scholarly journals Exploring microwave absorption by non-periodic metasurfaces

2021 ◽  
Vol 10 (3) ◽  
pp. 1-6
Author(s):  
J. K. Hamilton ◽  
I. R. Hooper ◽  
C. R. Lawrence
Keyword(s):  
Large Body ◽  
Coupling Efficiency ◽  
Low Frequency ◽  
Incident Radiation ◽  
Electromagnetic Response ◽  
Periodic Pattern ◽  
Large Area ◽  
Specular Reflectivity ◽  
Absorption Performance ◽  
Low Frequency Mode

In recent years there has been a large body of work investigating periodic metasurface microwave absorbers. However, surprisingly few investigations have focused on the absorption performance of similar non-periodic designs. In this work, the electromagnetic response of a large area (310 mm x 310 mm) microwave absorber that lacks a global periodicity is experimentally studied. The top metallic layer of the ultra-thin (0.3 mm) absorber is structured with rectangular patches given by a procedurally generated non-periodic pattern, known as the toothpick sequence. The specular reflectivity of both p-polarised and s-polarised incident radiation shows coupling to an additional low frequency mode when compared to a standard square patch periodic absorber. To further explore the coupling efficiency of such non-periodic absorbers, finite element models were used to investigate the influence of increasing sample size.

scholarly journals Broadband Unidirectional Forward Scattering with High Refractive Index Nanostructures: Application in Solar Cells

Molecules ◽  
2021 ◽  
Vol 26 (15) ◽  
pp. 4421
Author(s):  
Ángela Barreda ◽  
Pablo Albella ◽  
Fernando Moreno ◽  
Francisco González
Keyword(s):  
Refractive Index ◽  
Solar Cells ◽  
Forward Direction ◽  
High Refractive Index ◽  
Incident Radiation ◽  
Antireflection Coating ◽  
Electromagnetic Response ◽  
Silicon Substrates ◽  
Graded Index ◽  
Dielectric Substrates

High refractive index dielectric (HRID) nanoparticles are a clear alternative to metals in nanophotonic applications due to their low losses and directional scattering properties. It has been demonstrated that HRID dimers are more efficient scattering units than single nanoparticles in redirecting the incident radiation towards the forward direction. This effect was recently reported and is known as the “near zero-backward” scattering condition, attained when nanoparticles forming dimers strongly interact with each other. Here, we analyzed the electromagnetic response of HRID isolated nanoparticles and aggregates when deposited on monolayer and graded-index multilayer dielectric substrates. In particular, we studied the fraction of radiation that is scattered towards a substrate with known optical properties when the nanoparticles are located on its surface. We demonstrated that HRID dimers can increase the radiation emitted towards the substrate compared to that of isolated nanoparticles. However, this effect was only present for low values of the substrate refractive index. With the aim of observing the same effect for silicon substrates, we show that it is necessary to use a multilayer antireflection coating. We conclude that dimers of HRID nanoparticles on a graded-index multilayer substrate can increase the radiation scattered into a silicon photovoltaic wafer. The results in this work can be applied to the design of novel solar cells.

scholarly journals Differential Recordings of Local Field Potential:A Genuine Tool to Quantify Functional Connectivity

2018 ◽  
Author(s):  
Meyer Gabriel ◽  
Caponcy Julien ◽  
Paul A. Salin ◽  
Comte Jean-Christophe
Keyword(s):  
Functional Connectivity ◽  
Local Field ◽  
Signal To Noise Ratio ◽  
Field Potential ◽  
Low Frequency ◽  
Large Area ◽  
Signal To Noise ◽  
Cortical Areas ◽  
Electrophysiological Method ◽  
Local Field Potential Lfp

AbstractLocal field potential (LFP) recording is a very useful electrophysiological method to study brain processes. However, this method is criticized for recording low frequency activity in a large area of extracellular space potentially contaminated by distal activity. Here, we theoretically and experimentally compare ground-referenced (RR) with differential recordings (DR). We analyze electrical activity in the rat cortex with these two methods. Compared with RR, DR reveals the importance of local phasic oscillatory activities and their coherence between cortical areas. Finally, we show that DR provides a more faithful assessment of functional connectivity caused by an increase in the signal to noise ratio, and of the delay in the propagation of information between two cortical structures.

