scholarly journals Design and Characterization of the Next Generation Nanowire Amplifiers

VLSI Design ◽  
2008 ◽  
Vol 2008 ◽  
pp. 1-5
Author(s):  
Sotoudeh Hamedi-Hagh ◽  
Ahmet Bindal
Keyword(s):  
High Speed ◽  
Field Effect Transistors ◽  
Channel Length ◽  
Next Generation ◽  
Short Channel ◽  
Surrounding Gate ◽  
Channel Effects ◽  
Gate Control ◽  
Voltage Swing

Vertical nanowire surrounding gate field effect transistors (SGFETs) provide full gate control over the channel to eliminate short-channel effects. This paper presents design and characterization of a differential pair amplifier using NMOS and PMOS SGFETs with a 10 nm channel length and a 2 nm channel radius. The amplifier dissipates 5 μW power and provides 5 THz bandwidth with a voltage gain of 16, a linear output voltage swing of 0.5 V, and a distortion better than 3% from a 1.8 V power supply and a 20 aF capacitive load. The 2nd- and 3rd-order harmonic distortions of the amplifier are −40 dBm and −52 dBm, respectively, and the 3rd-order intermodulation is −24 dBm for a two-tone input signal with 10 mV amplitude and 10 GHz frequency spacing. All these parameters indicate that vertical nanowire surrounding gate transistors are promising candidates for the next generation high-speed analog and VLSI technologies.

Projected Performance of Sub-10 nm GaN-based Double Gate MOSFETs

2017 ◽  
Vol 2 (2) ◽  
pp. 15-19 ◽  
Author(s):  
Md. Saud Al Faisal ◽  
Md. Rokib Hasan ◽  
Marwan Hossain ◽  
Mohammad Saiful Islam
Keyword(s):  
High Speed ◽  
Field Effect Transistors ◽  
Cmos Technology ◽  
Channel Length ◽  
Capacitive Coupling ◽  
Oxide Semiconductor ◽  
Double Gate ◽  
Short Channel ◽  
Channel Effects ◽  
Silvaco Atlas

GaN-based double gate metal-oxide semiconductor field-effect transistors (DG-MOSFETs) in sub-10 nm regime have been designed for the next generation logic applications. To rigorously evaluate the device performance, non-equilibrium Green’s function formalism are performed using SILVACO ATLAS. The device is turn on at gate voltage, VGS =1 V while it is going to off at VGS = 0 V. The ON-state and OFF-state drain currents are found as 12 mA/μm and ~10-8 A/μm, respectively at the drain voltage, VDS = 0.75 V. The sub-threshold slope (SS) and drain induced barrier lowering (DIBL) are ~69 mV/decade and ~43 mV/V, which are very compatible with the CMOS technology. To improve the figure of merits of the proposed device, source to gate (S-G) and gate to drain (G-D) distances are varied which is mentioned as underlap. The lengths are maintained equal for both sides of the gate. The SS and DIBL are decreased with increasing the underlap length (LUN). Though the source to drain resistance is increased for enhancing the channel length, the underlap architectures exhibit better performance due to reduced capacitive coupling between the contacts (S-G and G-D) which minimize the short channel effects. Therefore, the proposed GaN-based DG-MOSFETs as one of the excellent promising candidates to substitute currently used MOSFETs for future high speed applications.

scholarly journals Analysis of Low Dimensional Nanoscaled Inversion-Mode InGaAs MOSFETs for Next-Generation Electrical and Photonic Applications

2015 ◽  
Vol 2015 ◽  
pp. 1-6
Author(s):  
C. H. Yu ◽  
X. Y. Chen ◽  
X. D. Luo ◽  
W. W. Xu ◽  
P. S. Liu
Keyword(s):  
Leakage Current ◽  
Drain Current ◽  
Gate Oxide ◽  
Channel Length ◽  
Next Generation ◽  
Short Channel ◽  
Channel Effects ◽  
Operating Limits ◽  
Low Dimensional ◽  
Interface Passivation

