scholarly journals Recent Observations on the Mechanical Properties of Polymer Networks

1971 ◽  
Vol 44 (5) ◽  
pp. 1256-1272 ◽  
Author(s):  
P. Thirion ◽  
R. Chasset

Abstract The influence of temperature, elongation, swelling or dilution ratio, crosslink density, nature of the polymers, and crosslinking agents on the dynamic properties, creep and relaxation of polymer networks is surveyed in the terminal region of the spectrum. Whereas the deformation does not change the relaxation kinetics in large ranges of extension, the crosslink density acts as a reduced variable apparently accelerating uniformly the viscoelastic processes beyond the glass transition. The other possible reductions ‘time-temperature’ and ‘time—swelling’ do not necessarily seem related to the variations of free volume. From the viewpoint of the explanation of the relaxation mechanisms in the terminal zone, the fact that the equilibrium of loosely crosslinked elastomers would only virtually be reached after several years at room temperature seem in better agreement with chain entanglement effects, either trapped or not by the permanent network, than with the dissociation of secondary linkages.

2003 ◽  
Vol 76 (4) ◽  
pp. 876-891 ◽  
Author(s):  
R. N. Datta ◽  
A. G. Talma ◽  
S. Datta ◽  
P. G. J. Nieuwenhuis ◽  
W. J. Nijenhuis ◽  
...  

Abstract The use of thiurams such as Tetramethyl thiuram disulfide (TMTD) or Tetrabenzyl thiuram disulfide (TBzTD) has been explored to achieve higher cure efficiency. The studies suggest that a clear difference exists between the effect of TMTD versus TBzTD. TMTD reacts with Bis (triethoxysilylpropyl) tetrasulfide (TESPT) and this reaction can take place even at room temperature. On the other hand, the reaction of TBzTD with TESPT is slow and takes place only at higher temperature. High Performance Liquid Chromatography (HPLC) with mass (MS) detection, Nuclear Magnetic Resonance Spectroscopy (NMR) and other analytical tools have been used to understand the differences between the reaction of TMTD and TESPT versus TBzTD and TESPT. The reaction products originating from these reactions are also identified. These studies indicate that unlike TMTD, TBzTD improves the cure efficiency allowing faster cure without significant effect on processing characteristics as well as dynamic properties. The loading of TESPT is reduced in a typical Green tire compound and the negative effect on viscosity is repaired by addition of anhydrides, such as succinic anhydride, maleic anhydride, etc.


1990 ◽  
Vol 53 (5) ◽  
pp. 386-390 ◽  
Author(s):  
ESPERANZA GÓMEZ-LUCÍA ◽  
JOAQUÍN GOYACHE ◽  
JOSÉ A. ORDEN ◽  
ANA DOMÉNECH ◽  
F. JAVIER HERNÁNDEZ ◽  
...  

Homemade mayonnaise, in which pH had been adjusted to a range between 5.0 and 5.8 by the addition of vinegar, was inoculated with eight Staphylococcus aureus strains known to be enterotoxigenic. They were incubated for a maximum of 7 days at 22, 28, 37, and 44°C. Periodically, staphylococcal growth and pH were determined. Mayonnaise samples were examined on d 7 for the presence of enterotoxins A, B, C, and D. Staphylococcal growth was higher at 22°C (average log10 7.21 cfu/g), than at the other temperatures tested (log10 7.15, 6.77, and 5.93 cfu/g, respectively for 28, 37, and 44°C), suggesting a better growth in mayonnaise at low room temperature. Enterotoxin synthesis took place mainly at 28°C, as 33.3% of the total enterotoxins produced were detected at this temperature. However, some strains synthesized high amounts of enterotoxin even at 22°C.


Author(s):  
R. Haswell ◽  
U. Bangert ◽  
P. Charsley

A knowledge of the behaviour of dislocations in semiconducting materials is essential to the understanding of devices which use them . This work is concerned with dislocations in alloys related to the semiconductor GaAs . Previous work on GaAs has shown that microtwinning occurs on one of the <110> rosette arms after indentation in preference to the other . We have shown that the effect of replacing some of the Ga atoms by Al results in microtwinning in both of the rosette arms.In the work to be reported dislocations in specimens of different compositions of Gax Al(1-x) As and Gax In(1-x) As have been studied by using micro indentation on a (001) face at room temperature . A range of electron microscope techniques have been used to investigate the type of dislocations and stacking faults/microtwins in the rosette arms , which are parallel to the [110] and [10] , as a function of composition for both alloys . Under certain conditions microtwinning occurs in both directions . This will be discussed in terms of the dislocation mobility.


Alloy Digest ◽  
1960 ◽  
Vol 9 (7) ◽  

Abstract HAYNES STELLITE 98M2 Alloy is a cobalt-base alloy having higher compressive strength and higher hardness than all the other cobalt-base alloys at room temperature and in the red heat range. This datasheet provides information on composition, physical properties, hardness, elasticity, tensile properties, and compressive strength as well as fracture toughness. It also includes information on heat treating, machining, and joining. Filing Code: Co-22. Producer or source: Haynes Stellite Company.


1992 ◽  
Vol 57 (11) ◽  
pp. 2302-2308
Author(s):  
Karel Mocek ◽  
Erich Lippert ◽  
Emerich Erdös

The kinetics of the reaction of solid sodium carbonate with sulfur dioxide depends on the microstructure of the solid, which in turn is affected by the way and conditions of its preparation. The active form, analogous to that obtained by thermal decomposition of NaHCO3, emerges from the dehydration of Na2CO3 . 10 H2O in a vacuum or its weathering in air at room temperature. The two active forms are porous and have approximately the same specific surface area. Partial hydration of the active Na2CO3 in air at room temperature followed by thermal dehydration does not bring about a significant decrease in reactivity. On the other hand, if the preparation of anhydrous Na2CO3 involves, partly or completely, the liquid phase, the reactivity of the product is substantially lower.


