PEGON-GLIPH GAME PENGENALAN DAN PEMBELAJARAN ARAB PEGON BERBASIS ANDROID

This study aims to design an Android-based game as a medium for the introduction and learning of Arabic pegon and to evaluate user performance of the Arabic pegon educational game using the User Experience Questionnaire (UEQ). The research stages consisted of stages, 1) research data; 2) design; 3) implementation; 4) examiners; 5) report creation. Then the design of this product is in the form of a Pegon-gliph game which is run on the Android system by having four main features, namely material features, training features, game features, and motivation features. And UEQ benchmark test results get good scores in the novelty category, while in other categories such as attractiveness, visibility, efficiency, dependability, and stimulation, the results are very good. So that the results of the performance of the Pegon-gliph educational game users show a positive user impression.

PENGARUH BAHAN TAMBAH RD260, E7016, ER705-6 PADA PENGELASAN OXY- ACETYLENE TERHADAP KEKUATAN TARIK PADA PLAT BORDES TIPE ST-37

This study aims to test the performance of the steering system, transmission, and electric braking system of the Urban Concept Warek V.1.1 type. The basic assumption of electricity is designed with the Urban Concept type (four vehicles like the current car) which is adjusted to the regulations for the Energy Saving Petite Contest (KMHE), which is held by the Indonesian government through the Ministry of Research, Technology and Higher Education. In the steering system design using the Ackerman type steering system, the transmission system uses a chain deive differential while the braking system uses hideelik discs. In the test results, the steering system has a maximum turning angle of 45 ° with a radius of less than 6 meters, for the transmission system in the test engine rotation speed (n,) is 589,867 rpm and electric meter rotation is 642.6 rpm with average speed - Average. 53 km / hour. The amount of deceleration of the braking system is 4.901 and 1.47 s for the braking time.

RANCANG BANGUN PENGAMAN MATA DENGAN LAYAR TV BERBASIS ARDUINO UNO

Television is an electronic device which now the majority is owned by all Indonesians. Besides the use of this electronic device, there is a negative impact or thing that is contained in this electronic device. When watching television, eyes often experience tired and dry eyes, this is caused by television monitors that emit radiation rays and cause several eye problems. The radiation beam emitted from each television differs depending on the size of the monitor. This has been proven by tests that have been carried out by related institutions that the distance to watch television for each monitor is different. "The eye has the most important role for the development of human intelligence". Therefore a tool was designed from the problems that arise which will set the ideal distance for watching television using the PIR sensor to determine the distance of the audience from the television which will be forwarded to Arduino UNO as data processing, the output of the tool is in the form of LED, Buzzer and executed by Rellay as Automatic shutdown where the television will be turned off automatically when the audience enters a distance of less than 3 meters and within 1 minute with the LCD indicator displaying text data in the form of "Danger" and the television will not be turned off automatically if the viewing distance is more than 3 meters and the LCD will display text data in the form of "SAFE".

PREDIKSI PENGADAAN DAN PENGELOLAAN INVENTORI JARINGAN SYARAF TIRUAN ALGORITMA BACKPROPAGATION PADA PERUM BULOG

Perum Bulog is a state-owned public company in food logistics field. Perum Bulog has a duty to stabilize food availability in Indonesia. The most consumed food by Indonesians is rice. It is estimated that the total national rice consumption reaches 30.25 million tons of rice. In this way, Perum Bulog must be able to meet their rice stock to maintain national food stability. However, in fact, in 2019 as many as 20 thousand tons of domestic rice had gone bad and caused the company to lose up to 167 billion. Thus, it is important to make predictions to determine the amount of rice stock in the future. One of the prediction techniques that can be used is prediction using Artificial Neural Networks. This study aims to determine the future rice stock of Perum Bulog using Artificial Neural Networks. Perum Bulog merupakan perusahaan umum milik negara yang bergerak di bidang logistik pangan. Perum Bulog memiliki tugas untuk menstabilkan ketersediaan pangan di Indonesia. makanan pokok yang paling sering dikonsumsi masyarakat Indonesia adalah beras. Diperkirakan jumlah konsumsi beras nasional mencapai 30,25 juta ton beras. Dengan begitu Perum Bulog harus dapat memenuhi stok beras mereka untuk menjaga kestabilan pangan nasional. Namun, nyatanya dilapan pada tahun 2019 sebanyak 20 ribu ton beras dalam negeri mengalami pembusukan dan membuat perusahaan rugi hingga 167 miliar. Dengan begitu pentingnya melakukan prediksi untuk mengetahui jumlah stok beras dimasa depan. Salah satu teknik prediksi yang dapa digunakan adalah prediksi menggunakan jaringan syaraf tiruan. Penelitian ini bertujuan untuk mengetahui stok beras masa depan Perum Bulog menggunakan jaringan syaraf tiruan.

