An Assessment of a Low-Cost Wastewater Disposal System after Twenty-Five Years of Operation

1987 ◽  
Vol 19 (5-6) ◽  
pp. 701-710 ◽  
Author(s):  
B. L. Reidy ◽  
G. W. Samson

A low-cost wastewater disposal system was commissioned in 1959 to treat domestic and industrial wastewaters generated in the Latrobe River valley in the province of Gippsland, within the State of Victoria, Australia (Figure 1). The Latrobe Valley is the centre for large-scale generation of electricity and for the production of pulp and paper. In addition other industries have utilized the brown coal resource of the region e.g. gasification process and char production. Consequently, industrial wastewaters have been dominant in the disposal system for the past twenty-five years. The mixed industrial-domestic wastewaters were to be transported some eighty kilometres to be treated and disposed of by irrigation to land. Several important lessons have been learnt during twenty-five years of operating this system. Firstly the composition of the mixed waste stream has varied significantly with the passage of time and the development of the industrial base in the Valley, so that what was appropriate treatment in 1959 is not necessarily acceptable in 1985. Secondly the magnitude of adverse environmental impacts engendered by this low-cost disposal procedure was not imagined when the proposal was implemented. As a consequence, clean-up procedures which could remedy the adverse effects of twenty-five years of impact are likely to be costly. The question then may be asked - when the total costs including rehabilitation are considered, is there really a low-cost solution for environmentally safe disposal of complex wastewater streams?

Molecules ◽  
2020 ◽  
Vol 25 (23) ◽  
pp. 5558
Author(s):  
Dimitra Vernardou ◽  
Charalampos Drosos ◽  
Andreas Kafizas ◽  
Martyn E. Pemble ◽  
Emmanouel Koudoumas

The need for clean and efficient energy storage has become the center of attention due to the eminent global energy crisis and growing ecological concerns. A key component in this effort is the ultra-high performance battery, which will play a major role in the energy industry. To meet the demands in portable electronic devices, electric vehicles, and large-scale energy storage systems, it is necessary to prepare advanced batteries with high safety, fast charge ratios, and discharge capabilities at a low cost. Cathode materials play a significant role in determining the performance of batteries. Among the possible electrode materials is vanadium pentoxide, which will be discussed in this review, due to its low cost and high theoretical capacity. Additionally, aqueous electrolytes, which are environmentally safe, provide an alternative approach compared to organic media for safe, cost-effective, and scalable energy storage. In this review, we will reveal the industrial potential of competitive methods to grow cathodes with excellent stability and enhanced electrochemical performance in aqueous media and lay the foundation for the large-scale production of electrode materials.


Nanomaterials ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 181
Author(s):  
Wai Kian Tan ◽  
Hiroyuki Muto ◽  
Go Kawamura ◽  
Zainovia Lockman ◽  
Atsunori Matsuda

In materials processing, the sol–gel method is one of the techniques that has enabled large-scale production at low cost in the past few decades. The versatility of the method has been proven as the fabrication of various materials ranging from metallic, inorganic, organic, and hybrid has been reported. In this review, a brief introduction of the sol–gel technique is provided and followed by a discussion of the significance of this method for materials processing and development leading to the creation of novel materials through sol–gel derived coatings. The controlled modification of sol–gel derived coatings and their respective applications are also described. Finally, current development and the outlook of the sol–gel method for the design and fabrication of nanomaterials in various fields are described. The emphasis is on the significant potential of the sol–gel method for the development of new, emerging technologies.


2021 ◽  
Author(s):  
Ghaida Salman Muhammed

Flexible photovoltaics are covering the way to low-cost electricity. The build-up of organic, inorganic and organic–inorganic solar cells on flexible substrates by printing technologies is to provide lightweight and economic solar modules that can be incorporated in various surfaces. Progress of flexible and lightweight solar cell is interesting for many terrestrial and space applications that require a very high specific power. Thin-film solar cells on polymer films can produce more than 2KW\\Kg specific power. Flexible solar cells are proposed to open up a numerous of possibilities for enabling new applications in consumer electronics and space satellites. Recent research in thin-film electronics has been concentrated on the replacement of the traditional rigid glass plate substrate with plastic or metallic foils. Organic materials bear the potential to develop a long-term technology that is economically viable for large-scale power generation based on environmentally safe materials with unlimited availability. Organic and organic-inorganic photovoltaics (PVs) (third generation solar cells) continue to attract great attention from the PV community, due to their promising features such as low organic–inorganic cost, flexibility and light weight. In this chapter, many of the possible materials for manufacturing of flexible solar cells are discussed.


