OPTIMIZATION OF XYLAN EXTRACTION PROCESS FROM RICE STRAW FOR PRODUCTION OF AUTOHYDROLYSATES RICH IN PREBIOTIC XYLOOLIGOSACCHARIDES

Rice straw, an abundant agricultural waste, possesses immense potential to serve as renewable, eco-friendly and non-edible feedstock to generate value-added products. Therefore, the present study aimed to obtain prebiotic neutral xylooligosaccharides (XOS)-rich autohydrolysate from rice straw xylan. The central composite design of response surface methodology was employed to optimize the conditions for the alkaline extraction of xylan, i.e. NaOH concentration (6-14%, w/v), reaction time (1-3.5 h) and temperature (50-100 °C). Autohydrolysis of xylan was carried out at 121 °C and 15 psi for varied hydrolysis times (10, 25 and 40 min) and sulphuric acid concentrations (0.1, 0.5 and 1.0M) to obtain XOS-rich autohydrolysate. The optimum conditions were found to be as follows: 11.04% (w/v) NaOH, 3.126 h and 80.146 °C, so that the maximum xylan yield of 19.97% was predicted by the software. This value was quite close to the experimental yield of 19.4%, with 80.83% xylan being recovered per gram of rice straw. The best autohydrolysis treatment for xylan was found to be using 0.1M sulphuric acid for 10 min, which allowed 34.5% of 100 mg xylan to be depolymerized to produce neutral XOS (degree of polymerization up to 7), with xylose, xylobiose and xylotriose constituting 4.45, 10.14 and 7.83 mg, respectively. These autohydrolysates promoted higher growth of Lactobacillus rhamnosus and Lactobacillus casei than established prebiotic fructooligosaccharides. The study attempts to solve disposal issues of rice straw through production of XOS-rich autohydrolysates in demand on the global nutraceuticals market.

Aspiration-mediated hydrogel micropatterning using rail-based open microfluidic devices for high-throughput 3D cell culture

Microfluidics offers promising methods for aligning cells in physiologically relevant configurations to recapitulate human organ functionality. Specifically, microstructures within microfluidic devices facilitate 3D cell culture by guiding hydrogel precursors containing cells. Conventional approaches utilize capillary forces of hydrogel precursors to guide fluid flow into desired areas of high wettability. These methods, however, require complicated fabrication processes and subtle loading protocols, thus limiting device throughput and experimental yield. Here, we present a swift and robust hydrogel patterning technique for 3D cell culture, where preloaded hydrogel solution in a microfluidic device is aspirated while only leaving a portion of the solution in desired channels. The device is designed such that differing critical capillary pressure conditions are established over the interfaces of the loaded hydrogel solution, which leads to controlled removal of the solution during aspiration. A proposed theoretical model of capillary pressure conditions provides physical insights to inform generalized design rules for device structures. We demonstrate formation of multiple, discontinuous hollow channels with a single aspiration. Then we test vasculogenic capacity of various cell types using a microfluidic device obtained by our technique to illustrate its capabilities as a viable micro-manufacturing scheme for high-throughput cellular co-culture.

Extraction Optimization of Polysaccharides From Corn Silk and Their Antioxidant Activities in vitro and in vivo

Response surface technique was employed for improving the extraction of corn silk polysaccharides (CSP). Temperature, liquid-to-solid ratio, and per extraction time were all examined as separate factors. The optimal extraction parameters were determined by fitting experimental data to a second-order polynomial; a liquid-to-solid ratio of 21.5 ml/g, temperature equivalent to 88°C, and extraction time of 1.87 h. The experimental yield of the extracted polysaccharides following the application of these conditions was 4.33 ± 0.08% (dry weight), which fit quite well with the predicted value. CSP’s strong scavenging capabilities against hydroxyls, 1,1-diphenyl-2-picrylhydrazyl radicals, and superoxide anions along with its excellent reducing potential, were demonstrated in an in vitro antioxidant experiment. Meanwhile, in vivo testing revealed that CSP substantially enhanced glutathione peroxidase and superoxide dismutase activities. The Malondialdehyde levels in the liver and serum of aged mice also underwent a decrease. This study found that CSP has a substantial antioxidant potential in vitro and in vivo, suggesting that it might be used as an antioxidant in food and medicine.