IMPLEMENTASI ALGORITMA BRUTE FORCE PADA PENCARIAN DATA KEPEMILIKAN TANAH

Geographical information system is a system that combines elements on a map that is prepared to process data, analyze, and display spatial data to improve design. In the era of technology, information and communication (ICT) for organizations, agencies and public services is very important and needs to be implemented immediately. ATR / BPN in Jonggol village, Jabon, Ponorogo, still uses the manual method in processing certified land registration. The process of seeking, processing, and collecting certificate data requires a lot of time, causing services to be inefficient and effective and community satisfaction also decreasing. Therefore, a technology is needed that can facilitate service officers to search for certified land ownership data by implementing the brute force algorithm in the Geographical Information System for certified land ownership. The application of Algortima Brute Force in this geographic information system can run well, but if the text characters are long inputted, the system search process will take longer (if the text is short, the search can run quickly). On 10 keywords with different keyword or character lengths, the average search time was 0.06335 seconds.

PENGARUH VARIASI PANJANG PEGAS KOPLING TERHADAP PERFORMA DAN KONSUMSI BAHAN BAKAR PADA HONDA TIGER 200 CC

Good acceleration and performance are influenced by the degree of flexibility of the clutch springs. The objective that underlies the implementation of this study is to determine the effect of replacing the clutch spring with different length variations. In this study, the data taken is the torque, power and fuel consumption of each type of clutch spring. In this test, two types of clutch springs were used, namely the standard clutch spring and the TDR type coupling spring which were varied in length (38.31mm), (40.93mm) with the addition of 2mm (42.93mm), (40.31mm) rings. also cutting thread 2mm (38.93mm), (36.31mm). Tests were carried out using a dynotest tool with an engine speed of 4000 rpm to 9000 rpm transmission position six. In the TDR clutch spring (42.93mm) there is an increase in torque of 7.42% with a torque yield of 16.20 Nm at 6000 rpm and an increase in power of 6.61% with a power yield of 14.5 HP at 7000 rpm. For fuel consumption TDR coupling spring at ideal rotation (low-medium), an increase of 9.68%. The decrease in fuel consumption only occurred at the top / high speed of 6.32%. For the test results pertalite ethanol fuel, there is a decrease in fuel consumption compared to pertalite fuel for all RPM variables

DATA MINING SELEKSI SISWA BERPRESTASI UNTUK MENENTUKAN KELAS UNGGULAN MENGGUNAKAN METODE K-MEANS CLUSTERING (Studi Kasus di MTS Darul Fikri )

MTs Darul Fikri Bringin is a Tsanawiyah Madrasah located in Ponorogo. This madrasah has a good learning system to support the quality of madrasah, one of which is a superior class program. MTs Darul Fikri Bringin is always experiencing an increase in the acceptance of new student registrants every year. In determining the superior class, there are difficulties in class clustering based on students' abilities. This is due to the increasing number of registrants each year. Therefore, in this study the data mining method is applied to help cluster superior classes with student grade variables using the K-Means Clustering Algorithm and Rstudio Tools. Where the attributes used are the report card value, activeness and presence of class VII students. The K-Means Clustring Algorithm method is used to process these 12 attributes so as to produce 2 regular clusters and 1 superior cluster with the Rshiny interface in Rstudio using the R programming language. A in cluster 1 has 23 members. Classes B, C, D include regular classes which include class B in cluster 2 totaling 25 members and classes C and D in cluster 3 totaling 52 members. The application of the K-Means Clustering Algorithm and Rstudio Tools can cluster the determination and selection of superior classes at MTs Darul Fikri.