The electrical characteristics of In0.53Ga0.47As MOSFET grown with Si interface passivation layer (IPL) and highkgate oxide HfO2layer have been investigated in detail. The influences of Si IPL thickness, gate oxide HfO2thickness, the doping depth, and concentration of source and drain layer on output and transfer characteristics of the MOSFET at fixed gate or drain voltages have been individually simulated and analyzed. The determination of the above parameters is suggested based on their effect on maximum drain current, leakage current, saturated voltage, and so forth. It is found that the channel length decreases with the increase of the maximum drain current and leakage current simultaneously. Short channel effects start to appear when the channel length is less than 0.9 μm and experience sudden sharp increases which make device performance degrade and reach their operating limits when the channel length is further lessened down to 0.5 μm. The results demonstrate the usefulness of short channel simulations for designs and optimization of next-generation electrical and photonic devices.

scholarly journals Implementation of 20 nm Graphene Channel Field Effect Transistors Using Silvaco TCAD Tool to Improve Short Channel Effects over Conventional MOSFETs

2021 ◽  
Vol 7 (1) ◽  
pp. 18-29
Author(s):  
Vinod Pralhad Tayade ◽  
Swapnil Laxman Lahudkar
Keyword(s):  
Low Power ◽  
Field Effect ◽  
High Speed ◽  
Field Effect Transistors ◽  
Oxide Semiconductor ◽  
Short Channel Effects ◽  
Short Channel ◽  
Channel Effects ◽  
20 Nm ◽  
Graphene Material

In recent years, demands for high speed and low power circuits have been raised. As conventional metal oxide semiconductor field effect transistors (MOSFETs) are unable to satisfy the demands due to short channel effects, the purpose of the study is to design an alternative of MOSFETs. Graphene FETs are one of the alternatives of MOSFETs due to the excellent properties of graphene material. In this work, a user-defined graphene material is defined, and a graphene channel FET is implemented using the Silvaco technology computer-aided design (TCAD) tool at 100 nm and scaled to 20 nm channel length. A silicon channel MOSFET is also implemented to compare the performance. The results show the improvement in subthreshold slope (SS) = 114 mV/dec, ION/IOFF ratio = 14379, and drain induced barrier lowering (DIBL) = 123 mV/V. It is concluded that graphene FETs are suitable candidates for low power applications.

SLD-MOSCNT: A new MOSCNT with step–linear doping profile in the source and drain regions

2017 ◽  
Vol 31 (01) ◽  
pp. 1650242 ◽  
Author(s):  
Behrooz Abdi Tahne ◽  
Ali Naderi
Keyword(s):  
Power Consumption ◽  
High Speed ◽  
Cutoff Frequency ◽  
Basic Structure ◽  
Channel Length ◽  
Doping Profile ◽  
Horizontal Distance ◽  
Short Channel ◽  
Channel Effects ◽  
Channel Lengths

In this paper, a new structure, step–linear doping MOSCNT (SLD-MOSCNT), is proposed to improve the performance of basic MOSCNTs. The basic structure suffers from band to band tunneling (BTBT). We show that using SLD profile for source and drain regions increases the horizontal distance between valence and conduction bands at gate to source/drain junction which reduces BTBT probability. SLD performance is compared with other similar structures which have recently been proposed to reduce BTBT such as MOSCNT with lightly-doped drain and source (LDDS), and with double-light doping in source and drain regions (DLD). The obtained results using a nonequilibrium Green’s function (NEGF) method show that the SLD-MOSCNT has the lowest leakage current, power consumption and delay time, and the highest current ratio and voltage gain. The ambipolar conduction in the proposed structure is very low and can be neglected. In addition, these structures can improve short-channel effects. Also, the investigation of cutoff frequency of the different structures shows that the SLD has the highest cutoff frequency. Device performance has been investigated for gate length from 8 to 20 nm which demonstrates all discussions regarding the superiority of the proposed structure are also valid for different channel lengths. This improvement is more significant especially for channel length less than 12 nm. Therefore, the SLD can be considered as a candidate to be used in the applications with high speed and low power consumption.

