scholarly journals Effective Removal of Methyl blue and Crystal Violet Dyes Using Improved Polysulfone / ZIF-8 Nanocomposite Ultrafiltration Membrane

2021 ◽  
Vol 12 (6) ◽  
pp. 7942-7956

Zeolitic Imidazole framework 8 (ZIF-8) was successfully prepared in an aqueous medium and then dissolved with concentrations ranging from 0.5% to 5% in polysulfone (PSF) to prepare an ultrafiltration membrane. ZIF-8 nanosized material uniformly distributed in the PSF membrane ultrafiltration membrane was prepared in a polar solvent of N,N'-dimethyl formamide (DMF) by phase inversion procedure. Significantly, ZIF-8 enhanced the membrane flux from 50.42 L/m2.h (PSF) to 83.65 L/m2.h at 100 Kpa, and the rejection of methyl blue and crystal violet dyes up to 95.1% and 89.65 %, respectively compared to the PSF membrane without ZIF-8, 41.08%, 46.32%. Wavelength dispersive X-ray fluorescence (WD-XRF), X-ray Diffraction (XRD), scanning electron microscopy (SEM), contact angle, and dead-end filtration experiment were carried out to characterize the morphology and performance of the prepared ZIF-8 and membranes. The hydrophilicity of the membrane was determined by a contact angle test between water and membrane. SEM was used to study the surface and the cross-sectional morphologies.

2021 ◽  
Vol 13 (4) ◽  
Author(s):  
Nima Hamzian ◽  
Saeed Asadian ◽  
Asiye Golestani ◽  
Hassan Zarghani

Background: Nowadays, ionizing radiation is increasingly used in medicine. One of the most frequent X-ray examinations is pelvic radiography. Gonads are susceptible in the pelvic area. Gonadal shielding (GS) is a useful method to reduce the received dose by gonads. Despite the benefits of using gonadal shielding, it is rarely used by radiographers. Methods: This cross-sectional study was carried out in ten governmental hospitals with 300 radiographs. Results: The radiographers’ knowledge of using GS had a value equal to 59.1%. However, the radiographers did not have enough information on the subject, although their awareness about the significance of GS was acceptable. Conclusions: Although the radiographers believed in the necessity of using GS for pelvic, abdominal, and spine examinations, they used no shields.


2014 ◽  
Vol 70 (2) ◽  
Author(s):  
Nurafiqah Rosman ◽  
Zawati Harun ◽  
Muhammad Zaini Yunos ◽  
Sulaiman Hasan

In the present work, polysulfone (PSf) ultrafiltration membranes were prepared by solution casting via phase inversion process. The effects of synthesized rice husk (RH) zeolite on the properties and performance of the casted PSf membrane were observed and investigated. Characterization of synthesized RH zeolite and morphology of membrane were conducted by using X-ray diffractometer (XRD), field emission microscopy (FESEM) and scanning electron microscopy (SEM). XRD analysis shows a mixture of zeolite A, Y and P, while FESEM images showed agglomeration of cubic-shaped morphology of the synthesized RH zeolite. SEM analysis on membrane morphology indicates that the addition of synthesized RH zeolite obviously changed the microstructure of the membrane sub layer. At 2g RHY content, the membranes held the highest water permeability (315.29 Lm-2h-1) and continuously decreased with higher RHY content. The incorporation of the RHY particles beyond 2% causes declination to the membrane flux and increment to the humic acid rejection from 95.8 to 99.6%.


Author(s):  
Henry I. Smith ◽  
D.C. Flanders

Scanning electron beam lithography has been used for a number of years to write submicrometer linewidth patterns in radiation sensitive films (resist films) on substrates. On semi-infinite substrates, electron backscattering severely limits the exposure latitude and control of cross-sectional profile for patterns having fundamental spatial frequencies below about 4000 Å(l),Recently, STEM'S have been used to write patterns with linewidths below 100 Å. To avoid the detrimental effects of electron backscattering however, the substrates had to be carbon foils about 100 Å thick (2,3). X-ray lithography using the very soft radiation in the range 10 - 50 Å avoids the problem of backscattering and thus permits one to replicate on semi-infinite substrates patterns with linewidths of the order of 1000 Å and less, and in addition provides means for controlling cross-sectional profiles. X-radiation in the range 4-10 Å on the other hand is appropriate for replicating patterns in the linewidth range above about 3000 Å, and thus is most appropriate for microelectronic applications (4 - 6).