PENGARUH MODIFIKASI BACKCUT SEAT VALVE DAN UNDERCUTSTEM TERHADAP EFISIENSI VOLUMETRIK PADA CYLINDER HEAD MESIN ASTRO 108 CC

As technology develops in the automotive world, more and more motor vehicle manufacturers are also applying the latest technologies, especially for vehicles sold in general. Call it, for example, the development of the fuel system, which was still a carburetor, now uses an injection system, from S.O.H.C to D.O.H.C. these technologies are useful for increasing volumetric efficiency. In this study, the researchers wanted to increase the volumetric efficiency of the Astro 108 cc engine by applying a simple modification, namely the inlet and exhaust that was modified with a 30 backcut on the valve, undercut system, and 4 angle valve jobs (30 , 45, 60 , 75 ). By applying these modifications to the Astro 108 cc engine, it can increase its volumetric efficiency, say at 2300 rpm with standard inlet and exhaust conditions producing an air flow rate of 0.000358 m3 / s and 0.000814 m3 / s, this data is obtained from pressure taking on the water box meter. The difference in flow occurs because the air that enters the inlet and exhaust is smoother due to the modifications made. With this flow rate, at 2300 rpm standard head produces a volumetric efficiency of 19.05712%, and 43.26364% with a modified head.

RANCANG BANGUN ALAT TERAPI ELEKTRIK UNTUK MEMBANTU PENYEMBUHAN CEDERA DI POLI FISIOTERAPI RSUD Dr SOEDOMO TRENGGALEK

An injury is a disorder that occurs in the body which results in the appearance of redness, pain, swelling and the inability to function properly in the limbs. Handling of minor to severe injuries is carried out with medical treatment such as surgery or traditional medicine, but this treatment has not provided any assurance of healing, as for the alternative treatment, namely heat therapy. Heat therapy is able to open blood vessels wider and can provide a supply of oxygen and nutrients to reduce pain in injured sufferers. From this research, it can be produced a design of an electric therapy device that can produce heat equipped with a heat setting and a therapy time controller. The design of an electric therapy device to help heal physiotherapy dipole injuries at Dr. SOEDOMO Trenggalek Hospital has several advantages, namely that it can generate heat according to temperature settings, can adjust the length of therapy process time according to time settings and can also provide a display of temperature and time on the LCD display. The results of research on this electric therapy device are able to work according to predetermined working principles.

INTEGRASI ALGORITMA FISHER-YATES SEBAGAI PENGEMBANGAN E-LEARNING DI UNIT KEGIATAN BELAJAR MANDIRI

E-learning is currently very important and a must for educational institutions. Many e-learning application platforms are based on Learning Management System (LMS) that can be used by schools, whether they are open source, paid for or build their own applications. There are many considerations that must be faced when deciding to use an e-learning-based application (LMS) including infrastructure readiness, costs and application compatibility with the e-learning concept desired by educational institutions. The availability of features in the e-learning system is one that must be adjusted to the e- learning concept that will be selected. Each institution may be able to determine its own characteristics that can be specific and not yet fully accommodated in the e-learning application that currently exists. One of them is the feature to randomize exam questions to ensure that each student gets different questions with the same composition. This research will try to answer this problem by integrating the fisher-yates shuffel algorithm. The success of this algorithm integration will be assessed by conducting an exam simulation involving two classes and seeing how the system will randomly divide the exam questions to each student. The first assessment is the suitability of the composition of the questions and the similarity of the questions between students, the less students receive the same questions appearing on the exam questions, the better the system performance.