2017 ◽  
Vol 26 (50) ◽  
pp. 115
Author(s):  
Marcelo Da Silva Leite ◽  
Celeste Gaia

Over the past decade due the expansion of globalization there has been an increasing emphasis on internationalization among faculty, administration and accrediting agencies in the Higher Education.  Although to promote internationalization in the Higher Education, costs are a big challenge, one way to have the international actions with low cost, it is seeking for grants from different governmental agencies and foundations.The Fulbright Scholar program provides a long-standing and externally-funded means for internationalizing college and university curriculum. This article is going to share the perspective   of a Brazilian Fulbright Scholar at an American college and the institution perspective of the Fulbright scholar participation at the College.


2020 ◽  
Author(s):  
Lungwani Muungo

The purpose of this review is to evaluate progress inmolecular epidemiology over the past 24 years in canceretiology and prevention to draw lessons for futureresearch incorporating the new generation of biomarkers.Molecular epidemiology was introduced inthe study of cancer in the early 1980s, with theexpectation that it would help overcome some majorlimitations of epidemiology and facilitate cancerprevention. The expectation was that biomarkerswould improve exposure assessment, document earlychanges preceding disease, and identify subgroupsin the population with greater susceptibility to cancer,thereby increasing the ability of epidemiologic studiesto identify causes and elucidate mechanisms incarcinogenesis. The first generation of biomarkers hasindeed contributed to our understanding of riskandsusceptibility related largely to genotoxic carcinogens.Consequently, interventions and policy changes havebeen mounted to reduce riskfrom several importantenvironmental carcinogens. Several new and promisingbiomarkers are now becoming available for epidemiologicstudies, thanks to the development of highthroughputtechnologies and theoretical advances inbiology. These include toxicogenomics, alterations ingene methylation and gene expression, proteomics, andmetabonomics, which allow large-scale studies, includingdiscovery-oriented as well as hypothesis-testinginvestigations. However, most of these newer biomarkershave not been adequately validated, and theirrole in the causal paradigm is not clear. There is a needfor their systematic validation using principles andcriteria established over the past several decades inmolecular cancer epidemiology.


2019 ◽  
Vol 19 (1) ◽  
pp. 4-16 ◽  
Author(s):  
Qihui Wu ◽  
Hanzhong Ke ◽  
Dongli Li ◽  
Qi Wang ◽  
Jiansong Fang ◽  
...  

Over the past decades, peptide as a therapeutic candidate has received increasing attention in drug discovery, especially for antimicrobial peptides (AMPs), anticancer peptides (ACPs) and antiinflammatory peptides (AIPs). It is considered that the peptides can regulate various complex diseases which are previously untouchable. In recent years, the critical problem of antimicrobial resistance drives the pharmaceutical industry to look for new therapeutic agents. Compared to organic small drugs, peptide- based therapy exhibits high specificity and minimal toxicity. Thus, peptides are widely recruited in the design and discovery of new potent drugs. Currently, large-scale screening of peptide activity with traditional approaches is costly, time-consuming and labor-intensive. Hence, in silico methods, mainly machine learning approaches, for their accuracy and effectiveness, have been introduced to predict the peptide activity. In this review, we document the recent progress in machine learning-based prediction of peptides which will be of great benefit to the discovery of potential active AMPs, ACPs and AIPs.


Author(s):  
Jeasik Cho

This book provides the qualitative research community with some insight on how to evaluate the quality of qualitative research. This topic has gained little attention during the past few decades. We, qualitative researchers, read journal articles, serve on masters’ and doctoral committees, and also make decisions on whether conference proposals, manuscripts, or large-scale grant proposals should be accepted or rejected. It is assumed that various perspectives or criteria, depending on various paradigms, theories, or fields of discipline, have been used in assessing the quality of qualitative research. Nonetheless, until now, no textbook has been specifically devoted to exploring theories, practices, and reflections associated with the evaluation of qualitative research. This book constructs a typology of evaluating qualitative research, examines actual information from websites and qualitative journal editors, and reflects on some challenges that are currently encountered by the qualitative research community. Many different kinds of journals’ review guidelines and available assessment tools are collected and analyzed. Consequently, core criteria that stand out among these evaluation tools are presented. Readers are invited to join the author to confidently proclaim: “Fortunately, there are commonly agreed, bold standards for evaluating the goodness of qualitative research in the academic research community. These standards are a part of what is generally called ‘scientific research.’ ”


BMC Biology ◽  
2019 ◽  
Vol 17 (1) ◽  
Author(s):  
Amrita Srivathsan ◽  
Emily Hartop ◽  
Jayanthi Puniamoorthy ◽  
Wan Ting Lee ◽  
Sujatha Narayanan Kutty ◽  
...  

