scholarly journals An Exploratory Study of DMIC Water Uses

Author(s):  
Arvind Singh

<div><p><em>Water availability for human consumption and other uses is a priority of any welfare government. Beside human consumption, water availability for industrial use has become a major challenge for the governments vying for rapid industrialization for achieving high growth rate and increasing employment opportunities. Drought prone state like Rajasthan faces an uphill task to manage its drinking water supply in lean years let alone providing enough water for its industries. With two third of DMIC project running through Rajasthan, it throws major challenge before authorities to manage water supply needed by the industries planned under DMIC. </em><em>This paper throws light on the features of DMIC project in Rajasthan. in terms of land acquisition and demarcation by authorities, plans for water supply, management, recycle and reuse of water, tackling infrastructure impediments related to rehabilitation and resettlement and planning for proving a standard urban life to the people coming to work in the DMIC industrial zones. </em><em>With all the emerging trends in Management, Science and Technology, proper water management offers not only multifaceted opportunities but also many challenges to overcome. </em><em> This paper identifies water as one of the biggest </em><em>impediments in successful development of DMIC in Rajasthan. Though authorities have focused much on recycle and reuse of water besides bringing in water from Chambal river, flowing 250 KM away. However, the paper concludes that success of DMIC is going to depend on how authorities manages water need of the industry and people in the area in coming decades and current plans are not only too optimistic but may also result in disastrous failure of DMIC in Rajasthan.</em></p></div>

2009 ◽  
Vol 8 (1) ◽  
pp. 02
Author(s):  
S. O. Lourenço

The search for energy sources that alleviate the dependency on fossil fuels is one the greatest challenges of humankind. The environmental damages that result of many decades of gas emissions from burning oil, natural gas, and mineral coal are evident, revealed by the high levels of atmospheric CO2 and by the ocean acidification, for instance. Two fundamental routes will help to reduce the dependence on fossil fuels: the development of machines and engines with more efficient consumption of fuel and the production of renewable sources of energy, such as biofuels.Brazil is probably the country with the highest potential to produce biofuels. The Brazilian success in the production of ethanol since the 1970’s is a world landmark. The recent growth of biodiesel production in Brazil from different sources (e.g., soybeans, bovine fat) is encouraging. New matrixes to produce biodiesel have been tested all over the world. Microalgae represent a world hope to generate advanced biofuels, allying a (potential) huge scale and very high productivity.In theory, microalgae can triplicate their biomass in 24 hours, depending on the species. This high growth rate combined to high accumulation of triglycerides allow the estimates that some microalgae could generate dozens of thousands of liters of biodiesel / ha per year. Microalgae do not follow seasonal crop harvest regimes (they can be harvested on daily basis), they make biofixation of CO2, occupy small physical areas, and can be cultivated in salty or brackish waters, avoiding the competition with scarce water resources for human consumption of irrigation. Fertile lands are unnecessary, since the cultivation includes ponds or photobioreactors, which are independent of the soil characteristics. There is no conflict with land use for agriculture, deforestation of pristine biomes is avoided, and there is the possibility to generate valuable co-products in parallel to biofuel production.Despite these stimulating arguments, no company produces biofuel from microalgae at commercial scale. Several hurdles still have to be overcome, such as the cost and the efficiency of the separation of the cells from the liquid medium, the accumulation of more triglycerides by the microalgae, the reduction of costs of the systems for mixing the cultivation and dissolution of CO2, and the scarce availability of water in key regions, among others. All technical problems put together and the high intensity of manpower result in high costs of production of biofuels from microalgae. Probably it is not possible yet to produce 1 liter of microalgae biodiesel for less than US$ 9.00, a value that makes the incorporation of microalgae to the world matrix of biofuel to be economically impossible, using the current technology.Due to the Brazilian tradition on biofuels, there is a tremendous international expectation on the participation of Brazil in the production of biofuels from microalgae. Several Brazilian groups have been working on the challenge of creating solutions to make feasible the cultivation of microalgae to generate biofuels. In the previous issue of Engenharia Térmica, two good examples of the Brazilian effort to develop microalgae production can be evaluated by the readers. Ribeiro et al. offered a mathematical analysis of the growth of Phaeodactylum tricornutum, a fast-growing marine microalga, in a closed system for cultivation - a photobioreactor. Torrens et al. evaluated the properties of different kinds of biodiesel generated from microalgae and their theoretical gas emissions in engines, based on the characteristics of their fatty acid composition. These initiatives are important and very welcome. Hopefully, these promising results will stimulate the development of the field in the country, attract more researchers to the subject, and inspire the cooperation amongmultidisciplinary Brazilian teams.