Oscillations in a Collapsed-Tube Analog of the Brachial Artery Under a Sphygmomanometer Cuff

1989 ◽  
Vol 111 (3) ◽  
pp. 185-191 ◽  
Author(s):  
C. D. Bertram ◽  
C. J. Raymond ◽  
K. S. A. Butcher
Keyword(s):  
High Frequency ◽  
Flow Characteristics ◽  
Low Frequency ◽  
Collapsible Tube ◽  
Tube Size ◽  
Low Frequency Oscillations ◽  
Central Segment ◽  
Experimental Parameters ◽  
Aqueous Flow ◽  
Low Frequency Mode

To determine whether self-excited oscillations in a Starling resistor are relevant to physiological situations, a collapsible tube conveying an aqueous flow was externally pressurized along only a central segment of its unsupported length. This was achieved by passing the tube through a shorter and wider collapsible sleeve which was mounted in Starling resistor fashion in a pressure chamber. The tube size and material, and all other experimental parameters, were as used in our previous Starling resistor studies. Both low- and high-frequency self-excited oscillations were observed, but the low-frequency oscillations were sensitive to the sleeve type and length relative to unsupported distance. Pressure-flow characteristics showed multiple oscillatory modes, which differed quantitatively from those observed in comparable Starling resistors. Slow variation of driving pressure gave differing behavior according to whether the pressure was rising or falling, in accord with the hysteresis noted on the characteristics and in the tube law. The results are discussed in terms of the various possible mechanisms of collapsible tube instability, and reasons are presented for the absence of the low-frequency mode under most physiological circumstances.

Mapping of induced polarization using natural fields

Geophysics ◽  
2001 ◽  
Vol 66 (1) ◽  
pp. 137-147 ◽  
Author(s):  
Erika Gasperikova ◽  
H. Frank Morrison
Keyword(s):  
Electric Field ◽  
Surrounding Medium ◽  
Low Frequency ◽  
Induced Polarization ◽  
The Body ◽  
Electromagnetic Response ◽  
Frequency Dependent ◽  
Finite Body ◽  
Electric Field Profile ◽  
Measured Response

The observed electromagnetic response of a finite body is caused by induction and polarization currents in the body and by the distortion of the induction currents in the surrounding medium. At a sufficiently low frequency, there is negligible induction and the measured response is that of the body distorting the background currents just as it would distort a direct current (dc). Because this dc response is not inherently frequency dependent, any observed change in response of the body for frequencies low enough to be in this dc limit must result from frequency‐dependent conductivity. Profiles of low‐frequency natural electric (telluric) fields have spatial anomalies over finite bodies of fixed conductivity that are independent of frequency and have no associated phase anomaly. If the body is polarizable, the electric field profile over the body becomes frequency dependent and phase shifted with respect to a reference field. The technique was tested on data acquired in a standard continuous profiling magnetotelluric (MT) survey over a strong induced polarization (IP) anomaly previously mapped with a conventional pole‐dipole IP survey. The extracted IP response appears in both the apparent resistivity and the normalized electric field profiles.

Observations of a low-frequency mode in a linear multiple mirror

1985 ◽  
Vol 28 (7) ◽  
pp. 2302
Author(s):  
M. A. Makowski ◽  
G. A. Emmert
Keyword(s):  
Low Frequency ◽  
Frequency Mode ◽  
Low Frequency Mode

Light Scattering from Pulsed Laser Deposited BaBi4Ti4O15 Thin Films

2000 ◽  
Vol 623 ◽  
Author(s):  
R.K. Soni ◽  
Anju Dixit ◽  
R. S. Katiyar ◽  
A. Pignolet ◽  
K.M. Satyalakshmi ◽  
...  
Keyword(s):  
Thin Films ◽  
Light Scattering ◽  
Room Temperature ◽  
Layer Structure ◽  
Low Frequency ◽  
Pulsed Laser ◽  
Buffer Layers ◽  
Frequency Mode ◽  
High Frequency Vibrations ◽  
Low Frequency Mode

