortality from diarrheal disease, malaria and dengue fever in 2030 and 2050 with current estimates used in SCC calculations and show these are likely underestimated in current SCC estimates, but are also small compared to more direct temperature effects.

Temperature Impacts on Endurance and Read Disturbs in Charge-Trap 3D NAND Flash Memories

Temperature effects should be well considered when designing flash-based memory systems, because they are a fundamental factor that affect both the performance and the reliability of NAND flash memories. In this work, aiming to comprehensively understanding the temperature effects on 3D NAND flash memory, triple-level-cell (TLC) mode charge-trap (CT) 3D NAND flash memory chips were characterized systematically in a wide temperature range (−30~70 °C), by focusing on the raw bit error rate (RBER) degradation during program/erase (P/E) cycling (endurance) and frequent reading (read disturb). It was observed that (1) the program time showed strong dependences on the temperature and P/E cycles, which could be well fitted by the proposed temperature-dependent cycling program time (TCPT) model; (2) RBER could be suppressed at higher temperatures, while its degradation weakly depended on the temperature, indicating that high-temperature operations would not accelerate the memory cells’ degradation; (3) read disturbs were much more serious at low temperatures, while it helped to recover a part of RBER at high temperatures.

Experimental Evolution of West Nile Virus at Higher Temperatures Facilitates Broad Adaptation and Increased Genetic Diversity

West Nile virus (WNV, Flaviviridae, Flavivirus) is a mosquito-borne flavivirus introduced to North America in 1999. Since 1999, the Earth’s average temperature has increased by 0.6 °C. Mosquitoes are ectothermic organisms, reliant on environmental heat sources. Temperature impacts vector–virus interactions which directly influence arbovirus transmission. RNA viral replication is highly error-prone and increasing temperature could further increase replication rates, mutation frequencies, and evolutionary rates. The impact of temperature on arbovirus evolutionary trajectories and fitness landscapes has yet to be sufficiently studied. To investigate how temperature impacts the rate and extent of WNV evolution in mosquito cells, WNV was experimentally passaged 12 times in Culex tarsalis cells, at 25 °C and 30 °C. Full-genome deep sequencing was used to compare genetic signatures during passage, and replicative fitness was evaluated before and after passage at each temperature. Our results suggest adaptive potential at both temperatures, with unique temperature-dependent and lineage-specific genetic signatures. Further, higher temperature passage was associated with significantly increased replicative fitness at both temperatures and increases in nonsynonymous mutations. Together, these data indicate that if similar selective pressures exist in natural systems, increases in temperature could accelerate emergence of high-fitness strains with greater phenotypic plasticity.

Spider Mites Singly Infected With Either Wolbachia or Spiroplasma Have Reduced Thermal Tolerance

Heritable symbionts play an essential role in many aspects of host ecology in a temperature-dependent manner. However, how temperature impacts the host and their interaction with endosymbionts remains largely unknown. Here, we investigated the impact of moderate (20°C) and high (30 and 35°C) temperatures on symbioses between the spider mite Tetranychus truncatus and two maternally inherited endosymbionts (Wolbachia and Spiroplasma). We found that the thermal tolerance of mites (as measured by survival after heat exposure) was lower for mites that were singly infected with either Wolbachia or Spiroplasma than it was for co-infected or uninfected mites. Although a relatively high temperature (30°C) is thought to promote bacterial replication, rearing at high temperature (35°C) resulted in losses of Wolbachia and particularly Spiroplasma. Exposing the mites to 20°C reduced the density and transmission of Spiroplasma but not Wolbachia. The four spider mite strains tested differed in the numbers of heat shock genes (Hsps) induced under moderate or high temperature exposure. In thermal preference (Tp) assays, the two Wolbachia-infected spider mite strains preferred a lower temperature than strains without Wolbachia. Our results show that endosymbiont-mediated spider mite responses to temperature stress are complex, involving a combination of changing endosymbiont infection patterns, altered thermoregulatory behavior, and transcription responses.

Methyl Iodide Adsorption on Reduced Silver-Functionalized Silica Aerogel: How Temperature Impacts the Adsorption?

To understand the effect of temperature to the adsorption, 104 ppbv and 1044 ppbv methyl iodide (CHI) adsorptions on reduced silver-functionalized silica aerogel (Ag-Aerogel) at 100, 150 and 200 ℃ were performed. In the experiments, a significantly high uptake rate (3 – 4 times higher than that at 100 and 150 ℃) was observed for the 104 ppbv adsorption at 200 ℃. To explain such behavior, a potential reaction pathway was proposed and multiple physical analyses including nitrogen titration, x-ray photoelectron spectroscopy (XPS) and scanning electron microscopy (SEM) were performed. Based on the results, the contributing factors appear to be the formation of different Ag-I components induced by temperature, higher silver site availability, decreasing diffusion limitation, and increasing reaction rate described by the Arrhenius relationship.