Well Knowledge of the Physiology of Actinobacillus succinogenes to Improve Succinic Acid Production

The anaerobic fermentation of glucose and fructose was performed by Actinobacillus succinogenes 130Z in batch mode using three different volume of bioreactors (0.25, 1 and 3 L). The strategy used was the addition of MgCO3 and fumaric acid (FA) as mineral carbon and the precursor of succinic acid, respectively, in the culture media. Kinetics and yields of succinic acid (SA) production in the presence of sugars in a relevant synthetic medium were investigated. Work on the bench scale (3 L) showed the best results when compared to the small anaerobic reactor's succinic acid yield and productivity after 96 h of fermentation. For an equal mixture of glucose and fructose used as substrate at 0.4 mol L−1 with the addition of FA as enhancer and under proven optimal conditions (pH 6.8, T = 37 °C, anaerobic condition and 1% v/v of biomass), about 0.5 mol L−1 of SA was obtained, while the theoretical production of succinic acid was 0.74 mol L−1. This concentration corresponded to an experimental yield of 0.88 (mol-C SA/mol-C sugars consumed anaerobically) and a volumetric productivity of 0.48 g-SA L−1 h−1. The succinic acid yield and concentration obtained were significant and in the order of those reported in the literature.

Validation of MATLAB algorithm to implement a two-step parallel pyrolysis model for the prediction of maximum %char yield

Numerical modeling of biomass pyrolysis is becoming a cost and time-saving alternative for experimental investigations, also to predict the yield of the by-products of the entire process. In the present study, a two-step parallel kinetic model was used to predict char yield under isothermal condition. MATLAB ODE45 function codes were employed to solve a set of differential equations that predicts the %char at varying residence times and temperatures. The code shows how the various kinetic parameters and mass of pyrolysis products were determined. Nevertheless, the algorithm used for the prediction was validated with experimental data and results from past works. At 673.15 K, the numerical simulation using ODE45 function gives a char yield of 27.84%. From 573.15 K to 673.15 K, char yield ranges from 31.7 to 33.72% to 27.84% while experimental yield decreases from 44 to 22%. Hence, the error between algorithm prediction and experimental data from literature is − 0.26 and 0.22. Again, comparing the result of the present work with the analytical method from the literature showed a good agreement.

Normalized unitary synaptic signaling of the hippocampus and entorhinal cortex

Limited experimental yield, heterogeneous recordings conditions, and ambiguous neuronal identification have so far prevented the systematic characterization of synaptic signals for all connections of any neural system. Introducing a novel strategy to overcome these challenges, we report the first comprehensive synaptic quantification among all known neuron types of the hippocampal-entorhinal network. First, we reconstructed > 2,600 synaptic traces from ~ 1,200 publications into a unified model of synaptic dynamics. We then trained a deep learning architecture with the resulting parameters, each annotated with detailed metadata. The model learned to predict the synaptic properties of all 3,120 circuit connections in arbitrary conditions with accuracy approaching the intrinsic experimental variability. Analysis of normalized data revealed that synaptic signals are controlled by few latent variables associated with specific molecular markers and interrelating conductance, kinetics, and short-term plasticity. We freely release the tools and full dataset of unitary synaptic values in 32 covariate settings via Hippocampome.org.

The NUMEN Project: An Update of the Facility Toward the Future Experimental Campaigns

The goal of NUMEN project is to access experimentally driven information on Nuclear Matrix Elements (NME) involved in the neutrinoless double beta decay (0νββ) by accurate measurements of the cross sections of heavy-ion induced double charge-exchange reactions. In particular, the (18O, 18Ne) and (20Ne, 20O) reactions are adopted as tools for β+β+ and β−β− decays, respectively. The experiments are performed at INFN–Laboratory Nazionali del Sud (LNS) in Catania using the Superconducting Cyclotron to accelerate the beams and the MAGNEX magnetic spectrometer to detect the reaction products. The measured cross sections are very low, limiting the present exploration to few selected isotopes of interest in the context of typically low-yield experimental runs. In order to make feasible a systematic study of all the candidate nuclei, a major upgrade of the LNS facility is foreseen to increase the experimental yield by more than two orders of magnitude. To this purpose, frontier technologies are being developed for both the accelerator and the detection systems. An update description of the NUMEN project is presented here, focusing on recent achievements from the R&D activity.