AbstractLight scattering investigations are carried out on BaBi4Ti4O15 (BBiT) which is a member of the Bi-layer structure ferroelectric oxide with n = 4. The BBiT thin films, thickness ∼ 300 nm, were grown on epitaxial conducting LaNiO3 electrodes on epitaxial buffer layers on (100) silicon by pulsed laser deposition. Micro-Raman measurements performed on these films reveal a sharp low-frequency mode at 51 cm−1 along with broad highfrequeficy modes corresponding to other lattice vibrations including TiO6 octahedra. No temperature dependence of the low frequency mode is seen while a weak dependence of the broad high frequency vibrations are observed in the mixed oriented regions. Raman polarization carried out at room temperature indicates that the prominent modes have Alg and Eg symmetries in the BaBi4Ti4O15 thin films.

scholarly journals Utilization of 2:1 Internal Resonance in Microsystems

Micromachines ◽  
2018 ◽  
Vol 9 (9) ◽  
pp. 448 ◽  
Author(s):  
Navid Noori ◽  
Atabak Sarrafan ◽  
Farid Golnaraghi ◽  
Behraad Bahreyni
Keyword(s):  
Internal Resonance ◽  
Mode Coupling ◽  
Equations Of Motion ◽  
Low Frequency ◽  
Nonlinear Behavior ◽  
Excitation Amplitude ◽  
Beam Structure ◽  
Nonlinear Mode Coupling ◽  
T Beam ◽  
Low Frequency Mode

In this paper, the nonlinear mode coupling at 2:1 internal resonance has been studied both analytically and experimentally. A modified micro T-beam structure is proposed, and the equations of motion are developed using Lagrange’s energy method. A two-variable expansion perturbation method is used to describe the nonlinear behavior of the system. It is shown that in a microresonator with 2:1 internal resonance, the low-frequency mode is autoparametrically excited after the excitation amplitude reaches a certain threshold. The effect of damping on the performance of the system is also investigated.

scholarly journals Source counts and confusion at 72–231 MHz in the MWA GLEAM survey

2019 ◽  
Vol 36 ◽  
Author(s):  
T. M. O. Franzen ◽  
T. Vernstrom ◽  
C. A. Jackson ◽  
N. Hurley-Walker ◽  
R. D. Ekers ◽  
...  
Keyword(s):  
Thermal Noise ◽  
Low Frequency ◽  
Radio Continuum ◽  
Large Area ◽  
Design Study ◽  
Array Design ◽  
Square Kilometre Array ◽  
Noise Limit ◽  
Murchison Widefield Array ◽  
Extended Emission

Abstract The GaLactic and Extragalactic All-sky Murchison Widefield Array survey is a radio continuum survey at 72–231 MHz of the whole sky south of declination +30º, carried out with the Murchison Widefield Array. In this paper, we derive source counts from the GaLactic and Extragalactic All-sky Murchison data at 200, 154, 118, and 88 MHz, to a flux density limit of 50, 80, 120, and 290 mJy respectively, correcting for ionospheric smearing, incompleteness and source blending. These counts are more accurate than other counts in the literature at similar frequencies as a result of the large area of sky covered and this survey’s sensitivity to extended emission missed by other surveys. At S154 MHz > 0.5 Jy, there is no evidence of flattening in the average spectral index (α ≈ −0.8 where S ∝ vα) towards the lower frequencies. We demonstrate that the Square Kilometre Array Design Study model by Wilman et al. significantly underpredicts the observed 154-MHz GaLactic and Extragalactic All-sky Murchison counts, particularly at the bright end. Using deeper Low-Frequency Array counts and the Square Kilometre Array Design Study model, we find that sidelobe confusion dominates the thermal noise and classical confusion at v ≳ 100 MHz due to both the limited CLEANing depth and the undeconvolved sources outside the field-of-view. We show that we can approach the theoretical noise limit using a more efficient and automated CLEAN algorithm.

Sign in / Sign up

Export Citation Format

Share Document