Author(s):  
W. Brünger

Reconstructive tomography is a new technique in diagnostic radiology for imaging cross-sectional planes of the human body /1/. A collimated beam of X-rays is scanned through a thin slice of the body and the transmitted intensity is recorded by a detector giving a linear shadow graph or projection (see fig. 1). Many of these projections at different angles are used to reconstruct the body-layer, usually with the aid of a computer. The picture element size of present tomographic scanners is approximately 1.1 mm2.Micro tomography can be realized using the very fine X-ray source generated by the focused electron beam of a scanning electron microscope (see fig. 2). The translation of the X-ray source is done by a line scan of the electron beam on a polished target surface /2/. Projections at different angles are produced by rotating the object.During the registration of a single scan the electron beam is deflected in one direction only, while both deflections are operating in the display tube.


2016 ◽  
Vol 5 (2) ◽  
pp. 150-156
Author(s):  
Laili Rahmatul Ilmi

Background: Workload may indirectly cause stress. The ability to manage work stress may affect staff’s motivation and performance. The staff performance will affect decision-making in improving the service quality. Objective: This study aimed to analyze the relationship between stress management, work motivation and work performance. Method: This was an analytic observational study with a cross sectional approach. A sample of 19 medical record staff, working at Prof. Dr. R Soeharso orthopedic hospital Surakarta, were selected for this study. A set of questionnaires were developed and administered to measure stress management, work motivation and work performance. Data were then analyzed with a bivariate correlation analysis. Results: There were statistically significant correlations between work stress management, work motivation and work performance. The ability to manage stress positively increased the motivation (r= 0,56; p= 0,013), as well as the work performance (r= 0,49; p= 0,036). Moreover, a higher motivation will lead to a higher performance (r= 0,42; p= 0,071). Conclusion: There were positive relationships between work stress management, work motivation and work performance. Key words: work stress management, motivation, performance.


2011 ◽  
pp. 137-144
Author(s):  
Thi Ngoc Ha Hoang ◽  
Anh Vu Nguyen ◽  
Minh Loi Hoang ◽  
Cuu Long Nguyen ◽  
Thi Thuy Hang Nguyen

Purposes: Describe the morphological and diastolic function of left ventricular changes in the patients with dilated cardiomyopathy (DCM) on US, X-ray findings, and Evaluate the correlation between morphology and diastolic function of left ventricular. Materials and method: Cross sectional study from Dec 2009 to Aug 2010, on 39 patients with dilated cardiomyopathy were evaluated at the University Hospital of Hue College of Medical and Pharmaceutical. Results: 1. X-ray and US findings characteristics of DCM is significantly increased in diameter of L, H and mG; LVM, LVMI, LVDd and LAD. 2. The pression of pulmonary artery has been significantly increased with redistribution pulmonary arteries in 61.5% cases and 23.1% have reversed pulmonary artery distribution. 3. DCM have diastolic dysfunction in 100% patients, including severe disorders to 61.5%; the restrictive dysfunction has ratio E/A>2 and E/Em average was 23.89± 17.23. 4.The correlation between the morphology and function in DCM: the diameter of H and L on the X-ray, LAD and ratio LA/AO on US correlated with the level of diastolic dysfunction (p< 0.05). All three radiographic parameters on the radio standard (H, L, the index Cardio/Thoracic) and LVDd on US have negative correlated with EF and FS with p <0.05. Key words: dilated cardiomyopathy, diastolic dysfunction, cardiac tissue Doppler, reversed pulmonary artery distribution