Yield gap, profitability and inefficiency of Aman rice in coastal areas of Bangladesh

Despite of being an extremely overpopulated country with a limited land resource, Bangladesh has managed to increase its food production to a viable level. Yet it is necessary to increase production of food crop in order to cope with the growing population in a sustainable way. Closing yield gap is a means of attaining sustainability of agricultural intensification to keep pace with the growing crop demand. The objective of the present study is to assess the inefficiency and the yield gap of Aman rice production in climate vulnerable areas in Bangladesh. The study was conducted in Shaymnagar and Kaliganj Upazilas of Satkhira district in Bangladesh and data were collected using a stratified random sampling technique from 110 Aman cultivating farmers. Descriptive statistical techniques as well as Stochastic Frontier model were used to achieve the objectives of the study. The study revealed that, Aman rice cultivation was profitable in the study area. We estimated the model based yield gap, highest recorded yield gap and experimental yield gap. The mean efficiency analysis revealed that farmers could increase their production with optimal use of inputs and proper management systems. Absence of proper knowledge about the optimum input use and lack of institutional training as well as inadequate extension services were responsible for the reduced yield in most farmers’ fields. Salinity has reduced the overall productivity of the region, but it is believed that by popularizing the practice of saline tolerant rice variety and addressing the above mentioned issues the potential production can be achieved in the coastal region. Progressive Agriculture 30 (4): 395-404, 2019

Optimizing the Extraction of Polysaccharides from Bletilla ochracea Schltr. Using Response Surface Methodology (RSM) and Evaluating their Antioxidant Activity

Bletilla ochracea Schltr. polysaccharides (BOP) have a similar structure to Bletilla striata (Thunb.) Reichb.f. (Orchidaceae) polysaccharides (BSP). Therefore, BOP can be considered as a substitute for BSP in the food, pharmaceuticals and cosmetics fields. To the best of our knowledge, little information is available regarding the optimization of extraction and antioxidant activity of BOP. In this study, response surface methodology (RSM) was firstly used for optimizing the extraction parameters of BOP. The results suggested that the optimal conditions included a temperature of 82 °C, a duration of 85 min and a liquid/material ratio of 30 mL/g. In these conditions, we received 26.45% ± 0.18% as the experimental yield. In addition, BOP exhibited strong concentration-dependent antioxidant abilities in vitro. The half-maximal effective concentration (EC50) values of BOP against 1,1-diphenyl-2-picrylhydrazyl (DPPH·), 2,2′-azino-bis (3-ethylbenzothiazoline-6-sulphonate) (ABTS+·), hydroxyl (·OH) and superoxide anion (·O2−) radicals and ferrous ions (Fe2+) were determined as 692.16, 224.09, 542.22, 600.53 and 515.70 µg/mL, respectively. In conclusion, our results indicate that BOP can be a potential natural antioxidant, deserving further investigation.

Investigation of Anisotropic Subsequent Yield Behavior for 45 Steel by the Distortional Yield Surface Constitutive Model

The subsequent anisotropic yield behavior of 45 steel was predicted by the distortional yield surface constitutive model, which can describe the anisotropic subsequent yield and the cross effect of metal associating with loading history. The yield characteristics and plastic hardening behaviors of the 45 steel were simulated under three preloading paths including pre-torsion, pre-tension, and pre-tension–torsion. Based on the comparison between the experimental yield stresses and the simulation by the classical Chaboche model, the proposed model can describe the remarkable anisotropic yield behavior related to the loading history, which can effectively describe the sharp point of yield surface in pre-loading direction and the smaller curvature near its opposite direction. It was successfully simulated by the constitutive model proposed that the subsequent distortional yield surface defined by small offset strain and the degradation process of the distortion feature defined by large offset strain.