scholarly journals A preventív és proaktív fogászati azonosítás bevezetése és jelentősége tömegkatasztrófa áldozat azonosításkor

2021 ◽  
Vol 2 (1) ◽  
pp. 123-134
Author(s):  
Botond Simon ◽  
Ajang Armin Farid ◽  
János Vág

Összefoglaló. A modern kriminalisztika interdiszciplináris területe a tömegkatasztrófa áldozat azonosítás. A katasztrófát általában egy előre nem látható esemény okozza, amelyben mind az emberi, mind pedig az anyagi kár jelentős. Napjainkban az áldozatazonosítás folyamata reaktív módon történik, tehát az azonosításhoz szükséges dokumentáció az esemény bekövetkezése után kerül összegyűjtésre. A fogászati ante-mortem (AM) adatokat előre, hatóságilag egy központi adatbázisban, preventív jelleggel, kötelező módon nem tárolják. A preventív AM adatbázis létrehozása felgyorsíthatja és költséghatékonnyá teheti az áldozatazonosítást, mert a jelenlegi reaktív módszer helyett preventív módon, proaktív jelleggel kerülne sor az azonosításra. Summary. Mass disaster identification is an interdisciplinary field of modern forensic science. A disaster is usually caused by an unforeseen event in which both human and material damage is significant. Nowadays, the victim identification process is reactive, i.e., the authorities react to the event that has occurred and collect the necessary documentation for identification after the event has taken place. Primary identifiers include fingerprints, DNA and dental records. In mass casualty incidents, teeth are usually the most common means of identifying victims. However, dental ante-mortem (AM) documentation is not stored in advance in a central database as a preventive measure. The creation of a preventive AM database could speed up and make victim identification cost-effective, because it would be done in a preventive and proactive way instead of the current reactive method. The quality of the AM documentation would be guaranteed to be good and accurate, so that post-mortem (PM) data collected in the field can be easily and efficiently compared by a smart pattern recognition software, increasing the likelihood of successful identification. The introduction of digital health involves not only security and technology, but also cultural change. In Hungary, from 2020 onwards, the private sector will be obliged to provide data to the National eHealth Infrastructure (Elektronikus Egészségügyi Szolgáltatási Tér, EESZT), so digital health information will be stored in a centralized system, which can improve the quality of ante-mortem documentation. When identifying victims, it is important to have biometric identifiers that are resistant to environmental influences, have individual characteristics, are easy to collect and compare with reference information, and can be stored and used in a cost-effective way. The palatal ridge has been shown to meet the above properties. The development of digital dentistry and the involvement of the dental sector in data collection will facilitate the work of forensic dental experts, enabling the state to ensure effective identification and subsequent dignified farewells and burials for its citizens in the event of a mass disaster. According to the principle of operation of the preventive AM-PM database, the two- and three-dimensional X-ray and other imaging data, findings, anamnesis documentation and final reports collected during the lifetime of a citizen are stored in a central database. Changes during screening examinations can be traced. One of the most valuable is dental documentation. All information linked to the individual is stored with AM ID, which is also linked to passport and ID card information. In the event of an accident, post-mortem data is also stored in the AM-PM database, which is saved with a PM ID. With the help of a smart algorithm, the AM-PM ID match helps to identify the victim. In the case of missing persons, it is important that the missing person’s medical AM documentation, if not already stored, is immediately included, since when identifying an unknown body, it is probably best to start the search among the missing persons first.

Author(s):  
Buddhika Senanayake ◽  
Nirupama Tyagi ◽  
Xiaoyun Zhou ◽  
Sisira Edirippulige

The benefits that digital health may offer include clinical, administrative, research, and educational. Research shows that if used in the right circumstances, digital health may increase access to healthcare services, improve clinical outcomes, safety, and quality of care. Digital health also has the potential to improve organisational efficiencies by reducing duplication and unnecessary diagnostic testing. From a healthcare consumer perspective, there is an expectation that healthcare services need to be provided in a more flexible and cost-effective way as in other spheres such as banking, commerce, and media. This is another important driver for consideration to integrate digital health in healthcare services. As digital health continues to be used in routine healthcare services, practitioners may require new knowledge, skills, and competencies to make the best use of this innovative method. Education and training relating to digital health have been recognised as a priority for developing the future healthcare workforce.


Author(s):  
I.N. Voronchikhina ◽  
◽  
A.G. Marenkova ◽  
V. S. Rubets ◽  
V. V. Pylnev

The results of elements development of varietal agrotechnics of a new high-potential line 238h of winter triticale presented. It was identified that under the conditions of 2020 the most cost effective fertilizer system is an early spring application of NPK (S) (15-15-15 (10)) at a dose of 200kg/ha. The profitability level of this fertilizer was 88,9%.


1998 ◽  
Vol 37 (4II) ◽  
pp. 873-882 ◽  
Author(s):  
Sarfaraz Khan Quershi

Growth in telecom infrastructure and provision of modern telecom services to consumers at a cost based tariff helps growth of national economy. Modern telecoms serve as the engine of growth of national economy. Following the global trends of liberalisation and deregulation in telecoms monopolies which have thus far been providing inefficient communication at a greedily high tariffs are falling apart. Mergers in telecoms are not for increasing the size of the monopoly but to provide more efficient and cost effective services to the consumers. In Pakistan the erstwhile T&T department played a needful role at its time. Conversion of the department into a corporation and then into a company were steps necessary for following the global trends. Need now is to continue this trend further, eliminate the monopolistic approach by allowing more players in the field thus permitting the market forces to decide the provision of better quality of modern services at competitive price.