2015 ◽  
pp. 50-58
Author(s):  
Thi Dung Nguyen ◽  
Tam Vo

Background: The patients on hemodialysis have a significantly decreased quality of life. One of many problems which reduce the quality of life and increase the mortality in these patients is osteoporosis and osteoporosis associated fractures. Objectives: To assess the bone density of those on hemodialysis by dual energy X ray absorptiometry and to examine the risk factors of bone density reduction in these patients. Patients and Method: This is a cross-sectional study, including 93 patients on chronic hemodialysis at the department of Hemodialysis at Cho Ray Hospital. Results: Mean bone densities at the region of interest (ROI) neck, trochanter, Ward triangle, intertrochanter and total neck are 0.603 ± 0.105; 0.583 ± 0.121; 0.811 ± 0.166; 0.489 ± 0.146; 0.723 ± 0.138 g/cm2 respectively. The prevalences of osteoporosis at those ROI are 39.8%, 15.1%; 28%; 38.7%; and 26.9% respectively. The prevalences of osteopenia at those ROI are 54.8%; 46.3%; 60.2%; 45.2% and 62.7% respectively. The prevalence of osteopososis in at least one ROI is 52.7% and the prevalence of osteopenia in at least one ROI is 47.3%. There are relations between the bone density at the neck and the gender of the patient and the albuminemia. Bone density at the trochanter is influenced by gender, albuminemia, calcemia and phosphoremia. Bone density at the intertrochanter is affected by the gender. Bone density at the Ward triangle is influenced by age and albuminemia. Total neck bone density is influenced by gender, albuminemia and phosphoremia. Conclusion: Osteoporosis in patients on chronic hemodialysis is an issue that requires our attention. There are many interventionable risk factors of bone density decrease in these patients. Key words: Osteoporosis, DEXA, chronic renal failure, chronic hemodialysis


2020 ◽  
Vol 9 (3) ◽  
pp. 207-211
Author(s):  
Sidra Sarwar ◽  
Sara Khalid ◽  
Tahir Mahmood ◽  
Hadeeqa Jabeen ◽  
Shahid Imran

Background: Musculoskeletal disorders are not only becoming prevalent among health care professionals in our country but are affecting their health and performance adversely. They are caused by poor ergonomics and awkward posture during work activities. The purpose of this study was to determine the frequency of neck and upper limb musculoskeletal disorders in dentists of Lahore, Pakistan. Material and Methods: This cross-sectional study was conducted during October 2017 to March 2018. The data was collected using convenient sampling technique from 162 Dentists including 52 males and 110 females of Children hospital Lahore, Punjab Dental hospital and Fatima Memorial Hospital, Lahore. Data was collected by using Mangalore Questionnaire for identification of musculoskeletal disorders. Descriptive analysis of the data was done using SPSS version 22.0. Results: Of 162 dentists, 115 (71%) suffered from musculoskeletal disorders. Shoulder was the most commonly affected region (30.9%) followed by neck (25.9%), arm (6.2%), wrist (4.3%), elbow (3.1%) and forearm (0.6%). Pain (45.7%) was found to be the most common complaint followed by muscle weakness (20.4%), paraesthesia (3.7%) and swelling (1.2%). Conclusions: It was concluded that majority of the dentists were suffering from musculoskeletal disorders with shoulder as the most affected region and pain as the most frequent complaint. Key words: Dentists, Musculoskeletal disorders, Neck pain, Upper extremity


2018 ◽  
Vol 69 (10) ◽  
pp. 2754-2758
Author(s):  
Lucretiu Radu ◽  
Mara Carsote ◽  
Ancuta Augustina Gheorghisan Galateanu ◽  
Smaranda Adelina Preda ◽  
Veronica Calborean ◽  
...  

Circulating parathyrin (PTH or parthormon) is increased in primary hyperparathyroidism (PHP) in association with high total/ionic calcium (T/I Ca) and others mineral metabolism anomalies. This is a clinical cross-sectional and case-control study analyzing these changes after PHP surgical correction in menopausal women. Baseline parameters were: mean age at diagnosis (59.63�9.6 years), TCa of 10.9�0.7 mg/dL, PTH of 138.02�59.36 pg/mL. Longitudinal data showed: final TCa p[0.00001, ICa p[0.00001, phosphorus p[0.0001, magnesium p=0.9, 24-h urinary calcium p=0.4, 25-hydroxycholecalciferol p=0.01, PTH p[0.00001. High circulating parathyrin values due to PHP normalized after surgery in addition to statistical significant changes of TCa, ICa, P, lumbar Bone Mineral Density provided by Dual-Energy X-Ray Absorptiometry; Mg and 24-h Ca might not be a marker of general mineral metabolism improvement.


Sign in / Sign up

Export Citation Format

Share Document