Abstract Background More than 80% of all animal species remain unknown to science. Most of these species live in the tropics and belong to animal taxa that combine small body size with high specimen abundance and large species richness. For such clades, using morphology for species discovery is slow because large numbers of specimens must be sorted based on detailed microscopic investigations. Fortunately, species discovery could be greatly accelerated if DNA sequences could be used for sorting specimens to species. Morphological verification of such “molecular operational taxonomic units” (mOTUs) could then be based on dissection of a small subset of specimens. However, this approach requires cost-effective and low-tech DNA barcoding techniques because well-equipped, well-funded molecular laboratories are not readily available in many biodiverse countries. Results We here document how MinION sequencing can be used for large-scale species discovery in a specimen- and species-rich taxon like the hyperdiverse fly family Phoridae (Diptera). We sequenced 7059 specimens collected in a single Malaise trap in Kibale National Park, Uganda, over the short period of 8 weeks. We discovered > 650 species which exceeds the number of phorid species currently described for the entire Afrotropical region. The barcodes were obtained using an improved low-cost MinION pipeline that increased the barcoding capacity sevenfold from 500 to 3500 barcodes per flowcell. This was achieved by adopting 1D sequencing, resequencing weak amplicons on a used flowcell, and improving demultiplexing. Comparison with Illumina data revealed that the MinION barcodes were very accurate (99.99% accuracy, 0.46% Ns) and thus yielded very similar species units (match ratio 0.991). Morphological examination of 100 mOTUs also confirmed good congruence with morphology (93% of mOTUs; > 99% of specimens) and revealed that 90% of the putative species belong to the neglected, megadiverse genus Megaselia. We demonstrate for one Megaselia species how the molecular data can guide the description of a new species (Megaselia sepsioides sp. nov.). Conclusions We document that one field site in Africa can be home to an estimated 1000 species of phorids and speculate that the Afrotropical diversity could exceed 200,000 species. We furthermore conclude that low-cost MinION sequencers are very suitable for reliable, rapid, and large-scale species discovery in hyperdiverse taxa. MinION sequencing could quickly reveal the extent of the unknown diversity and is especially suitable for biodiverse countries with limited access to capital-intensive sequencing facilities.


1943 ◽  
Vol 3 (S1) ◽  
pp. 1-8
Author(s):  
Curtis P. Nettels

One influence of war has repeatedly asserted itself in the past—an effect on the costs of production and on the competitive position of the industries and firms of victorious or neutral nations. This subject needs more study, but certain facts suggest a hypothesis, of three parts. First: war expands some industries or concerns, increases their efficiency, enables them to operate, at the end of the struggle, on a comparatively low-cost basis, intensifies their competitive advantages, and improves their position in relation to foreign competitors. Second: war—for the duration—bolsters up some high-cost units by enabling them to sell at a profit all they can produce. The end of the war places such high-cost units at a disadvantage in the process of absorbing the shocks of the transition to a peacetime economy. Third: the history of postwar periods usually exhibits a sharp contest between such low-cost and high-cost enterprises. While “low cost” and “high cost” may refer to the relative positions of units within the same country, in most of this discussion, the terms will be applied to the producers of one country (either victor or neutral) to mean that their costs are low or high in comparison with those of their foreign competitors.


AJIL Unbound ◽  
2021 ◽  
Vol 115 ◽  
pp. 263-267
Author(s):  
Doron Teichman ◽  
Eyal Zamir

The use of nudges—“low-cost, choice-preserving, behaviorally informed approaches to regulatory problems”—has become quite popular at the national level in the past decade or so. Examples include changing the default concerning employees’ saving for retirement in a bid to encourage such saving; altering the default about consent to posthumous organ donation to increase the supply of organs for transplantation; and informing people about other people's energy consumption to spur them to reduce theirs. Nudges are therefore used to promote the welfare of the people being nudged, and of society at large. However, the use of nudges has sparked a lively normative debate. When turning to the international arena, new arguments for and against nudges can be raised. This essay focuses on the normative aspects of using nudges in the international arena.


Sign in / Sign up

Export Citation Format

Share Document