2013 ◽  
Vol 9 ◽  
pp. 8-14 ◽  
Author(s):  
Yan Sun ◽  
Jing Sun ◽  
Chao-Guo Yan

A fast and convenient protocol for the synthesis of novel spiro[dihydropyridine-oxindole] derivatives in satisfactory yields was developed by the three-component reactions of arylamine, isatin and cyclopentane-1,3-dione in acetic acid at room temperature. On the other hand the condensation of isatin with two equivalents of cyclopentane-1,3-dione gave 3,3-bis(2-hydroxy-5-oxo-cyclopent-1-enyl)oxindole in high yields. The reaction mechanism and substrate scope of this novel reaction is briefly discussed.


1966 ◽  
Vol 39 (4) ◽  
pp. 870-880 ◽  
Author(s):  
R. Chasset ◽  
P. Thirion

Abstract In agreement with the results of dynamic experiments of Stratton and Ferry, this study of relaxation of rubber vulcanizates entirely confirms the existence of peculiar, slow, viscoelastic processes in high polymer networks. Characteristic differences with the rheological behavior of unvulcanized polymers are best reflected by the shape of the end of the distribution functions of relaxation times. The box distribution found for free chains is replaced, for crosslinked polymers, by a long incline extending during several decades of time. The slope of this linear part of the spectrum is only slightly dependent on nature of the polymer and type of vulcanizate. On the other hand, the position of the incline along the time scale is very sensitive to the mean molecular weight Mc of the vulcanizates, by far the most important factor controlling the phenomenon. The downward deviations observed at the end of the incline also occur later for larger values of Mc. A useful step towards theoretical understanding of this behavior should be a quantitative knowledge of the effect of molecular weight in a broader range of Mc than studied here. If the chain entanglements are of primary importance, as considered probable by Ferry it seems that some singularity should occur for a critical molecular weight fitting the corresponding value for the viscosity of free chains. The role of crosslink mobility might be tested by comparing the relaxation of ordinary random vulcanizates with that of eventually more regular polybutadiene networks prepared by end group crosslinking of carboxy-terminated and mono-disperse chains. In fact, the displacement of a crosslink away from its affine position requires, apart from the Brownian fluctuations, an unbalance between the forces exerted by the four radiating chains. This implies that the lengths of the strands present large differences and that the shortest chains are approaching their limit of extensibility. As the latter condition can hardly be fullfilled at small deformations, it seems doubtful that this mechanism may be predominant either for dynamic properties or the relaxation experiments reported here. Another cause sometimes invoked is the presence of free chains attached to the networks and we are presently studying their effect on viscoelastic relaxation. At this stage, it is already apparent that they do not have a large effect, as might be expected on theoretical grounds. In our opinion, special attention should be paid to the reason why the experimentally found relaxation times are so large, in spite of the relatively short average length of the network strands. If the usual notion of entanglements developed for free chains, as an extension of the Rouse theory, should fail in this respect, it would be necessary to reconsider the non-equilibrium statistics of single chains with fixed ends, taking into account the proper inter- and intramolecular forces hindering their motion. This more direct approach to the problem, already outlined by Kirkwood, ought to express mathematically the fact that the presence of crosslinks tends to prevent longitudinal slippage of large parts of the chains. The slow changes of configuration should occur therefore rather through lateral motions to which the neighboring medium opposes a much greater resistance.


2013 ◽  
Vol 717 ◽  
pp. 113-116
Author(s):  
Sani Klinsanit ◽  
Itsara Srithanachai ◽  
Surada Ueamanapong ◽  
Sunya Khunkhao ◽  
Budsara Nararug ◽  
...  

The effect of soft X-ray irradiation to the Schottky diode properties was analyzed in this paper. The built-in voltage, leakage current, and work function of Schottky diode were investigated. The current-voltage characteristics of the Schottky diode are measured at room temperature. After irradiation at 70 keV for 55 seconds the forward current and leakage current are increase slightly. On the other hand, the built-in voltage is decrease from the initial value about 0.12 V. Consequently, this method can cause the Schottky diode has low power consumption. The results show that soft X-ray can improve the characteristics of Schottky diode.


Author(s):  
Shweta Singh ◽  
Sureshbabu Popuri ◽  
Qazi Mohammad Junaid ◽  
Sabiah Shahul Hameed ◽  
Jeyakumar Kandasamy

A wide range of N-tosyl α–ketoamides underwent transamidation with various alkyl amines in the absence of catalyst, base, or additives. On the other hand, transamidation in N-Boc α–ketoamides is achieved...


2005 ◽  
Vol 488-489 ◽  
pp. 287-290 ◽  
Author(s):  
Tadayoshi Tsukeda ◽  
Ken Saito ◽  
Mayumi Suzuki ◽  
Junichi Koike ◽  
Kouichi Maruyama

We compared the newly developed heat resistant magnesium alloy with conventional ones by Thixomolding® and aluminum alloy by die casting. Tensile properties at elevated temperatures of AXEJ6310 were equal to those of ADC12. In particular, elongation tendency of AXEJ6310 at higher temperature was better than those of the other alloys. Creep resistance of AXEJ6310 was larger than that of AE42 by almost 3 orders and smaller than that of ADC12 by almost 2 orders of magnitude. Fatigue limits at room temperature and 423K of AXEJ6310 was superior among conventional magnesium alloys.


Sign in / Sign up

Export Citation Format

Share Document