2021 ◽  
Vol 2 (2) ◽  
pp. 178-182
Author(s):  
Zurhayati Zurhayati ◽  
Susi Hartati ◽  
Ifni Wilda

Indonesia is a country with a relatively high growth rate. The essence of the task of the Family Planning (KB) program is to reduce fertility in order to reduce the burden of development for the realization of happiness and prosperity for the people and nation of Indonesia. As a problem There are people who do not know about contraceptives and have not become family planning acceptors. This activity aims to provide knowledge about contraceptives and provide contraceptives for free. This activity aims to provide knowledge about contraceptives and provide contraceptives for free. The method of service is counseling and coaching residents of West Labuh Baru Village. The service was carried out in Labuh Baru Barat Village, Pekanbaru with 98 participants/samples in the activity. This activity is also in collaboration with midwives in the working area of the Payung Sekaki Health Center, Labuh Baru Barat Village. The tools and materials used in the activity are in the form of contraception as a free family planning service and counseling using the lecture method. The results of community service in Labuh Baru Barat Village are willing to become family planning acceptors according to their needs, and will repeat family planning if the family planning period has ended.


2010 ◽  
Vol 59 (1) ◽  
pp. 151-156 ◽  
Author(s):  
H. Klupács ◽  
Á. Tarnawa ◽  
I. Balla ◽  
M. Jolánkai

Water supply of crop plants is the most essential physiological condition influencing quality and quantity performance of grain yield. In a 12-year experimental series of winter wheat agronomic trials run at the Nagygombos experimental site (Hungary) the effect of water availability has been studied. The location represents the typical average lowland conditions of the country, the annual precipitation of the experimental site belonging to the 550–600 mm belt of the Northern edges of the Great Hungarian Plain, while the average depth of groundwater varies between 2 to 3 metres. Crop years with various precipitation patterns have had different impacts on crop yield quality and quantity. Yield figures were in positive correlation with annual precipitation in general. Water availability had diverse influence on quality manifestation. Good water supply has often resulted in poorer grain quality, especially wet gluten and Hagberg values have been affected by that. Drought reduced the amount of yield in general, but contributed to a better quality manifestation in some of the crop years.


2019 ◽  
Vol 118 (8) ◽  
pp. 236-240
Author(s):  
Dr.R. Murugesan ◽  
M. Leelavathi ◽  
Dr. K. Ravindran

towards jumping from the category of developing economy to developed economy there is one big factor that stops and poses a hindrance in its path of advancement and that obstacle is termed as Poverty. The Indian economic policy focuses on a high growth rate along with a equal participation of the poor so that they avail the opportunities available in the market economy. And in order to ensure the participation of the poor it has become important for the country to create a platform where the poor can easily access the various financial products. Microfinance is one such strategy for inclusive growth. Microfinance can change the life of the poor though not completely but a reasonable change can be ensured. In different phases of life women play a crucial role despite the discrimination that is faced by them. But equality can be endowed to women by enhancing the entrepreneurial skills in them. This is possible through Self Help Groups (SHGs). In India women produce around 30% of the total food consumed but she gets only 10% of the property or wealth of the country. Development of women is inevitable for the development and growth of any economy. SHGs happen to be a positive step in this direction. Along with these mediums there should be a cheap and easy source of credit for them and Microfinance fulfills the requirement. This study aims to find the role of this strong medium of Microfinance in the advancement of SHGs in India