Short-channel and high-mobility p- and n-type organic single-crystal transistors with air-gap structures

2012 ◽  
Vol 1402 ◽  
Author(s):  
M. Uno ◽  
T. Uemura ◽  
K. Miwa ◽  
A. Facchetti ◽  
J. Takeya
Keyword(s):  
Single Crystal ◽  
High Speed ◽  
Carrier Mobility ◽  
Field Effect Transistors ◽  
High Mobility ◽  
Channel Length ◽  
Air Gap ◽  
Short Channel ◽  
Glass Substrates ◽  
Channel Lengths

ABSTRACTIn an effort to realize high-speed organic logic components, p- and n-type single-crystal organic field-effect transistors (SC-OFETs) were fabricated using air-gap structures with channel lengths as short as several μm. High carrier mobility of about 10 cm2/Vs is demonstrated in rubrene SC-OFETs even with the short channel length of 6 μm, using Si-based microstructures. The contact resistance is estimated to be 450 Ohm cm, which is only 5% of the total channel resistance between source and drain electrodes. Performances of n-type air-gap devices based on PDIF-CN2 are also demonstrated exhibiting electron transport with the carrier mobility of about 2 cm2/Vs. Furthermore, micron-scale air-gap structures are fabricated using insulating materials on glass substrates to reduce parasitic gate capacitance. The cut-off frequency of this rubrene air-gap device is measured to be as high as 8 MHz with applied drain voltage VD of 15 V. These techniques are promising to be applicable to next-generation organic high-speed logic circuits.

scholarly journals Design and software characterization of finFET based full adders

2019 ◽  
Vol 8 (1) ◽  
pp. 51
Author(s):  
Raju Hajare ◽  
C. Lakshminarayana
Keyword(s):  
Field Effect Transistors ◽  
Full Adder ◽  
Oxide Semiconductor ◽  
Short Channel Effects ◽  
Short Channel ◽  
Switching Speed ◽  
Chip Area ◽  
Channel Effects ◽  
Technology Nodes

Adder is the most important arithmetic block that are used in all processors. Most of the logical circuits till today were designed using Metal Oxide Semiconductor Field Effect Transistors (MOSFET’s). In order to reduce chip area, leakage power and to increase switching speed, MOSFET’s were continuously scaled down. Further scaling below 45nm, MOSFET’s suffers from Short Channel Effects (SCE’s) which leads to degraded performance of the device. Here the Performance of 28T and 16T MOSFET based 1-bit full adder cell is characterized and compared with FinFET based 28T and 16T 1-bit full adders at various  technology nodes using HSPICE software. Results show that FinFET based full adder design gives better performance in terms of speed, power and reliability compared to MOSFET based full adder designs. Hence FinFET are promising candidates and better replacement for MOSFET.

scholarly journals Revisiting Analytical Models of N-Type Symmetric Double-Gate MOSFETs Shaded Conditions

2020 ◽  
Vol 24 (1) ◽  
Author(s):  
Rekib Uddin Ahmed ◽  
Prabir Saha
Keyword(s):  
Integrated Circuits ◽  
Field Effect Transistors ◽  
Drain Current ◽  
Cmos Technology ◽  
Channel Length ◽  
Oxide Semiconductor ◽  
Analytical Models ◽  
Double Gate ◽  
Short Channel ◽  
Channel Effects

Nowadays, the endlessly increasing demand for faster and complex integrated circuits (IC) has been fuelled by the scaling of metal-oxide-semiconductor field-effect-transistors (MOSFET) to smaller dimensions. The continued scaling of MOSFETs approaches its physical limits due to short-channel effects (SCE). Double-gate (DG) MOSFET is one of the promising alternatives as it offers better immunity towards SCEs and can be scaled to the shortest channel length. In future, ICs can be designed using DG-CMOS technology for which mathematical models depicting the electrical characteristics of the DG MOSFETs are foremost needed. In this paper, a review on n-type symmetric DG MOSFETs models has been presented based on the analyses of electrostatic potential distribution, threshold voltage, and drain-current models. Mathematical derivations of the device models are described elaborately, and numerical simulations are also carried out to validate the replicability of models.

Sign in / Sign up

Export Citation Format

Share Document