Author(s):  
Gwee Hoon Yen ◽  
Ng Kiong Kay

Abstract Today, failure analysis involving flip chip [1] with copper pillar bump packaging technologies would be the major challenges faced by analysts. Most often, handling on the chips after destructive chemical decapsulation is extremely critical as there are several failure analysis steps to be continued such as chip level fault localization, chip micro probing for fault isolation, parallel lapping [2, 3, 4] and passive voltage contrast. Therefore, quality of sample preparation is critical. This paper discussed and demonstrated a quick, reliable and cost effective methodology to decapsulate the thin small leadless (TSLP) flip chip package with copper pillar (CuP) bump interconnect technology.


2017 ◽  
Vol 6 (04) ◽  
pp. 5347 ◽  
Author(s):  
Omar B. Ahmed* ◽  
Anas S. Dablool

Several methods of Deoxyribonucleic acid (DNA) extraction have been applied to extract bacterial DNA. The amount and the quality of the DNA obtained for each one of those methods are variable. The study aimed to evaluate bacterial DNA extraction using conventional boiling method followed by alcohol precipitation. DNA extraction from Gram negative bacilli was extracted and precipitated using boiling method with further precipitation by ethanol. The extraction procedure performed using the boiling method resulted in high DNA yields for both E. coli and K. pneumoniae bacteria in (199.7 and 285.7μg/ml, respectively) which was close to control method (229.3 and 440.3μg/ml). It was concluded that after alcohol precipitation boiling procedure was easy, cost-effective, and applicable for high-yield quality of DNA in Gram-negative bacteria.


Author(s):  
Shaun Bowler

This chapter analyzes to what extent variation in political institutions affects political support. The chapter observes that the existing research is not always clear on which institutions should produce what kind of effect, although a general expectation is that institutional arrangements improve political support when they give citizens an increased sense of connection to the political process. In general then, we should expect institutions that strengthen the quality of representation to strengthen political support. This general expectation is specified in six hypotheses that are tested using data from the ESS 2012. The chapter demonstrates that electoral systems that provide voters with more choice about candidates, multiparty governments, and “responsive” legislatures, correlate positively with political support. However, compared to other macro-level factors and individual characteristics, the effects of political institutions on political support are modest. The chapter concludes that the prospects for institutional reform to strengthen political support are limited.


2021 ◽  
Vol 21 (1) ◽  
Author(s):  
Izabela Grabowska ◽  
Radosław Antczak ◽  
Jan Zwierzchowski ◽  
Tomasz Panek

Abstract Background The United Nations Convention on the Rights of Persons with Disabilities [1] highlights the need to create proper socioeconomic and political conditions for persons with disabilities, with a special focus on their immediate living conditions. According to the Convention, these conditions should be built to ensure that persons with disabilities have the potential to enjoy a high quality of life (QoL), and this principle is reflected in the notion of livable areas. The crucial aspect of this framework is the relationship between the individual QoL and the environment, broadly understood as the socioeconomic as well as the technical conditions in which persons with disabilities function. Methods The basic research problem was to assess the relationship between individual QoL for the population with disabilities as a dependent variable and livability indicators as independent variables, controlling for individual characteristics. The study used a dataset from the EU-SILC (European Union Statistics on Income and Living Conditions) survey carried out in 2015 in Poland. The research concept involved several steps. First, we created a variable measuring the QoL for the entire population with disabilities. To measure the multidimensional QoL, we used Sen’s capability approach as a general concept, which was operationalized by the MIMIC (multiple indicators multiple causes) model. In the second step, we identified the livability indicators available in the official statistics, and merged them with survey data. Finally, in the last step, we ran the regression analysis. We also checked the data for the nested structure. Results We confirmed that the general environmental conditions, focused on creating livable areas, played a significant role in shaping the QoL of persons with disabilities; i.e., we found that the higher the level of the local Human Development Index, the higher the quality of life of the individuals living in this area. This relationship held even after controlling for the demographic characteristics of the respondents. Moreover, we found that in addition to the general environmental conditions, the conditions created especially for persons with disabilities (i.e., services for this group and support for their living conditions) affected the QoL of these individuals. Conclusions The results illustrate the need to strengthen policies aimed at promoting the QoL of persons with disabilities by creating access to community assets and services that can contribute to improving the life chances of this population.


Author(s):  
Audrius Dėdelė ◽  
Auksė Miškinytė

Sustainable mobility is becoming a key factor in improving the quality of life of the residents and increasing physical activity (PA) levels. The current situation of sustainable mobility and its analysis is a first step in understanding the factors that would encourage residents to discover and choose alternative modes of travel. The present study examined the factors that encourage the choice of active modes of travel among urban adult population. Walking and cycling were analyzed as the most sustainable forms of urban mobility from the perspective of car and public transport (PT) users. Total of 902 subjects aged 18 years or older were analyzed in the study to assess commuting habits in Kaunas city, Lithuania. The majority (61.1%) of the respondents used a passenger vehicle, 28.2% used PT, and only 13.5% used active modes of travel. The results showed that safer pedestrian crossings, and comfortable paths were the most significant factors that encourage walking. A wider cycling network, and bicycle safety were the most important incentives for the promotion of cycling. Our findings show that the main factors encouraging walking and cycling among car and PT users are similar, however, the individual characteristics that determine the choice of these factors vary significantly.


Sign in / Sign up

Export Citation Format

Share Document