The Use of Composite GOES-R Satellite Imagery to Evaluate a TC Intensity and Vortex Structure Forecast by an FV3GFS-Based Hurricane Forecast Model

The HAFS model is an effort under the NGGPS and UFS initiatives to create the next generation of hurricane prediction and analysis system based on FV3-GFS. It has been validated extensively using traditional verification indicators such as tracker error and biases, intensity error and biases, and the radii of gale, damaging and hurricane strength winds. While satellite images have been used to verify hurricane model forecasts, they have not been used on HAFS. The community radiative transfer model CRTM is used to generate model synthetic satellite images from HAFS model forecast state variables. The 24 forecast snapshots in the mature stage of hurricane Dorian in 2019 are used to generate a composite model synthetic GOES-R infrared brightness image. The composite synthetic image is compared to the corresponding composite image generated from the observed GOES-R data, to evaluate the model forecast TC vortex intensity, size, and asymmetric structure. Results show that the HAFS forecast TC Dorian agrees reasonably well with the observation, but the forecast intensity is weaker, its overall vortex size smaller, and the radii of its eye and maximum winds larger than the observed. The evaluation results can be used to further improve the model. While these results are consistent with those obtained by traditional verification methods, evaluations based on composite satellite images provide an additional benefit with richer information because they have near-real-times spatially and temporally continuous high-resolution data with global coverage. Composite satellite infrared images could be used routinely to supplement traditional verification methods in the HAFS and other hurricane model evaluations. Note since this study only evaluated one hurricane, the above conclusions are only applicable to the model behavior of the mature stage of hurricane Dorian in 2019, and caution is needed to extend these conclusions to expect model biases in predicting other TCs. Nevertheless, the consistency between the evaluation using composite satellite images and the traditional metrics, of hurricane Dorian, shows that this method has the potential to be applied to other storms in future studies.

Influence of low-Z impurity on the stabilization of m/n = 2/1 tearing/locked modes in EAST

The impact of the low-Z impurity concentration on the modes stabilization has been investigated in the EAST tokamak. Series of tearing modes (TMs) with multiple helicities are excited by the concentration of low-Z (carbon) impurity, and the dominant mode structure is featured by m/n = 2/1 magnetic islands that propagate in electron diamagnetic drift direction (m and n are poloidal and toroidal mode numbers respectively). The m/n = 2/1 locked modes (LMs) can be formed by the redistribution of low-Z impurity concentration, which is unlocked spontaneously for the decreasing of impurity concentration, where the width of magnetic islands can reach w ≅ 5 cm (w/a ≅ 0.1, a is minor radius). The increasing of electromagnetic brake torque is the primary reason for the mode locking, and the 'O'-point of m/n = 2/1 magnetic islands is locked by the tungsten protector limiter (toroidal position: -0.4π ≦ φ ≦ -0.3π) with separation of Δφ ≅ 0. The 3D asymmetric structure of m/n = 2/1 magnetic islands is formed for the interaction with the tungsten protector limiter, and the electromagnetic interaction decreases dramatically for the separation of Δφ ≧ 0.2π. The mechanisms for the mode excitation and locking can be illustrated by the "hysteresis effect" between the low-Z impurity concentration and the width of m/n = 2/1 magnetic islands, namely the growth of magnetic islands is modulated by the low-Z impurity concentration, and the rotation velocity is decelerated accordingly. However, the intrinsic mechanism for the unlocking of m/n = 2/1 LMs is complicated by considering the concentration of the low-Z impurity, and the possible unlocking mechanism is discussed. Therefore, understanding of the relationship between the impurities and magnetic islands is more important for optimizing the control techniques (RMP→LMs, ECRH→NTM, impurity seeding→major collapse, et al).

Improving the torsional response of asymmetric buildings with self-centering controlled rocking steel braced frame system

Self-centering controlled rocking steel braced-frame (SC-CR-SBF) is proposed as an earthquake-resistant system with low damage. Pre-stressed vertical strands provide a self-centering mechanism in the system and energy absorbing fuses restrict maximum displacement. Presence of asymmetry in structures can highlight the advantages of employing this structural system. Moreover, these days designing and constructing asymmetric and irregular structures is inevitable and as a result of architectural attractiveness and requirements of different functions of buildings, they are of great importance. Consequently, in these types of structures in order to minimize seismic responses, particular measures should be taken into consideration. Proper distribution of strength and stiffness throughout the plan of structures with self-centering systems can play a considerable role in resolving problems associated with asymmetry in these structures. In this study, the asymmetric buildings with 10% and 20% mass eccentricities and having different arrangements of centers were simulated. The models were analyzed under a set of 22 bidirectional far-field ground-motion records and corresponding responses of maximum roof drift, acceleration and rotation of the roof diaphragms of the structures with different arrangements of the center of mass, stiffness and strength were computed and studied. Results show that proper distribution of stiffness and strength throughout the plan of the structures with SC-CR-SBF system reduces the maximum roof drift as well as the rotation of the roof diaphragm. With appropriate arrangement of the centers, maximum drift response of the asymmetric structure decreases as much as roughly 20% and the ratio of the maximum drift response of the asymmetric structure to the response of the similar symmetric structure with the same overall stiffness and strength was 1.1. In other words, maximum drift response of the asymmetric structure with SC-CR-SBF system is acceptably close to the one for the symmetric building.

