scholarly journals VSWR value measurement analysis using Direct Digital Synthesizer

JAICT ◽  
2018 ◽  
Vol 3 (1) ◽  
Author(s):  
Lorenza Louis Natalia

<p class="AbstractL-MAG"><span lang="EN-US">SWR Analyzer is an electronic device radio is useful to know the value of VSWR and antenna impedance without the use of radio tranciever. In this final use Direct Digital Synthesizer (DDS) to generatewaveforms analog digitally. DDS signal generation programmable via Arduino nano. The frequency used is aantenna operating frequency dipole 7 MHz which are in the range 6.9 MHz - 7.4 MHz.calibration SWR Analyzer is done by providing a form of pure resistor load with the acquisition of a data error of 4% as compared with the theory. The test results niali VSWR atantenna dipole 7 MHzusing an SWR Analyzer then compared with measuring devices in general, ie VSWR SWR meter. Earned value matching 1: 1 obtained by SWR Analyzer at a frequency of 6.9 MHz, while using the SWR meter lowest VSWR values obtained at 7:04 MHz frequency with a value ofratio matching impedance1:35: 1. The accuracy of the measurement results using the SWR Analyzer when compared with SWR meter reaches a value 83%.</span></p>

2018 ◽  
Vol 3 (2) ◽  
pp. 79
Author(s):  
Arif Nuryono

Performance measurement in manufacturing industry is usually measured with the approach of OEE (Overall Equipment Effectiveness). In the mining industry, backhoe excavator performance can also be measured by OEE value approach. OEE value measurement performed on the excavator in coal mine Embalut Kaltim. In the case study on the company, the performance analysis also compared with the backhoe excavator defined performance targets of the company. OEE Value mine done OEE parameter modification into 3 dimensions: availability, utilization and productivity index. OEE measurement mine OB Removal devoted to the activity, as this activity has a value greater than most activity cost Getting Coal. The measurement results OEE values for the existing conditions is very low. Two of six units which have a low OEE value. The low value of OEE most influential is the utilization value. If compared with OEE value targets, there are five units of backhoe has a value below the target. Efforts are being made to improve OEE values is by the application of TPM: implementing autonomous maintenance, implementation of SMED: change the internal activity into external and doing jobs that could be eliminated or Parallelize and application 5W1H: make your creative ideas by way of brainstorming or explore the idea of problem solving, After implementation of the improvement idea, the value of simulation obtained quite good, an increase compared with OEE value before improvement. Keyword : Availability, Utilization, Productivity Index, TPM, SMED, 5W1H.


2021 ◽  
Vol 328 ◽  
pp. 07005
Author(s):  
Hariyanto Hariyanto ◽  
Muhammad Rusdi ◽  
Daniel Parenden ◽  
Cipto Cipto ◽  
Klemens A. Rahangmetan

Dye-Sensitized Solar Cell is a type of solar cell that is being developed by researchers around the world. The purpose of this research is to analyse the performance measurement of DSSC using Arduino Nano. The DSSC used as the sample is the result of fabrication with the pipette method and red fruit colouring material. The data measurement method is carried out in real-time using Arduino nano devices and sensors that have been assembled. The measurement results are presented in the form of graphs and tables, while the parameters measured include intensity, current, and voltage. While power is the current and voltage values, efficiency is the ratio between the input and output values. The value of the test results shows the maximum voltage value is 0.020 V, the current is 1.800 A, power is 0.036 W/m2, and efficiency is 0.007%.


Energies ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3187
Author(s):  
Keon-Woo Park ◽  
Chul-Hwan Kim

In this study, we describe the development of a plug-in type of switchgear that can control bidirectional power flow. This switchgear system can connect distributed generations such as photovoltaic and wind turbine generation, and AC and DC loads. The proposed switchgear system consists of an inverter for connecting distributed generations and DC load, a static transfer switch (STS) that can control and interrupt the bidirectional power flow, and an intelligent electronic device (IED) that can control each facility using a communication system. Since the topology inside the switchgear is composed of DC bus, it can be operated as a plug-in type of system that can be used by simply connecting the converters of various distributed generations to the inverter in the developed switchgear system. In this study, we describe the overall structure of the proposed switchgear system and the operation of the components. In addition, prototypes of each facility are developed and the results of building a small testbed are presented. Finally, we verify the operation of the inverter by performing an experiment on the testbed and show that throughout a test sequence the proposed switchgear system works normally. The contributions of this study are the development of a plug-in type of switchgear for AC/DC and the actual test results presented through prototype development and testbed configuration.


