Wastewater Treatment

Author(s):  
Deepika Rajwar ◽  
Mamta Bisht ◽  
J. P. N. Rai

In recent years, stringent discharge standards prior to the release of effluent into the water bodies have led to implementation of diverse advanced biological treatment processes in various industries. Biological treatment is a fundamental part of industrial wastewater treatment, contains soluble inorganic/organic pollutants. Being a cost-effective process, biological treatment has an economic advantage over chemical and physical processes. It employs a range of microorganisms which as a community form a microbial biofilm. Microbial biofilm provides a diverse range of micro-niches to microbial communities and protection from physical agitation to support metabolic potential and functional stability. Currently, biofilms are applied in wastewater treatment, degradation of toxic waste in water and soil and production of various commercial products. Intensive exploration has proved the importance of biofilm as a highly promising biotechnology, especially in wastewater treatment.

Author(s):  
N. Zaletova ◽  
S. Zaletov

Биологический метод очистки сточных вод представляет собой сложный многокомпонентный процесс, ключевой составляющей которого является работа ферментной системы. Известно, что одним из важнейших ферментов, обеспечивающих биологический процесс, являются дегидрогеназы. Полностью сложнейший механизм действия ферментов до конца пока не раскрыт, однако в практике контроля процессов биологической очистки используется показатель дегидрогеназной активности ила. Результаты исследований позволили дополнить имеющуюся информацию фактическими данными о взаимообусловленности уровня дегидрогеназной активности ила и показателей отдельных технологических параметров биологической очистки. Показано, что режим работы аэротенков (нагрузка на ил, доза активного ила и др.) и величина показателей исходной дегидрогеназной активности и дегидрогеназной активности этого же образца ила со слабо концентрированным раствором (ДАИН2О) связаны между собой и зависят от нагрузки на ил по органическим веществам. Полученные результаты исследования могут быть использованы для контроля биологического процесса очистки сточных вод.The biological method of wastewater treatment is a comprehensive multicomponent process the activities of the enzyme system being the key component of it. It is known that dehydrogenases have been one of the most important enzymes the ensure the biological process. The complicated mechanism of the action of enzymes has not been fully described so far however, in the practice of monitoring biological treatment processes, an indicator of the dehydrogenase activity of sludge is used. The research results provided for supplementing the available information with actual data on the interdependence of the level of dehydrogenase activity of sludge and indicators of individual process parameters of biological treatment. It was shown that the mode of operation of aeration tanks (organic matter load on sludge, dose of activated sludge, etc.) and the values of the initial dehydrogenase activity and dehydrogenase activity of the same sludge sample with weakly concentrated solution (DASН2О) are interconnected and depend on the organic load on sludge. The results of the study can be used to control the biological process of wastewater treatment.The biological method of wastewater treatment is a comprehensive multicomponent process the activities of the enzyme system being the key component of it. It is known that dehydrogenases have been one of the most important enzymes the ensure the biological process. The complicated mechanism of the action of enzymes has not been fully described so far however, in the practice of monitoring biological treatment processes, an indicator of the dehydrogenase activity of sludge is used. The research results provided for supplementing the available information with actual data on the interdependence of the level of dehydrogenase activity of sludge and indicators of individual process parameters of biological treatment. It was shown that the mode of operation of aeration tanks (organic matter load on sludge, dose of activated sludge, etc.) and the values of the initial dehydrogenase activity and dehydrogenase activity of the same sludge sample with weakly concentrated solution (DASН2О) are interconnected and depend on the organic load on sludge. The results of the study can be used to control the biological process of wastewater treatment.


1986 ◽  
Vol 18 (6) ◽  
pp. 35-45 ◽  
Author(s):  
John C. Kissel

Parameters characterizing intrasolid, liquid/solid, and gas/liquid mass transport phenomena in biological treatment systems are required if mass transfer is to be included in process models. Estimates of such parameters are presented and discussed. Collective and individual effects of mass transfer resistances are illustrated by computer simulation of a high-rate trickling filter.


2021 ◽  
Vol 3 (2) ◽  
pp. 130-140
Author(s):  
Maria Diana Puiu ◽  

The food industry wastewater is known to present a high organic matter content, due to specific raw materials and processing activities. Even if these compounds are not directly toxic to the environment, high concentrations in effluents could represent a source of pollution as discharges of high biological oxygen demand may impact receiving river's ecosystems. Identifying the main organic contaminants in wastewater samples represents the first step in establishing the optimum treatment method. The sample analysis for the non-target compounds through the GC-MS technique highlights, along with other analytical parameters, the efficiency of the main physical and biological treatment steps of the middle-size Wastewater Treatment Plant (WWTP). Long-chain fatty acids and their esters were the main abundant classes of non-target identified compounds. The highest intensity detection signal was reached by n-hexadecanoic acid or palmitic acid, a component of palm oil, after the physical treatment processes with dissolved air flotation, and by 1-octadecanol after biological treatment.