Многократное изменение электрон-фононного взаимодействия в квантовых ямах с диэлектрически различными барьерами

The specific features of the interaction of charged particles with polar optical phonons have been studied theoretically for quantum wells with the barriers that are asymmetric in their dielectric properties. It is shown that the interaction with interface phonon modes makes the greatest contribution in narrow quantum wells. The parameters of the electron-phonon interaction were found for the cases of different values of the phonon frequencies in the barrier materials. It turned out that a significant (by almost an order of magnitude) change in the parameters of the electron-phonon interaction can occur in such structures. This makes it possible, in principle, to trace the transition from weak to strong interactions in quantum wells of the same type but with different compositions of barrier materials. The conditions are found under which an enhancement of the electron-phonon interaction is possible in an asymmetric structure in comparison with a symmetric one with the barriers of the same composition.

Manipulating Optical Scattering of Quasi-BIC in Dielectric Metasurface with Off-Center Hole

Bound states in the continuum (BICs) correspond to a particular leaky mode with an infinitely large quality-factor (Q-factor) located within the continuum spectrum. To date, most of the research work reported focuses on the BIC-enhanced light matter interaction due to its extreme near-field confinement. Little attention has been paid to the scattering properties of the BIC mode. In this work, we numerically study the far-field radiation manipulation of BICs by exploring multipole interference. By simply breaking the symmetry of the silicon metasurface, an ideal BIC is converted to a quasi-BIC with a finite Q-factor, which is manifested by the Fano resonance in the transmission spectrum. We found that both the intensity and directionality of the far-field radiation pattern can not only be tuned by the asymmetric parameters but can also experience huge changes around the resonance. Even for the same structure, two quasi-BICs show a different radiation pattern evolution when the asymmetric structure parameter d increases. It can be found that far-field radiation from one BIC evolves from electric-quadrupole-dominant radiation to toroidal-dipole-dominant radiation, whereas the other one shows electric-dipole-like radiation due to the interference of the magnetic dipole and electric quadrupole with the increasing asymmetric parameters. The result may find applications in high-directionality nonlinear optical devices and semiconductor lasers by using a quasi-BIC-based metasurface.

Synthesis and Characterization of Blended Cellulose Acetate Membranes

The casting and preparation of ultrafiltration ZnO modified cellulose acetate membrane (CA/ZnO) were investigated in this work. CA membranes were fabricated by phase inversion using dimethylformamide (DMF) as a solvent and ZnO as nanostructures materials. Ultrafiltration (UF) performance, mechanical stability, morphology, contact angle, and porosity were evaluated on both CA- and ZnO-modified CA samples. Scanning electron microscopy (SEM) was used to determine the morphology of the membranes, showing different pore sizes either on rough surfaces and cross-sections of the samples, an asymmetric structure and ultra-scale pores with an average pore radius 0.0261 to 0.045 µm. Contact angle measurements showed the highest hydrophobicity values for the samples with no ZnO addition, ranging between 48° and 82.7° on their airside. The permeability values decreased with the increasing CA concentration in the casting solution, as expected; however, ZnO-modified membranes produced lower flux than the pure CA ones. Nevertheless, ZnO modified CA membranes have higher surface pore size, pore density and porosity, and improved surface hydrophilicity compared with pure CA membranes. The results indicated that the incorporated nano-ZnO tends to limit the packing of the polymer chains onto the membrane structure while showing antifouling properties leading to better hydrophilicity and permeation with consistent UF applications.

Correlation Research Between Gondola Car Body Structure And Weld Stress Based On Asymmetry Coefficient

In order to find out the root cause of cross bearer welds’ cracks on the general purpose gondola cars, the relationship between asymmetric structure and stress distribution is studied in this paper. Firstly, the concept of asymmetry coefficient is proposed, and the asymmetric coefficients’ calculation methods of independent and dependent variables are given respectively in two-dimensional space. Secondly, according to the different positions of side column 1 and side column 2, 30 local models are established, the cross bearer weld stresses are extracted after finite element simulation, and the stress distribution clusters are formed. Finally, the asymmetry coefficients of the side columns are calculated, and the correlation between the positions of the side columns and the weld stresses is studied by the methods of Pearson correlation coefficient and complex correlation coefficient. The results show that the correlation between the stress of cross bearer weld 2 and the positions of the side columns is much higher. This research can not only provide an important basis for the structural optimization of 80t gondola car body, and it also provides reference for the structural design of the gondola car body.