1998 ◽  
Vol 14 (04) ◽  
pp. 265-276
Author(s):  
Ivo Senjanovic

This review paper covers extensive investigations which were undertaken in order to verify the idea of launching of ships and other floating structures from a horizontal berth by a set of turning pads. This includes structural dynamics during launching, model tests and strength analysis of the structure and the launching system. The most important results, which were used for the design of the launching system, are presented. The preparation of a barge for side launching is described, and the full-scale measurement results are compared with the test results. The advantages of building ships and offshore structures on a horizontal berth are pointed out in the conclusion.


2018 ◽  
Vol 164 ◽  
pp. 01017 ◽  
Author(s):  
Jalinas ◽  
Wahyu Kusuma Raharja ◽  
Bobby Putra Emas Wijaya

The heart is one of the most important organs in the human body. One way to know heart health is to measure the number of heart beats per minute and body temperature also shows health, many heart rate and body temperature devices but can only be accessed offline. This research aims to design a heart rate detector and human body temperature that the measurement results can be accessed via web pages anywhere and anytime. This device can be used by many users by entering different ID numbers. The design consists of input blocks: pulse sensor, DS18B20 sensor and 3x4 keypad button. Process blocks: Arduino Mega 2560 Microcontroller, Ethernet Shield, router and USB modem. And output block: 16x2 LCD and mobile phone or PC to access web page. Based on the test results, this tool successfully measures the heart rate with an average error percentage of 2.702 % when compared with the oxymeter tool. On the measurement of body temperature get the result of the average error percentage of 2.18 %.


Media Wisata ◽  
2021 ◽  
Vol 16 (1) ◽  
Author(s):  
Sri Larasati

The purpose of this research is to know wtether knowledge, skill, responsiveness and communication skill influence in job competition for graduate student from Sekolah Tinggi Pariwisata AMPTA. The population in this study are student pf Sekolah Tinggi Pariwisata SMPTA that graduated in 2013 until 2016, the total population in this studt is 702 and 200 respondents who have worked taken as samples, samples were taken with non probability sampling technique and accidental sampling approach. Sampling approach using regression equations obtained results that through test results F (regression analysis jointly) may note that the value of F = 147.104 count with the significance of 0.000 < 0.05. The test results of the test F reinforced with testing the determination of the coefficient that shows the value of 74.6%) (0.746. From Test t (partially) can result in variable knowledge with a value of t = 3,173 and significance of the value 0002 < 0.05, variable skill with a value of t = 2,949 and value the significance of 0.004 < 0.05, variable attitude with a value of t = 2,688 and value the significance of 0.008 < 0.05, variable communication skill with a value of t = value and significance of 4,497 0000 < 0.05. From the above results can be known that the hypothesis posed was not proven in other words that all of these variables can be said to have a positive and significant effect simultaneously as well as partial toward the ability of STP graduates AMPTA in the face of competition in the world of work


2021 ◽  
Vol 2 (6) ◽  
pp. 2143-2154
Author(s):  
Bambang Suwarno

The purpose of this study was to analyse the extent of Consumer-Based Brand Equity, Quality Product and Price affects customer loyalty at PT. Panasonic Gobel Indonesia Branch Medan and to compare the theories. The author examined by collecting data using a variety of library research, questionnaires are structured as an instrument to obtain quantitative data with Likert-scale systems are distributed to 68 respondents. Data was then compiled then processed and analysed using multiple regression analysis techniques (multiple regression) through the test of validity, test of reliability and test of classic assumptions. By using the tools of Statistical Product Service Solutions program (SPSS version 22.0). From the survey results revealed that the influential Consumer-Based Brand Equity, Product Quality and Price simultaneously with the results Fhitung 18,457 > Ftabel 2,75 and probability sig. 0,000 < 0,05 then reject ho (accept hi) that the Consumer-Based Brand Equity, Product Quality, Price simultaneously significantly influence Customer Loyalty PT. Panasonic Gobel Indonesia Branch Medan. The Consumer-Based Brand Equity there is for the partial influence on the Customer Loyalty with a value of thitung 3,980 > ttabel 1,997 and sig. 0,000 < 0,05, the Product Quality there is for the partial influence on the Customer Loyalty with a value of thitung 3,874 > ttabel 1,997 and sig. 0,000 < 0,05 and the Price there is for the partial influence on the Customer Loyalty with a value of thitung 2,483 > ttabel 1,997 and sig. 0,002 < 0,05. From the test results are also obtained by the value of determination R square is 0,564 or 56,4%. It is claimed that Consumer-Based Brand Equity, Product Quality and Price is an excellent way to improve Customer Loyalty and also the hypothesis that the authors proposed previously received.