2013 ◽  
Vol 740-742 ◽  
pp. 323-326
Author(s):  
Kassem Alassaad ◽  
François Cauwet ◽  
Davy Carole ◽  
Véronique Soulière ◽  
Gabriel Ferro

Abstract. In this paper, conditions for obtaining high growth rate during epitaxial growth of SiC by vapor-liquid-solid mechanism are investigated. The alloys studied were Ge-Si, Al-Si and Al-Ge-Si with various compositions. Temperature was varied between 1100 and 1300°C and the carbon precursor was either propane or methane. The variation of layers thickness was studied at low and high precursor partial pressure. It was found that growth rates obtained with both methane and propane are rather similar at low precursor partial pressures. However, when using Ge based melts, the use of high propane flux leads to the formation of a SiC crust on top of the liquid, which limits the growth by VLS. But when methane is used, even at extremely high flux (up to 100 sccm), no crust could be detected on top of the liquid while the deposit thickness was still rather small (between 1.12 μm and 1.30 μm). When using Al-Si alloys, no crust was also observed under 100 sccm methane but the thickness was as high as 11.5 µm after 30 min growth. It is proposed that the upper limitation of VLS growth rate depends mainly on C solubility of the liquid phase.


Water ◽  
2021 ◽  
Vol 13 (10) ◽  
pp. 1433
Author(s):  
Navneet Kumar ◽  
Asia Khamzina ◽  
Patrick Knöfel ◽  
John P. A. Lamers ◽  
Bernhard Tischbein

Climate change is likely to decrease surface water availability in Central Asia, thereby necessitating land use adaptations in irrigated regions. The introduction of trees to marginally productive croplands with shallow groundwater was suggested for irrigation water-saving and improving the land’s productivity. Considering the possible trade-offs with water availability in large-scale afforestation, our study predicted the impacts on water balance components in the lower reaches of the Amudarya River to facilitate afforestation planning using the Soil and Water Assessment Tool (SWAT). The land-use scenarios used for modeling analysis considered the afforestation of 62% and 100% of marginally productive croplands under average and low irrigation water supply identified from historical land-use maps. The results indicate a dramatic decrease in the examined water balance components in all afforestation scenarios based largely on the reduced irrigation demand of trees compared to the main crops. Specifically, replacing current crops (mostly cotton) with trees on all marginal land (approximately 663 km2) in the study region with an average water availability would save 1037 mln m3 of gross irrigation input within the study region and lower the annual drainage discharge by 504 mln m3. These effects have a considerable potential to support irrigation water management and enhance drainage functions in adapting to future water supply limitations.


2013 ◽  
Vol 687 ◽  
pp. 255-261 ◽  
Author(s):  
Sandra Cunha ◽  
José Barroso Aguiar ◽  
Victor Ferreira ◽  
António Tadeu

Increasingly in a society with a high growth rate and standards of comfort, the need to minimize the currently high energy consumption by taking advantage of renewable energy sources arises. The mortars with incorporation of phase change materials (PCM) have the ability to regulate the temperature inside buildings, contributing for an increase in the level of thermal comfort and reduction of the use of heating, ventilation and air conditioning (HVAC) equipment, using only the energy supplied by the sun. However, the incorporation of PCM in mortars modifies some of its characteristics. Therefore, the main objective of this study was the characterization of mortars doped with two different phase change materials. Specific properties of different PCM, such as particle size, shape and enthalpy were studied, as well as the properties of the fresh and hardened state of these mortars. Nine different compositions were developed which were initially doped with microcapsules of PCM A and subsequently doped with microcapsules of PCM B. It was possible to observe that the incorporation of phase change materials in mortars causes differences in properties such as compressive strength, flexural strength and shrinkage. After the study of the behaviour of these mortars with the incorporation of two different phase change materials, it was possible to select the composition with a better compromise between its aesthetic appearance, physical and mechanical characteristics.


Sign in / Sign up

Export Citation Format

Share Document