AAU-Net: Attention-Based Asymmetric U-Net for Subject-Sensitive Hashing of Remote Sensing Images

The prerequisite for the use of remote sensing images is that their security must be guaranteed. As a special subset of perceptual hashing, subject-sensitive hashing overcomes the shortcomings of the existing perceptual hashing that cannot distinguish between “subject-related tampering” and “subject-unrelated tampering” of remote sensing images. However, the existing subject-sensitive hashing still has a large deficiency in robustness. In this paper, we propose a novel attention-based asymmetric U-Net (AAU-Net) for the subject-sensitive hashing of remote sensing (RS) images. Our AAU-Net demonstrates obvious asymmetric structure characteristics, which is important to improve the robustness of features by combining the attention mechanism and the characteristics of subject-sensitive hashing. On the basis of AAU-Net, a subject-sensitive hashing algorithm is developed to integrate the features of various bands of RS images. Our experimental results show that our AAU-Net-based subject-sensitive hashing algorithm is more robust than the existing deep learning models such as Attention U-Net and MUM-Net, and its tampering sensitivity remains at the same level as that of Attention U-Net and MUM-Net.

Asymmetric Structure of the Native Rhodobacter sphaeroides Dimeric LH1-RC Complex

The light-harvesting-reaction center (LH1-RC) core complex of purple photosynthetic bacterium Rhodobacter (Rba.) sphaeroides is characterized by the presence of both a dimeric form and a monomeric form. Following structure determination of the monomeric LH1-RC including its previously unrecognized component designated protein-U (Nat. Common.12, 6300, 2021), here we present cryo-EM structures of the dimeric LH1-RC from native Rba. sphaeroides IL106 at 2.75 Å resolution and from an LH1-RC monomer lacking protein-U (ΔU) at 2.64 Å resolution. The native dimeric core complex reveals many asymmetric features in the arrangement of its two monomeric components including the structural integrity of protein-U, the overall LH1 organization, and the rigidities of the proteins and pigments that form the complex. PufX polypeptides play a critical role in connecting two monomers, with one PufX interacting at its N-terminus with another PufX and an LH1 β-polypeptide in another monomer, in good agreement with biochemical analyses. One of the proteins-U was only partially identified in the dimeric structure, signaling significantly different degrees of disorder in the two monomers. The ΔU LH1-RC monomer revealed a half-moon-shaped structure containing 11 α- and 10 β-polypeptides (compared with 14 of each in the wild type), indicating a critical role for protein-U in controlling the number of αβ-subunits required for correct assembly and stabilization of the LH1-RC dimer. The structural features are discussed in relation to the unusual topology of intracytoplasmic photosynthetic membranes and an assembly model proposed for the native Rba. sphaeroides dimeric LH1-RC complex in membranes of wild-type cells.

Effects of interfacial Dzyaloshinskii–Moriya interaction on magnetic dynamics

In the “Beyond Moore” era, the information device is expected to exhibit advantages including small sizes, high processing speed, and low power and dissipation. The novel magnetic information device with these advantages is made of heavy metal(HM)/ferromagnet (FM) composite. Owing to the asymmetric structure, the anisotropic exchange coupling named the interfacial Dzyaloshinskii–Moriya interaction (iDMI) is generated at the HM/FM interface. This iDMI influences the magnetic dynamics including ferromagnetic resonance (FMR), spin wave, and the motion of chiral DWs. These magnetic dynamic behaviors are the bases of the functions of novel magnetic information devices. Therefore, the influence of iDMI on the magnetic dynamics has attracted wide attention in recent years. In this topical review, we give a detailed introduction and discussion about recent investigation on the iDMI-relevant magnetic dynamics of the HM/FM bilayer system. This review consists of five sections: (1). the introduction about the background, the basic theory of magnetic dynamics and DMI; (2). the review about the effect of iDMI on the propagation of spin wave. Owing to the iDMI, the dispersion relationship of spin wave is asymmetric. This not only offers a precise method for measuring the iDMI constant, but also gives rise to potential application for novel magnonic devices. (3). the review about the effect of iDMI on the FMR. Unique iDMI-relevant mode was observed in the FMR spectra owing to the nonparallel alignment of magnetic moments. (4). the review about the motion of DWs with chiral structure due to iDMI. The iDMI plays a fundamental role in the high velocity of the chiral DWs. Meanwhile, the iDMI results in the tilting of DW plane, and the mechanism has been widely investigated. The tilting of the DW plane may be depressed by the interlayer exchange coupling. (5). finally, we summarize the review and give an outlook.