2020 ◽  
Vol 5 (2) ◽  
pp. 138-145
Author(s):  
Ely Kurniati ◽  
Rusnawati

Preeclampsia complicates 4-7% of pregnancies and remains the leading cause of maternal and fetal morbidity and mortality worldwide. Despite improvements in health care over the last decade, preeclampsia remains the second most common cause of maternal mortality in Indonesia. This study aims to determine whether the mean arterial pressure (MAP) is related to the incidence of preeclampsia in pregnant women at the Bontobangun Puskesmas, Bulukumba district for the period 2018 to 2019. This research uses a descriptive-analytic approach with Historical Cohort Studies, namely by looking at the cohort book of the history of blood pressure measurement results for pregnant women at the Bontobangun Public Health Center, Bulukumba Regency for the period 2018 to 2019. Determining the sample using the sampling method taken by purposive sampling. 31 samples of pregnant women who experienced preeclampsia and 31 controls were pregnant women with normal conditions who had certain criteria (matching) with the sample. The results explained that from the paired T-test results, the value of α> 0.037 so that it is said that there is a relationship between mean artery pressure (MAP) and the incidence of preeclampsia in pregnant women at Bontobangun puskesmas for the period 2018-2019.


2020 ◽  
Vol 11 (1) ◽  
pp. 110-119
Author(s):  
Julianto Julianto ◽  
Izma Daud ◽  
Sari Milyati

Abstrak  Latar Belakang :Access block adalah situasi dimana pasien yang mengalami lama rawat di IGD 6 karena kurangnya akses ke ruang rawat inap dan kepadatan jumlah pasien yang tidak terkendali, dampaknya ditemukan bahwa semakin lama access block  semakin tinggi pula perburukan pasien dalam 24 jam.Tujuan : ini bertujuan untuk mengetahui hubungan access block dengan perburukan kondisi pasien di Instalasi Gawat Darurat RSUD Ulin Banjarmasin.Metode :Penelitian menggunakan desain analitik dengan pendekatan cross sectional. Jumlah sampel yang diambil berjumlah 40 orang dengan teknik pengambilan accidental sampling. Analisis data melalui uji spearman rank.Hasil : Hasil uji dipapatkan nilai p hitung 0,000 (0,05) ada hubungan antara access block dengan perburukan kondisi pasien di instalasi gawat darurat RSUD Ulin Banjarmasi.Simpulan: Berdasarka hasil penelitian Ada hubungan antara access block dengan perburukan kondisi pasien di Instalasi Gawat Darurat RSUD Ulin Banjarmasin dengan nilai P= 0,000 nilai α = 0,05 dengan nilai koefisien korelasi 0,588 Kata kunci: Access Block, Perburukan Pasien. Abstract Background :Access block is a situation where patients who experience length of stay in the ED 6 due to lack of access to the inpatient room and uncontrolled density of patients, it is found that the longer the access block the higher the deterioration of patients in 24 hours.Purpose: This study aims to determine the relationship of access block with deteriorating condition of patients in Emergency Installation Ulin Hospital Banjarmasin.Method : The research method uses an analytical design with a cross sectional approach. The number of samples taken is 40 people using the accidental sampling technique. Data analysis through spearman rank test.Result: The test results obtained p value calculated 0,000 (0.05) there is a relationship between the access block and deterioration of the patient's condition at the Ulin Banjarmasin Hospital emergency department.Conclusion: Based on the results of the study, there is a relationship between the access block and the worsening of the patient's condition at the Emergency Department of RSUD Ulin Banjarmasin with a value of P = 0.000 value α = 0.05 with a correlation coefficient value of 0.588. Keywords: Access Block, Patient worsening 


Sign in / Sign up

Export Citation Format

Share Document