2019 ◽  
Vol 31 (5) ◽  
pp. 1013-1016
Author(s):  
J.B. Veeramalini ◽  
B. Bharathiraja ◽  
S. Raghu Vinayak ◽  
R. Vignesh ◽  
S.K. Raghul

In present work, water treatment processes is carried out by an affordable, readily usable and non-chemical method. This study involved the process of water may reduce the concentration of particulate matter that includes suspended particles, micro organisms, a range of dissolved and particulate material derived from the surfaces. The substances used in this work were coarsely blended with each other and a special composite fibre filter was made. Several processes variables of quality of waste are also measured before and after the treatment. Results show that the water quality has been enriched in several ways such as reduction in the dissolved solids, pH has been controlled, deodorization and prevention of microbial growth. Hence use of this work has been utilized as a “Homemaker Model” and act as an alternative method for wastewater treatment in a cost effective way.


2012 ◽  
Vol 19 (1) ◽  
pp. 9-18 ◽  
Author(s):  
Elżbieta Hallmann ◽  
Renata Tomczak-Wandzel ◽  
Krystyna Mędrzycka

Combined Chemical-Biological Treatment of Effluents from Soil Remediation Processes by Surfactants Solutions Flushing In recent years combined chemical-biological wastewater treatment processes have received increasing interest. In the present study wastewater from soil remediation processes were treated by means of 1-step processes like Fenton, aerobic degradation and 2-steps combined method. The effluents resulting from soil remediation processes consist of high surfactant concentration solutions, mobilized oils and oil-in-water (o/w) emulsions. The effectiveness of wastewater treatment was evaluated by COD reduction and surfactant removal. The application of Fenton process alone showed around 80% of COD and surfactant removal, and in case of aerobic process only 60% of COD and 50% of surfactant removal was accomplished. However, the maximum COD reduction and surfactant removal from wastewater samples, above 90%, was obtained in aerobic degradation with Fenton process as pretreatment. Thus, the Fenton process could be effectively applied as a pretreatment step to improve the reduction of both COD and surfactant from wastewater resulting from soil remediation.


2006 ◽  
Vol 6 (4) ◽  
pp. 17-25 ◽  
Author(s):  
A. Ried ◽  
J. Mielcke

The use of ozone and/or UV for water treatment processes is often a combination of an ozone and/or UV-step with additional treatment steps, e.g. biological treatment, flocculation, filtration and activated carbon. Therefore, it is necessary to develop an optimized combination of these different steps. This article will demonstrate the advantages presenting two examples for drinking water treatment and two examples for municipal wastewater treatment.


2002 ◽  
Vol 2002 (5) ◽  
pp. 765-787 ◽  
Author(s):  
Vera L. Barbosa ◽  
Adam W. R. Brookes ◽  
Suzy Morton ◽  
Joanna E. Burgess ◽  
Richard M. Stuetz

2020 ◽  
Vol 10 (5) ◽  
pp. 1886 ◽  
Author(s):  
Diana Pacheco ◽  
Ana Cristina Rocha ◽  
Leonel Pereira ◽  
Tiago Verdelhos

The need to reduce costs associated with the production of microalgae biomass has encouraged the coupling of process with wastewater treatment. Emerging pollutants in municipal, industrial, and agricultural wastewaters, ranging from pharmaceuticals to metals, endanger public health and natural resources. The use of microalgae has, in fact, been shown to be an efficient method in water-treatment processes and presents several advantages, such as carbon sequestration, and an opportunity to develop innovative bioproducts with applications to several industries. Using a bibliometric analysis software, SciMAT, a mapping of the research field was performed, analyzing the articles produced between 1981 and 2018, aiming to identifying the hot topics and trends studied until now. The application of microalgae on water bioremediation is an evolving research field that currently focuses on developing efficient and cost-effective treatments methods that also enable the production of add-value products, leading to a blue and circular economy.


2013 ◽  
Vol 13 (1) ◽  
pp. 225-236 ◽  
Author(s):  
Wei-Hsiang Chen ◽  
Wen-Ben Yang ◽  
Chung-Shin Yuan ◽  
Jun-Chen Yang ◽  
Qing-Liang Zhao

Sign in / Sign up

Export Citation Format

Share Document